http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
SI 엔진에서 고속 NDIR 분석법을 이용한 과도상태 CO₂ 농도와 A/F 측정
이석원(Sukwon Lee),김우석(Wooseok Kim),이종화(Jonghwa Lee),박진일(Jinil Park),유재석(Jaisuk Yoo) 한국자동차공학회 2004 한국자동차공학회 춘 추계 학술대회 논문집 Vol.- No.-
A fast response CO₂ analyzer has been developed to study transient characteristics of SI engine. The analyzer has 4.5 ms delay time and 2.8ms time constant, which is fast enough to measure CO₂ concentration on transient condition. Wide range of A/F ratio can be also estimated using the analyzer with an additional switch type oxygen sensor. The result of measurement of CO₂ concentration and A/F ratio on transient condition including rapid acceleration, rapid deceleration, and EGR on/off is presented and compared with commercial exhaust gas analyzer and UEGO sensor.
가시회 장비와 FRFID를 이용한 연료거동 분석법 개발에 관한 연구
이석원(Sukwon Lee),김우석(Wooseok Kim),이종화(Jonghwa Lee),유재석(Jaisuk Yoo),조한승(Hanseung Cho) 한국자동차공학회 2004 한국자동차공학회 춘 추계 학술대회 논문집 Vol.- No.-
Fuel behavior in the intake port has not been fully understood due to the complexity of fuel film behavior, although many researches have been carried out to identify the fuel transport phenomena in the port fueled gasoline engines. In this paper FRFID and visualization method are used in order to study on the fuel transport behavior. That is, the relationship between the control logic and uHC emission is analyzed by using FRFID, and fuel spray patterns and wall wetted fuel are visualized by using the visioscope. Through these methods, the characteristic of uHC emission is analyzed on steady(uHC concentration at idle is emitted about 100% higher than that at 2000rpm, bmep=2.0 bar) and transient (uHC emission is increased at rapid deceleration and fuel cut) condition including rapid acceleration/deceleration. Also, wall wetted fuel corresponding to coolant temperature is measured. In the case which the coolant temperature is 30 degree, fuel wetting is increased above 190% compared with that at fully warm up. And, the design parameters of the intake manifold to decrease the fuel wetting are considered by visualization.
SI 엔진의 연료특성에 따른 시동 시 제어와 HC 배출에 관한 연구
이석원(Sukwon Lee),김우석(Wooseok Kim),이종화(Jonghwa Lee),유재석(Jaisuk Yoo),한승훈(Seunghun Han) 한국자동차공학회 2004 한국자동차공학회 춘 추계 학술대회 논문집 Vol.- No.-
The gasoline for vehicles has a various characteristic according to the area. DI (Drivability index) is one of important factors which are expressed the characteristic. In this paper, the control logic of conventional ECU corresponds to DI is examined during 15 cycles after starting, and the control logic for reducing the HC emission is designed. Through comparing with logic of conventional ECU and developed control logic (injection duration is increased, and speak time is advanced.). It is verified that HC emission is the identical level in case of using conventional fuel, and HC emission reduce above 140% in case of using high DI fuel.
복합적인 전신질환이 있는 안면마비 환자의 양악 자성 피개의치 수복 증례
고은진,안수진,이석원,박수정,이성복,Ko, Eunjin,Ahn, Sujin,Lee, Sukwon,Park, Sujung,Lee, Richard Sungbok 대한치과보철학회 2015 대한치과보철학회지 Vol.53 No.2
부분 혹은 완전 무치악 환자에서 임플란트 치료가 보편화됨에 따라, 복합적인 전신질환이 있는 고령 환자들도 전통적인 총의치보다 임플란트-지지-고정성 보철물이나, 임플란트-유지-가철성 보철물을 선호하는 경향이 높아지고 있다. 본 증례의 환자는 77세 여성 환자로, 내원 당시 만성 고혈압으로 아스피린을 포함한 혈압약과 bisphosphonate 계열의 골다공증 약을 장기 복용 중이었으며, 상 하악 치조골 흡수량이 상당하였고 비대칭이 심하였다. 또한 2년 전 뇌졸중 진단을 받은 후, 우측 상반신마비로 인하여 좌측의 편측 저작만 가능하며, 팔 또한 좌측만 사용할 수 있는 상태(hemi-syndrome)이다. 초진 시 하악 총의치의 재제작만을 원하였으나, 상악 역시 잔존 치아들의 상태가 불량하여 치근을 이용할 수 있는 2개 치아를 제외한 나머지 치아들을 발거 후 치근에 의해 유지되는 피개의치를 계획하였으며, 하악에는 임플란트를 식립 후 그에 유지되는 피개의치를 계획하였다. 유지장치로는, 한 손으로도 쉽게 의치의 착탈이 가능한 자석을 선택하였다. 복용 중인 약의 전략적 중단을 통해 상악의 발치와 하악의 임플란트 식립을 시행하였고, 3개월 후 평가에서 임플란트가 주위 변연골 소실 없이 잘 유지되고 있어 자석을 이용한 피개의치를 제작, 장착하였다. 5개월 정기 검진까지 시행한 결과, 주목할 만한 합병증 없이 저작 기능 및 발음, 심미면에서 만족할 만한 결과를 얻었기에 보고하는 바이다. As dental implant treatment becomes popular for both partial and complete edentulous patients, old people with complex systemic diseases also tend to prefer implant-assisted-overdenture or implant-supported-fixed prostheses to conventional complete denture. In this case, 77-year-old female who was on medication for hypertension and osteoporosis and paralyzed on right side due to stroke visited for implant-assisted-overdenture on lower jaw. After oral and radiographic examination, root-assisted magnet overdenture on upper jaw and implant-assisted magnet overdenture on lower jaw are planned. Consequently, overdentures using self-adjusting magnetic attachment(SA) system on both jaws resulted in recovering satisfying function and retention, which is enable to insert and remove with only one hand.
