http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
수학자 이상설이 소개한 근대자연과학: <식물학(植物學)>
박영민 ( Young Min Park ),김채식 ( Chae Sik Kim ),이상구 ( Sang Gu Lee ),이재화 ( Jae Hwa Lee ) 한국수학교육학회 2011 수학교육논문집 Vol.25 No.2
본 원고는 2004년 과학사학자 박성래 교수가 독립 운동가이자 한국 근대 수학교육의 아버지로 부르기 시작한 보재 이상설(李相卨, 1870-1917)이 자연과학에 기여한 내용을 다루고 있다. 한국수학사학회지 2009년 11월 호에 자세히 소개된 〈數理〉를 쓴 시기를 전후하여, 같은 시기에 이상설이 붓으로 쓴 것으로 여겨지는 〈植物學>(이상설, 1899)은 총 4면의 초록 필사본이며, 그 대본(臺本)은 〈植物學啓蒙〉 (Edkins, 1886)으로 영국의 Joseph Edkins(艾約瑟, 1823-1905)가 번역하여 1886년에 간행한 〈西學啓蒙〉 16종 가운데 하나이다. 이상설의 〈植物學>은 이 〈植物學啓蒙〉을 읽으면서 그 책의 내용 중 당시의 조 선 학자가 모르고 있던 새로운 내용을 중심으로 메모를 한 것으로 여겨진다. 본 연구에서는 전통산학과 근대서양수학을 연결하는 〈數理〉를 저술했으며. 우리나라의 정규 교과과정에 수학과 과학을 필수과목으로 지정하고, 첫 번째 수학교과서 〈산術新書〉를 발간함으로 당대 최고의 수학자로 평가된 이상설이 쓴 〈植物學〉을 발굴하여 그 내용과 의미를 최초로 분석한다, 이를 통하여 당시 조선의 서양 과학, 특히 식물학에 대한 이해 수준을 분석하고 〈植物學〉의 원전인 〈植物學啓蒙〉 과 <西學啓蒙〉의 저자에 대하여 알아본다. 이는 당시 수학교육자가 자연과학분야에 행한 교육적 기여를 이해 하는데 필수적인 연구이다. This paper deals with contents that Sang-Seol Lee contributed to the natural science in the 19th century Korea. Prof. Sung-Rae Park, the science historian, called Sang-Seol Lee Father of the Modern Mathematics education of Korea. Sang-Seol Lee wrote a manuscript Botany with a brush in late 19th century. Botany was transcribed from Science Primers: Botany (written by J. D. Hooker), which is translated into Chinese by Joseph Edkins in 1886. The existence of Sang-Seol Lee`s book Botany was not known to Korean scientists before. In this paper, we study the contents of Botany and its original text. Also we analyze people`s level of understanding Western sciences, especially botany at that time. In addition, we study authors of 16 Primers for Western Knowledge. We study the contribution of mathematician Sang-Seol Lee to science education in the 19th century Korea.
성재현 대한치과교정학회 1996 대한치과교정학회지 Vol.26 No.2
저자는 성장기 Ⅲ급 부정교합자의 치료 후 성장완료시까지 장기관찰 기록을 통하여 Ⅲ급 부정교합치료 전략 수립에 도움이 되는 유용한 정보를 얻었다. 장기 관찰 결과는 다음과 같이 요약할 수 있다. 첫째, 전치부 반대교합의 조기 개선시에 상악에서 상당한 전방성장이 많은 증례에서 관찰되었다. 둘째, 악골에 대한 정형적 치료에 의한 성장조절은 장기적인 관점에서 제한적인 효과만 인정되었다. 셋째, 반대교합을 가진 어린 환자에서 얻은 어떤 자료도 장기적인 관점에서 그 환자의 치료후 안정성을 예측활 수 있는 것은 없었다. 그러나 gonial angle은 어느 정도 예측의 가능성을 보였다. 넷째, 성장이 된 연령에서 하악에 대한 정형적 후방력이나 하악의 급작스런 위치 변화는 약관절에 좋지 못한 영향을 줄 수 있었다. 따라서 저자는 다음과 같이 Ⅲ급 치료 전략을 제시한다. ·반대교합은 가능하다면 조기에 개선하는 것이 좋으며, 전형적 치료는 10세 이전에 1-2년 정도 사용하는 것이 좋겠다. ·이후에 바로 phaseⅡ 치료에 들어가지 말고 성장이 어느 정도 끝나는 시점까지 기다린다. 즉 여자는 14세, 남자는 17세 경까지 기다린 후에 교정치료로 마무리할 것인지 악교정 수술을 할 것인지 결정한다. 관찰기간 동안에 성장에 영향을 줄 수 있는 기도문제, 혀자세, 습관, 제3대구치의 발율 등을 감독하고, 성자에 관한 자료를 채득한다. 이렇게 하므로서 앞에서 관찰한 치료 완료 후의 재발로 인한 재치료 문제를 줄일 수 있고, 실제적인 치료기간을 단축할 수 있어 환자나 술자에게 모두 유익하다고 생각한다. The author obtained some useful useful information for the classⅢ treatment from long term observation on the growing patients with class Ⅲ malocclusion. 8 patients were selected for this study and presentation. From these observation so far my conclusions might be as follows; First, in the early correction of the anterior crossbite, considerable forward growth changes were observed in the maxilla. Second, as for the growth modification of jaws by orthopedic treatment, only limited effects were recognized from the long-term observation Thrid, at early age of patients with anterior crossbite, any data couldn't make me predict the stability after treatment on the long-term basis. Fortunately, however,gonial angle showed a marginal