http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
급성 골수성 백혈병(M6)에 합병된 중추성 요붕증 1 예
김성연,조보연,이홍규,고창순,민헌기,김병국,김노경,신찬수,이명식,강덕현,조종태 대한내과학회 1989 대한내과학회지 Vol.37 No.2
Leukemia is known to be an extremely rare cause of diabetes insipidus. We report a case of diabetes insipidus as a complication of leukemia. An 18 year-old man was admitted because of polyuria polydipsia and fever. Bone marrow aspiration and biopsy revealed the diagnosis of acute erythroleukemia (AML, M6). On the water deprivation test, the diabetes insipidus was confirmed to be of the central type. He was managed with intranasal vasopressin for diabetes insipidus with good response. Induction chemotherapy was administered without response, and the patient died of septicemia and respiratory failure 2 months after initial diagnosis. A short review of the literature related to this subject is also presented.
방전 플라스마에 의한 CFC-12(CCl2F2)의 분해
황명환,우인성,조정국,강현춘,안형환,이한섭,강안수 한국산업안전학회 1999 한국안전학회지 Vol.14 No.3
Decomposition efficiency, power consumption, and applied voltage of CFC(Chlorofluorocarbon) were investigated by SPCY(surface induced discharge plasma chemical processing) reactor to obtain optimum process variables and maximum decomposition efficiencies. Decomposition efficiency of CFC-12 with various electric frequencies(5∼50㎑). flow rates (100∼1,000mL/min), initial concentrations(100∼1,000ppm), electrode materials(W, Cu. Al), electrode thickness(1, 2, 3mm) and reference gases(N₂, O₂, air) were measured and the products were analyzed with FT-IR. Experimental results showed that at the frequency of 10kHz, the highest decomposition efficiency of 92.7% for CFC-12 were observed at the power consumptions of 29.6W, respectively, and that decomposition efficiency decreased with increasing frequency above 20㎑ and decomposition efficiency per unit power were 3.13%/W for CFC-12. Decomposition efficiency was increased with increasing residence times and with decreasing initial concentration of pollutants. Decomposition efficiency was increased with increasing thickness of discharge electrode and the highest decomposition efficiency was obtained for the electrode diameter of 3mm. As the electrode material, decomposition efficiency was in order that tungsten(W), copper(Cu), aluminum (Al).
한국에서의 Human T-Cell Leukemia Virus Type-1(HTLV-1)에 대한 혈청학적 및 역학에 관한 연구
이영열,이성열,김은실,이홍복,김병국,이문호,박선양,김노경,서철원,규경채,최강원,조한익,고월청,야마구찌이찌세이 대한내과학회 1986 대한내과학회지 Vol.31 No.2
Type-C retrovirus, human T-cell leukemia virus type-l(HTLV-1), has been shown to be associated etiologically with adult T-cell leukemia, which is an endemic disease in southwestern parts of Japan. We examined the seroepidemiological characteristics of antibody to adult T-cell leukemia virus associated antigen (anti-ATLA-antibody) by the indirect immunofluorescent assay and ELISA from the healthy individuals and various diseased patients in the Republic of Korea, a country adjacent to Japan in which HTLV-1 is endemic. The results were as follows. 24 out of 9,603 individuals(0.25%) were seropiositive. The positve rate was 0.17% in males and 0.36% in females, the sex difference was female predominent relatively. HTLV-1 carriers were found 16 individuals in Seoul, 5 in Kyonggi area, 1 in Chungnam and Jonbuk, respectively, but found only 1 individual in Busan city and Jaejoo area close to southwestern parts of Japan. Positive rate to anti-ATLA-antibody seemed to be high in older age, especially at the 50s(0. 4Yo). In conclusion the prevalence rate of anti-ATLA- antibody seemed to be very low in the Republic of Korea adjacent to Japan in which HTLV-1 is endemic and no patient with adult T-cell leukemia has been found as yet. Also we noted that the Republic of Korea is not an endemic area to HTLV-1.
두께가 일정하지 않은 재료에서 경사진 균열의 성장거동에 관한 연구
조명래,표창률,박종구,고명훈 한국산업안전학회 1997 한국안전학회지 Vol.12 No.4
The effect of geometry factors on the combined mode stress intensity factor behaviors of a slant crack in a non-uniform thickness material was analysed by 2-dimensional theoretical analysis. The analysis is based on the Laurent's series expansions of complex potentials where the complex coefficients of the series are determined from the compatibility and the equilibrium conditions of the thickness interface. and the stress free conditions of the crack surface. In numerical calculations the perturbation technique is employed. The expressions for the crack tip stress intensity factor are given in the form of power series of dimensionless crack length λ, and the function of crack slant angle α and thickness ratio β . The results of numerical calculations for each problems are represented as the correction factors F(λ, α, β). The results clearly show the following characteristics : The correction factors of the combined mode stress intensity factors for a non-uniform thickness material can be defined in the form of F(λ, α, β). The stress intensity factor values for a given crack length are decreased with increase of thickness ratio β.