가스 고속 샘플링 모듈 해석 및 가용 범위 결정에 관한 연구
김우석(Wooseok Kim),이석원(Sukwon Lee),이종화(Jonghwa Lee),박진일(Jinil Park),유재석(Jaisuk Yoo) 한국자동차공학회 2004 한국자동차공학회 춘 추계 학술대회 논문집 Vol.- No.-
As engine investigations in abnormal condition is recognized an important matter to meet strict enhanced emission regulations, needs of a fast response exhaust gas analyzer are getting stronger. A fast analyzing instrument of concentration should be designed to analyze gas concentration cycle by cycle by using fast sampling module and appropriate measuring methods for each emission elements. In this study, a fast sampling module with a new concept is introduced and flow analysis is performed using FLUENT code. According to the analysis, module's operating condition for applying engine and data for expecting measurement sensitivity are acquired. Calculated flow toward sampling module has 0.5~4% error, and back flow toward expansion tube is expected when CP chamber's pressure is over 0.6bar. For stable supply of flow toward optical cell, the pressure of sample gas should be 0.35~1.90bar when the pressure in the CP camber and the optical cell are 0.2bar and 0.158bar respectively.
문화예술복지정책에서의 장애인의 역할과 체감효용에 관한 연구
정연백(Jeong, Yeon-Baek),이석원(Lee, SukWon),이재완(Lee, Jae-Wan) 서울행정학회 2014 한국사회와 행정연구 Vol.25 No.3
문화예술은 인간의 삶을 풍요롭게 만들어 주는 토양이다. 그러나 사회적으로 문화예술향유의 격차가 크게 나타나고 있고, 특히 사회적 약자인 장애인의 경우 그 격차는 더욱 크다. 문화복지정책은 문화권(cultural rights)을 구현하고 문화격차를 해소할 수 있는 정책수단이다. 본 연구에서는 문화복지정책인 장애인 문화예술향수 지원사업을 장애인의 역할과 체감효용을 기준으로 그 단위사업을 평가하고자 한다. 단위사업의 내용분석을 통해 장애인의 역할이 문화생산자인지 문화소비자인지를 기준으로 분석하고, 그 사업이 인간다운 삶과 행복을 구현하는지와 관련된 체감효용을 평가하기 위해 참여자와 관객을 대상으로 설문조사를 하였다. 장애인의 역할에 대한 단위사업의 내용분석 결과, 장애인 문화예술 집중육성 사업이 장애인을 가장 적극적인 문화생산자로서의 지위를 인정하고 있으며, 장애인 국제교류 사업, 장애인 문화향수 지원사업, 풀뿌리장애인 문화예술활동 지원사업 순이었다. 체감효용에 대한 설문조사 결과, 장애인들은 단위사업에 대한 만족도가 매우 높고, 사업 참여로 인한 긍정적인 효과가 큰 것으로 나타났다. 장애인 문화예술 공연 및 전시를 관람한 관객들의 경우도 장애인에 대한 인식전환의 계기가 되었으며, 장애인 문화예술의 가치에 대해 높게 평가하고 있었다. 앞으로 장애인 문화예술향수 지원사업을 통해 장애인들의 문화향유 기회를 충분히 보장하고, 나아가 장애인들을 문화창조자로 발전하기 위한 정부의 정책적 지원과 관심이 필요하다. Culture and arts enrich the life of human beings. However, depending on the social environment, a huge gap to enjoy the cultural arts exists, in the case of people with disabilities, it is even greater. Culture welfare policy is policy tools that bridge the gap and realize the cultural rights. In this study, we analyze the meaning of the cultural rights and the needs of cultural welfare policy. And we classify its types by the role of the disabled in The Support Program of Art & Cultural Enjoyments and evaluate its efficacy by the survey participants and audience. Based on survey, the participants with disabilities very satisfies the program, the program participants appeared and showed a large positive effect due to the participation of program. Awareness for people with disabilities, which can change even if the instrument can be the Disabled cultural arts performances and exhibits of the audience who watched about the value of arts, culture, people with disabilities, and was highly appreciated. This implies that continued government support and attention is needed because more people with disabilities in order to receive the benefits.
강창구(Changgu Kang),이석원(Sukwon Lee) 한국정보기술학회 2022 한국정보기술학회논문지 Vol.20 No.11
In everyday life, people continue to live with various physical interactions with the environment, such as walking, opening the door, drinking water, talking on the phone, and sitting down. Various studies on such interactions are being conducted. The physical interaction starts with contact, and interaction operations may be classified according to the contact portion of the person. Despite this importance, most studies have focused on interactive contact posture or behavioral induction, and studies on determining whether or not to contact a physical object have been lacking. To overcome this situation, we propose a method for detecting hand contact states where the most frequent contact occurs in physical interactions. The proposed method consists of a bidirectional LSTM based feature vector generation part and a contact detection part. In addition, the contact detection part has a learning structure in which the left and right hands are divided. We perform model learning using the collected motion data, and the test results of the learned model shows 93.9% accuracy.