possibility of it prediction. Forth, at an advanced age/retraction orthopedic force on the mandible and the rapid change in the mandibular position may cause some trouble in the T.M.joint. Finally, the followings are recommendable. As for the anterior crossbite, correct it early as possible, and use orthopedic force under the age of ten. Do not enter the phase Ⅱtreatment directly. Just wait and observe until the growth were almost completed, focusiong on some important factors such as airway problem, tongue position, and third molar development. Of course, these factors may have some effects on the mandibular growth. for the female, at the age of around 14 years old and the male, around 17 years old, make a final decision whether the patients will continue to be treated orthodontically or surgically. Thereby, (I think) the relapse and retreatment problem after treatemnt we have observed so far might be minimized Furthermore, the active treatment time may be also reduced.
성낙창,김은호,문추연,김정권,장성호,김수생,박출재 동아대학교 환경문제연구소 1996 硏究報告 Vol.19 No.1
In this study, we can be obtained the following conclusions about the characteristics of leachate with waste compositions and landfill methods. pH shows a tendency to increase in E. landfill, because NH₃ is created by anaerobic degradation and dissolved in leachate. The concentrations of BOD and COD become different, In case of E. landfill, food of combustible is H. & S. landfill and then SS is high in concentration. According to passed time, T-N is high in concentration, but T-P shows a similar tendency. Heavy metals of leachate is lower than threshold concentrations. If leachate is treated biologically, microbes are not inibitory.
Consideration of Diluents Selection and Input Amounts of the Hunter Process for Tantalum Production
Jae‑Jin Sim,Sang‑Hoon Choi,Yong‑Kwan Lee,Sung Gue Heo,Taek‑Soo Kim,Seok‑Jun Seo,Kyoung‑Tae Park 대한금속·재료학회 2021 METALS AND MATERIALS International Vol.27 No.7
Tantalum (Ta) is a heavy refractory metal with an atomic weight of 180.95 g/mol, a density of 16.6 g/cm3, and a high meltingpoint of 3017 °C. With its refractory characteristics, it shows excellent chemical and physical stability as well as corrosionand heat resistance at elevated temperatures. The demand for Ta metal and related compounds is increasing with the expansionof the electronics and chemical industries. The Hunter process was proven to be effective in producing Ta powder in1953. Hunter proposed a method in which potassium heptafluorotantalate (K2TaF7) was reduced by sodium (Na). Thus far,this process has been the primary commercial method to produce Ta powder. In this study, quantitative differences wereanalyzed for diluent selection. Additionally, consideration was given to changes in the caloric value depending on the inputamount of diluents. Finally, the optimum material input and the properties of the prepared Ta were analyzed. Stoichiometricratios of K2TaF7(1 mol), NaCl (6.2–6.7 mol), Na (5–7 mol) were weighed, to perform a metallothermic reduction reaction. After the reaction, the tantalum powder was recovered and the flush process was carried out. After that, it was dried in avacuum atmosphere. Physical properties such as oxygen concentration, PSA, ICP-OES, and XRD of powder were conductedto evaluate the characteristics of Ta powder that was finally manufactured.