위암 환자의 복강내 투여를 위한 Activated Charcoal-Alginate Bead 제형으로부터 Mitomycin C의 용출 거동

이진호,최선웅,서중기,김동민,정경수,오정연,김진향,노승무,민병무,김용백,김창식,박근성,강대영,송규상,양준묵,조준식,정현용,김학용,인현빈 충남대학교 의과대학 지역사회의학연구소 1998 충남의대잡지 Vol.25 No.1

Locoregional recurrence is the most common type of recurrence in surgical operation of gastric adenocarcinoma, and peritoneal dissemination is one of the most difficult problems in advanced gastric adenocarcinoma treatment. Because the peritoneal cavity is the most common site of the first recurrence after gastric cancer resection, intraperitoneal chemotherapy seems a logical choice for cancer chemotherapy. In this study, Mitomycin C (MMC)-activated charcoal (CH)-alginate (ALG) beads were prepared by the mixtures of CH particles adsorbed with MMC as an anti-cancer drug and aqueous alginate solution. The alginate is recognized as biodegradable, nontoxic, and biocompatible. The release of MMC from the beads in 0.1 M Tris buffer was stable and continuous until about 1 week. The MMC-CH-ALG beads can be applied in the peritoneal cavity for intraperitoneal chemotherapy since they provide a good adhesiveness on the tissue and controlled release pattern of the drugs.

위암환자의 복강내에 투여한 Mitomycin C-Carbon Particle의 Mitomycin 용출에 관한 연구

노승무,조영훈,정경수,오정연,김진향,양준묵,강대영,송규상,조준식,최선웅,이진호,민병무,김용백,김창식,박근성,인현빈,정현용,김학용 충남대학교 의과대학 지역사회의학연구소 1998 충남의대잡지 Vol.25 No.1

Locoregional recurrence is the most common type of recurrence in surgical operation of gastric adenocarcinoma, and peritoneal dissemination is one of the most difficult problems in advanced gastric adenocarcinoma treatment. Because the peritoneal cavity is the most common site of the first recurrence after gastric cancer resection, intraperitoneal chemotherpy seems a logical choice for cancer chemotherapy. The Mitomycin C(MMC) adsorbed by the activated charcoal particles(CH) is relatively released when the drug concentration surrounding the carbon particles becomes low in the peritoneum of the peritoneal cavity. For the intraperitoneal chemotherapy on the advanced gastric adenocarcnoma, mitomycin C adsorbed on activated carbon particles was administered in the peritoneal cavity just before abdominal wall closure. The closed drainage tubes were inserted in the peritoneal cavity and clamped for tuo hours after completion of operation. MMC concentrations were serially measured in peritoneal fluid, plasma and urine at 2hour, 48 hour, 72 hour and 168 hour following its administration in order to study the efficacy of the MMC-CH as a drug delivery system. There were minimal toxicities in born marrow, liver, and gastrointestinal system after intraperitoneal MMC-CH administration. The data of this study suggested that MMC-CH may have a somewhat more beneficial effect than surgery alone when administered in optimal dose and schedules, but the MMC concentration of the peritoneal fluid was not sufficient to eradicate remnant cancer cells, and effective duration of maintenance was only below 24 hours in the peritoneal fluid and plasma.

다기능 5축 복합가공기 구조 최적설계 및 동강성 평가

정용민,장성현,황현영,최영휴,하종식 한국공작기계학회 2008 한국공작기계학회 추계학술대회논문집 Vol.2008 No.-

This paper describes a structural design. optimization for light weight and minimum compliance using G.A. and a study on dynamic stiffness evaluation of a 5-axes multi-tasking machine tool. Dynamic stiffness is one of important factors regarding to machine tool accuracy. In design optimization, we optimized the thickness of structural member which minimize the compliance and weight of the machine structure under several constraints. Furthermore, dynamic stiffness, in this study, were obtained by using both FEM analysis and an experimental dynamic stiffness test, that is a random excitation test by using a hydraulic exciter. Both the theoretical and experiment analysis results showed good agreement with each other. Finally, some discussion and review from the view point absolute dynamic stiffness were made based on the analysis results.

