http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
배은현,고광진,장현구 成均館大學校 科學技術硏究所 1989 論文集 Vol.40 No.2
The effects of reduction ratio and purity on the superplasticity of Pb-62%Sn eutectic alloys were studied. The alloys of two values of reduction ratio(r=10 : 1, 25 : 1) and impurity content(alloy A : 0.075%, alloy B : 0.216%) were prepared to compare the flow stress and elongation at constant strain rate. Also, the effect of temperature on the tensile behavior and the structural changes of the surfaces were investigated. Larger elongations were achieved for more worked(r=25 : 1) alloys because of their finer equiaxed grains, and for more purified alloy A in which less impurities inhibit the grain boundary sliding. Maximum elongation of 2300% was obtained for alloy A at room temperature, r = 25 : 1 and strain rate, ε˙= 1.4 x 10 exp(-4)/s. Increase in temperature, caused increase in strain rate sensitivity and decrease in flow stress, which explains that atomic accommodation process and grain boundary migration arc more enhanced at elevated temperature.
누적처리기법을 이용한 능동표적식별 시스템의 실시간 구현
박규태,배은현,이균경,Park, Gyu-Tae,Bae, Eun-Hyon,Lee, Kyun-Kyung 한국음향학회 2007 韓國音響學會誌 Vol.26 No.2
LFM 신호를 이용한 능동소나 신호처리에서는 Split-beam을 이용한 좌우 두 빔 사이의 상호상관관계를 측정함으로써 표적의 자세각과 길이 정보를 추정할 수 있다. 그러나 탐지된 원거리 표적의 정보를 추정하기 위해서는 고분해능의 방위각 및 거리 해상도가 요구된다. 이를 위해 나이키스트(Nyquist) 샘플링 주파수보다 높은 샘플링 주파수가 필요하므로, 일반적으로 보간기법을 이용하여 과도샘플링(over-sampling) 을 해야 한다. 하지만 과도 샘플링된 좌우 빔신호를 이용하여 상호상관관계를 구할 경우, 요구되는 연산량과 메모리 용량이 일반적으로 상용 DSP 프로세서들의 처리용량과 내부 메모리 용량을 초과하게 되어 DSP를 이용한 실시간 구현이 어렵게 된다. 본 논문에서는 이러한 문제를 해결하기 위해 누적처리기법을 이용한 Split-beam처리 방법을 제안하였다. 제안한 기법의 성능을 모의실험을 통하여 검증하고, ADSP-TS101을 사용하여 실시간 시스템으로 구현하였다. In active sonar system, aspect angle and length of a target can be estimated by calculating the cross-correlation between left and right split-beams of a LFM(Linear Frequency Modulated) signal. However, high-resolution performances in bearing and range are required to estimate the information of a remote target. Because a certain higher sampling frequency than the Nyquist sampling frequency is required in this performance, an over-sampling process through interpolation method should be required. However, real-time implementation of split-beam processing with over-sampled split-beam outputs on a COTS(commercial off-the-shelf) DSP platform limits its performance because of given throughput and memory capacity. This paper proposes a cumulative processing algorithm for split-beam processing to solve the problems. The performance of the proposed method was verified through some simulation tests. Also, the proposed method was implemented as a real-time system using an ADSP-TS101.
저주파 대역에서 좌/우 구분이 가능한 지향성배열센서 구조 및 신호처리 기법
김대경,배은현,전상태,김태환,Kim, Dae-Kyung,Bae, Eun-Hyon,Jeon, Sang-Tae,Kim, Tae-Hwan 한국음향학회 2018 韓國音響學會誌 Vol.37 No.4
본 논문은 기존 선배열센서에서 발생하는 좌/우 구분 모호성을 해결하기 위해 저주파 대역에서 좌/우 구분이 가능한 지향성배열센서 구조 및 신호처리 방안을 제안한다. 지향성배열센서는 기존 음향배열센서에 지향성을 가지는 DIFAR(Directional Frequency Analysis and Recording)배열센서를 추가 확장한 선배열센서 구조이며, 음향배열센서의 빔형성 결과와 DIFAR배열센서의 빔형성 결과를 융합/처리하는 신호처리 구조를 가진다. 이러한 지향성배열센서는 좌/우 구분이 가능한 기존의 이중 선배열센서와 비교하여 낮은 신호 대 잡음비 및 저주파수 대역에서 높은 좌/우 구분 성능을 나타낸다. A new directional linear array structure and its signal processing method are presented to resolve the left/right ambiguity inherent in a linear array. The array structure combines an ordinary acoustic sensor array with a DIFAR (Directional Frequency Analysis and Recording) sensor array, keeping a linear array configuration and gaining a instantaneous left/right discrimination. It presents better PSRR (Port-Starboard Rejection Ratio) in low frequency band and low SNR (Signal to Noise Ratio) situation as compared with a conventional twin linear array, and good compromise to easily upgrade an existing linear array system to a new one with a left/right discrimination capability.
광대역 chirp 신호의 방위각 추정을 위한 적응 빔 형성
김정수,최병웅,배은현,이균경,Kim, Jeong-Soo,Choi, Byung-Woong,Bae, Eun-Hyon,Lee, Kyun-Kyung 한국음향학회 2008 韓國音響學會誌 Vol.27 No.2
In this paper, the adaptive chirp beamforming method is proposed to solve the bias problem in the direction-of-arrivals (DOAs) estimation of the wideband chirp signals which have an identical time-frequency parameter and are emanated from different directions. The source location bias results from the interferences impinging on the array from the other directions. The proposed method exploits the time-frequency structure of the chirp signal based on STMV (STeered Minimum Valiance) to improve the DOA estimation performance by minimizing the chirp interferences effectively. Simulation results show the DOA estimation performance achieved by the proposed method as compared to the conventional methods. 본 논문은 동일한 주파수 파라미터를 가지고 다른 방위에서 입사하는 chirp신호의 방위각 (DOA : Direction-of-arrival) 추정에서 상호 간섭으로 인한 bias문제를 해결하기 위하여 적응 chirp 빔형성기법을 제안한다. 제안한 기법은 기존의 STMV (STeered Minimum Variance)기법에 chirp 신호의 시간-주파수 특성을 고려함으로써 chirp신호들의 상호 간섭을 보다 효과적으로 감소시켜 방위각 추정성능을 향상시킨다. 모의 실험에서 제안한 기법과 기존의 기법들에 의한 방위각 추정성능을 비교한다.