무가압 침투법에 의해 제조된 Al/BN 복합재료의 미세조직과 인장성질
조수연,이건배,심호섭,허성우,유황룡,권훈 대한금속재료학회(대한금속학회) 2000 대한금속·재료학회지 Vol.38 No.12
Spontaneous infiltration and strengthening behaviors were analyzed in terms of microstructures and tensile properties of Al/BN composite fabricated by pressureless infiltration technique, compared with control alloy without BN fabricated by the same method. The Mg₃N₂ formed by the reaction of Mg vapor and nitrogen gas, which coated the particles in the powder bed, is believed to induce spontaneous infiltration through a great enhancement of wetting via the following reaction, Mg₃N₂+ 2Al→2AlN + 3Mg. This was identified by the finding of AlN particle layers on the surfaces of old Al particles in the powder bed, which contacted with the infiltrating melt. In addition, unreacted Mg₃N₂ was observed outside the composite, where the Al melt directly did not come into contact. Fine AlN particles formed in-situ resulted in a significant strengthening even in the control alloy with no addition of BN. In the composite reinforced with BN, additional AlN was formed by the interfacial reaction of the BN and Al melt as well as AlN by the in-situ reaction. Consequently, both the BN particles and the additional AlN particles formed by the interfacial reaction led to a further strengthening in the composite, as compared to control alloy strengthened by the AlN particles formed in-situ.
차동 플로팅매스형 전자 트랜스듀서를 이용한 이식형 인공중이의 실험적 평가
송병섭,김명남,조진호,정주영,김동만,이건일 경북대학교 전자기술연구소 2001 電子技術硏究誌 Vol.22 No.2
Recently, implantable middle ear hearing system have attracted hearing impaired person's attention because it can overcome the disadvantages of conventional hearing aids such as sound distortion, sound feedback and howling effect. In this study, implantable middle ear hearing system, using DFMT(differential floating mass type) transducer that has two magnets glued with the same pole facing was evaluated by performing several experiments. The results of vibration experiments using DFMT transducer showed several advantages such as high vibration efficiency, good frequency response, minimal influencing by external magnetic flux, etc. And the results of the ABR(auditory brainstem response) test using guinea pig proved the performance of transducer in the animal's body and the possibility of clinical application of the implantable middle ear system for mild to severe hearing loss patients.
초내열합금 Mar-M 247 LC 에서 열처리에 의한 미세조직의 변화와 크리프특성과의 관계
김일호,최병학,강수현,조종춘,허보영,김학매 대한금속재료학회(대한금속학회) 1999 대한금속·재료학회지 Vol.37 No.3
Creep-rupture properties of a cast type Superalloy, Mar-M247LC. were studied in 760℃ and 980℃. The shape and size of γ′ particles in grains were known to have significant influence on the creep behavior and rupture life in relation to the micro-mechanism of plastic deformation. It was found that the creep properties were also affected by the cast structure which is composed of dendrite matrix and eutectic boundaries. The hardening effect of boundaries by solute segregation and eutectic phases may improve the creep resistance of grain or eutectic boundaries during creep-rupture.
한국산 날치과(Beloniformes , Exocoetidae)어류 5 종의 분류학적 재검토
김종만,김진구,유정화,조선형,명정구,강충배,김용억 한국어류학회 2001 韓國魚類學會誌 Vol.13 No.2
Taxonomic review of the five flyingfishes, Parexocoetus mento (Valenciennes), Cheilopogon agoo (Temminck et Schlegel), Cheilopogon heterurus doederleini (Steindachner), Cheilopogon cyanopterus (Valenciennes), Hirundichthys oxycephalus (Bleeker) were carried out based on samples collected from the South sea and around sea of Jeju Island of Korea from 1996 to 1998. Parexocoetus mento (Valenciennes) and Cheilopogon cyanopterus (Valenciennes) were revealed as the unrecorded species in Korea, which were named as "Men-to-hwang-nal-chi" and "Ki-geom-nal-chi" respectively. Parexocoetus mento is differed from P. barchypterus in having no chin barbels in juveniles, and Cheilopogon cyanopterus is distinguished from C. agoo in the branched form of pectoral fin rays and from C. heterurus doederleini in the numbers of the dorsal fin ray and the color of pectoral fins.