블라인드 시공간 적응 배열 안테나

정대훈,장은영,노현민,변건식 東亞大學校附設 情報技術硏究所 2005 情報技術硏究所論文誌 Vol.13 No.1

In Mobile communication systems, it require a high speed transmission. But the performance of systems is bad according to a selective fading channel. Therefore we must estimate a channel environment. In this paper, we esimated a direction of arrival of the coming wave. Currently there is MUSIC algorithm in DOA estimation. But this technique is difficult to estimate DOA in real time because of time. This paper proposed a new method called Blind adaptive array Antenna. As a result, we verified the performance of system is superior in various channel condition using simulation.

하시모토 갑상선염을 동반한 갑상선 이형성증 1예

정현주,김예나,최영식,박요한 고신대학교 의과대학 2009 고신대학교 의과대학 학술지 Vol.24 No.1

Thyroid hemiagenesis is a rare congenital anomaly, in which one thyroid lobe fails to develop. It is reported that thyroid hemiagenesis associated with thyroid diseases such as Graves' disease, Hashimoto's thyroiditis, colloidal goiter and thyroid follicular and papillary cancer. However, Thyroid hemiagenesis associated Hashimoto's thyroiditis haven't reported in Korea. A 31-year-old female patient was clinically hypothyroid with a left-sided goiter. Hemiagenesis of right thyroid lobe indicated on 99mTc pertechnete scan and later confirmed on ultrasonography. The authors report this case with literature review.

3-Cyano 및 3-Carbomethoxy Chromone과 Allenylstannane과의 반응

鄭大一,宋有淨,崔舜圭,李龍均,安賢淑,윤구식 東亞大學校附設基礎科學硏究所 1998 基礎科學硏究論文集 Vol.15 No.2

t-Butyldimethylsilyl triflate 존재에서 3-Cyano 및 3-Carbomethoxy Chromone(1a,b)과 Allenylstannane(2) 과의 반응에서 Chromone의 C-2위치에 propargyl기가 도입된 유도체(3a,b)를 합성하였다. 합성한 유도체의 상대적 구조는 ¹H-NMR을 통해 분석하였으며, T.S구조의 모델을 통하여 가능한 메카니즘을 제시하였다. Reaction of 3-Cyano and 3-Carbomethoxy Chromone(1a,b) with Allenylstannane(2) in the presence of tert-butyldimethylsilyl triflate afforded the corresponding the propargylation product(3a,b) in the moderate yield. The relative stereochemistry of 3a,b are obtained on the basis of ¹H-NMR analysis. And the possible reaction mechanism are suggested by the molecular models in the transition state.

박막 크로멜-알루멜 열전퇴형 교류-직류 변환기

정인식,김호운,김진섭,이정희,이종현,신장규,박세일,권성원 경북대학교 센서기술연구소 1998 센서技術學術大會論文集 Vol.9 No.1

A planar chromel-alumel multijunction ac-dc converter was fabricated on a LPCVD Si_(3)N_(4)/SiO_(2)/Si_(3)N_(4)-diaphragm, prepared by silicon bulk micromachining, which thermally isolated a bifilar evanohm-heater and the hot junctions of a chromel-alumel thermopile from the silicon substrate. The voltage responsivity, the ac-dc transfer error, and the fluctuation of the output thermoelectric voltage of the converter were investigated. The respective voltage responsivities in air and in a vacuum of the converter were about 3.16 mV/mW and 9.41 mV/mW. The ac-dc voltage and the current transfer errors in air were about ±1.5 ppm and ±0.7 ppm in a frequency range from 10 Hz to 10 kHz, respectively. The fluctuation of the output thermoelectric voltage from 5 seconds to 120 seconds after preheating in air for 5 seconds was about 0.06 % for a heater input of dc 1 V.

