http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
메탄/공기 층류 부분예혼합화염의 상세 라디칼(OH*, CH* 그리고 C<sub>2</sub>*) 정보와 배기매출물에 관한 실험적 연구
정용기,오정석,전충환,장영준,Jeong Yong Ki,Oh Jeong Seog,Jeon Chung Hwan,Chang Young June 대한기계학회 2005 大韓機械學會論文集B Vol.29 No.2
An experimental study was performed to investigate the effects of partially premixing, varying the equivalence ratios from $0.79{\sim}{\infty}$, on NOx emissions and chemiluminescence of excited $OH^{\ast},\;CH^{ast}\;C_2^{\ast}$ radicals in laminar partially premixed flames. the signal from the electronically excited state of $OH^{\ast},\;CH^{ast}\;C_2^{\ast}$ was detected through a band pass filter with a photo multiplier tube, which are processed to the intensity ratio ($C_2^{\ast}/CH^{\ast},\;C_2^{\ast}/OH^{\ast},\;and\;CH^{\ast}/OH^{\ast}$) to reveal the correlation with local equivalence ratio. And measurements of NOx emission were made to investigate the relationship between visible flame appearance, chemiluminescence, and EINOX. The results demonstrated that (1) the flames at ${\phi}<1.59$ exhibited classical double flame structure, at ${\phi}>4.76$, the flames exhibited diffusion flame structure, and the intermediate flames at $1.59<{\phi}<4.76$ was a merged flame, (2) the $OH^{\ast}$ peak was located inside the $CH^{\ast}\;and\;C_2^{\ast}$ radical for all measured conditions and the emission intensity ratio of $C_2^{\ast}/CH^{\ast}\;and\;C_2^{\ast}/OH^{\ast}$ were identified as good marker for local equivalence ratio over a range of ${\phi}=0.79{\sim}1.2\;and\;CH^{\ast}/OH^{\ast}\;is\;0.79<{\phi}<1.9$. However, it was difficult to predict the equivalence ratio in partially premixed flames using this system for ${\phi}>2.38$, (3) the minimum NOX emission index (EINOx) is obtained for a equivalence ratio of 3.19 in the intermediate flames.
메탄 공기 층류 부분 예혼합화염에서 예혼합 정도에 따른 화염구조와 질소산화물의 배출에 미치는 영향에 관한 연구
오정석(Jeong Seog Oh),정용기(Yong Ki Jeong),전층환(Chung Hwan Jeon),장영준(Young June Chang) 대한기계학회 2003 대한기계학회 춘추학술대회 Vol.2003 No.11
It is shown that the effect of variable parameters on flame structures and NOx emissions in the laminar<br/> partially premixed methane-air flames with a co-axial Bunsen burner. Objectives of this paper is to<br/> understand the effects of flow variables on NOx emissions and the flame structure with OH<br/> chemiluminescence, including reconstructed image by abel inversion processing at each conditions. A fuel<br/> flowrate of 200 [cc/min] was fixed and the amount of air was varied from 400 to 1200 [cc/min]. The<br/> experimental variables were equivalence ratio( ), fuel split percentage( ) and inner tube recess(x/D). Flow<br/> conditions were ranged from 1.36~4.76(equivalence ratio), 50~100(fuel split percentage) and 0~20(inner<br/> tube recess). NOx analyzer and ICCD camera with a OH filter were used as a main experimental<br/> apparatus. In addition, Abel inversion, which is a kind of tomography and valuable to estimate a<br/> two-dimensional structure of co-axial flames from cubical information, was employed for combustion<br/> diagnostics. Results from this study indicate that the main effects depend on equivalence ratio and next<br/> sigma, x/D for NOx production and OH formation. Throughout Abel inversion, we could affirm the<br/> maximum position and the tendency of OH radical intensity by variants at five axial heights above the<br/> burner exit.
최동석(D.S.Choi),김덕줄(D.J.Kim),오승묵(S.M.Oh),황의상(E.S.Hwang),정용일(Y.I.Jeong) 한국자동차공학회 1996 한국자동차공학회 춘 추계 학술대회 논문집 Vol.1996 No.6_2
The OH molecule is a highly reactive combustion intermediate and relatively abundant in combustion systems. It also has the availability of convenient UV -laser systems to excite the A²Σ-X²?? electronic transition. The spectroscopic parameters describing this transition are well known. In this research, the OH molecule was measured in the laminar flame burner and constant volume combustion chamber(CVCC) in order to use it as the fundamental data for studying combustion phenomena. The LIF images of the OH molecule in the laminar 리ame burner were caught by using KrF excimer laser and ICCD camera. The natural fluorescence<br/> of OH was also measured by the interference filter(310 nm) and spectrometer in the CVCC at different equivalence ratios.