廢棄物埋立地 浸出水에서 黃酸鹽還元菌의 分布와 重金屬 不溶化役割

정권,신재영,정일현,고견택일유,유영식 한국환경위생학회 1997 한국환경보건학회지 Vol.23 No.3

This study, collaborated Gifu University. Japan, was performed to analyze chemical pollutants and microorganism and to clarify the distribution of sulfate-reducing bacteria and their insolubilization of heavy metal ions in leachates sampled seasonally between 1994 and 1996 from Nanjido waste landfill site, sampled 4 times between 1995 and 1996 from Pusan and Daejeon waste landfill site. and sampled 1 time between 1992 and 1994 from Hokkaido. Nagoya, Osaka and Hukuoka waste landfill site in Japan. The results were as follows: 1. The temperatures of internal leachate and leachate effluent were 40℃ and 30℃, respectively, and the pH values of both leachates were about 8.0 at Nanjido waste landfill site. The concentration of SO_(4)^(-2)gradually increased with the degree of stabilization and that of NO_(3)-N was detected in a part of sampling sites at one and half years, and in all sampling sites at 3 years after completion of landfill. 2. The organic substances in leachate of Nanjido waste landfill site decreased with the degree of stabilization and they were very fluctuated with measuring point and time. The concentration of organic substance and heavy metals in internal leachate were higher than in leachate effluent and those of Cd, Hg. and Pb were lower than detection limit except a part of samples in 1996. 3. APCs in internal leachate and leachate effluent were not much different and the minimum of APCs in internal leachate and leachate effluent were 1.0 x 10^(4)/ml and 4.0 x 10^(1)ml. respectively. 4. The maximums of SRBs in Nanjido, Pusan, and Daejeon waste landfill site were 9180 MPN/ml, 24000 MPN/ml, and 348 MPN/ml, respectively and the maximum of SRBs in Japan waste landfill site was 9300 MPN/ml. 5. During 2-week-SRB culture, the values of MPN were high at 50℃ for initial culture period and at 30℃ for last culture period. MPN started to appear at first day and rapidly increased between 7th day and 9th day. 6. Cadmium and copper were insolubilized by SRB within 6 hr and iron and zinc were done within 48 hr. The rates of insolubilization of Cd. Cu. Fe. Zn, T-Cr were 100%. 99.5%. 95.0%. 99.8%. 16.1% after 48 hr treatment with SRB. respectively.

안면부에 발생한 비색소성 흑색종 2례

한예식,김보현,이정윤,안희창 大韓成形外科學會 1993 Archives of Plastic Surgery Vol.20 No.1

Amelanotic melanoma is extremely rare and more aggressive than similarly staged pigmented lesion. It has been estimated that 2 percent of all melanoma is clinically amelanotic. The authors recently experienced 2 cases of amelanotic melanomas. An amelanotic melanoma of the left lower eyelid was widely excised, and reconstructed with the nasal mucochondral graft and Mustard cheek flap. Until 33month after the operation, no metastatic lesion was found and well being state. An amelanotic melanoma on the right buccal mucosa, in the other patients was widely excised and reconstructed with bilobed forearm flap. 10month later lung metastasis was noted.

품질기능 및 비용 전개를 위한 소프트웨어 Tool 개발

김정식,장현수,이병기 명지대학교 대학원 1997 대학원논문집 Vol.1 No.-

QFD is a method for supporting product planning and development processes. This method enables to specify clearly the customer's needs and then evaluate the product capability in terms of its impact on meeting those needs, The QFD process involves constructing the HoQ matrix which consists of the customer requirements, the engineering characteristics to meet those requirements, and the evaluation factors in the planning matrix. The QFD often produces different results according to each evaluation factor in the matrix. Therefore, am integrating technique is required to solve the problem. This paper provides the technique which integrates the QFD analysis results due to different evaluation factors. The technique also considers the production cost as an evaluation factor to help produce an economical solution. Finally, a software tool for supporting the comprehensive QFD process is developed and implemented using the Visual Basic of Microsoft Excel.