Kyu-shik Jeong,정원일,Jae-yong Chung,Mi-young An,Chae-yong Jung,Gyoung-jae Lee,Jong-soo Kang,Byeong-cheol Kang,Young-heun Jee,Bruce H Williams,Young-oh Kwon,Da-hee Jeong 대한수의학회 2003 Journal of Veterinary Science Vol.4 No.2
Cirrhosis Occurring in a Young Woodchuck (Marmota monax) Due to Vertical Transmission of Woodchuck Hepatitis Virus (WHV)Da-hee Jeong, Won-il Jeong, Jae-yong Chung, Mi-young An, Chae-yong Jung, Gyoung-jae Lee1, Jong-soo Kang1, Byeong-cheol Kang2, Young-heun Jee3, Bruce H Williams4, Young-oh Kwon5 and Kyu-shik Jeong*College of Veterinary Medicine, Kyungpook National University, Daegu 702-701, Korea1Shinwon Scientific Co., LTD, Research Institute, Suwon, Korea2Clinical Research Institute, Seoul National University, Seoul 110-744, Korea3College of Veterinary Medicine, Jeju National University, Jeju 690-756, Korea
오정환,최수남,정익수 한국운동역학회 2005 한국운동역학회지 Vol.15 No.1
C. H. OH, S. N. CHOI, I. S. JEONG. Kinematic Analysis of the Badminton Drop-shot Motion. Korean Journal of Sport Biomechartics, Vol. 15, No. 1, pp. 221-235, 2005. The purpose of this study was to analyse badminton players' drop-shots, in order to make players understand the principles of drop-shot motion in badminton. Three dimensional analysis was used to measure movements such as the time required per section, the change of center of gravity, joint angle and speed, and joint speed. The results of this study revealed as follows: (1) top players are faster than amateurs in the total time required per section; (2) top players moved more in the x-axis and z-axis, while amateurs moved more in the y-axis; (3) the inclination of amateurs was greater than that of top players in all phases; (4) amateurs showed larger angle on the shoulder joints than top players in the first phase, while top players showed larger angle on the shoulder joint than amateurs in the second and third phase. Amateurs' angle was larger on angle joint in the first phase than top players' ones, while top players' angle was larger in the third phase than amateurs; (5) the speed of racket head of top players was faster than that of amateurs; and the velocity of the center of gravity of amateurs was greater than that of the top players. The findings of this study were that gravity decreases during impact and then the velocity increases to perform the follow-through and making the swing fast by increasing the speed of the racket head is most important.
알칼리 처리에 의한 폴리에스테르 필름의 강도 및 염색성의 변화
오정숙,이광주,전정희 효성여자대학교 가정대학 학도호국단 1985 家政大論集 Vol.4 No.-
When polester fibers are hydrolyxed in alkaline solution, they dissolve successively from their surface and change their dyeability. We examined the weight loss ofpolyester films treated with NaOH solution under various conditions and the equilibrium.amount of disperse dyes absorbed in films. An uptake of dyes on films treated withan alkaline solution has beer discussed in relat'on to the changes of weight loss of films. The changes of weight loss increased linearly on hydrolyzing time because ofdissolving uniformly froml their surface of films. However. in high concentrations ofalkaline solution, the changes of weight loss increased drastically owing to OH-attackedto the inner regions of films. The tensile strength of hydrolysed films decreased a sodden drop when the weightloss were low. But it decreased gently when weight loss were high. The dye uptake of hydrolyzed films increased a very small amount below 20% ofweight loss. However, it increased remarkably above 20% of weight loss.
Jeong‑Han Lee,Ik‑Hyun Oh,Ju‑Hun Kim,Sung‑Kil Hong,Hyun‑Kuk Park 대한금속·재료학회 2021 METALS AND MATERIALS International Vol.27 No.9
Densely consolidated WC-based hard materials with 5–20 vol% ZrSiO4was fabricated by spark plasma sintering at 1400 ℃ ata constant heating rate of 70 ℃/min−1. To achieve mechanical alloying of WC-ZrSiO4, planetary ball milling was carried outfor 12 h, during which the brittle-brittle components (WC-ZrSiO4) became fragmented and their particles became refined. Itwas observed that certain, specific, non-isothermal sintering kinetics, such as apparent activation energy, sintering exponents,and densification strain, affected the densification behavior. The evolution of phase structure from powder to compact wasfound to be related the lattice distortion and micro-strain in the basal planes of WC. By examining the mechanical propertiesof the samples, it was that the added zircon content leads to enhanced fracture toughness (12.9 MPa m1/2) owing to thepresence of WC-ZrSiO4 in the cemented carbide. In fact, the microcrack propagation of the fracture passed through zirconfrom a transgranular to a ductile component (fcc) where the crack tips could be absorbed.
오정환,오창남,정도혁 대한스포츠의학회 1994 대한스포츠의학회지 Vol.12 No.2
Injuries to the sternoclavicular joint are not frequent, and the posterior dislocation of the sternoclavicular joint is much more rare. As the diagnosis is not easy with simple radiographic technique, special techniques are required. A case of the traumatic posterior dislocation of the sternoclavicular joint had been reported in our literature up to now. We also experienced a case of the retrosternal dislocation of the clavicle which had been caused by a ski injury and had a satisfactory clinical result with a closed reduction in a long-term follow-up. So we are reporting this case with a review of the literatures along with the injury mechanism.
Jeong‑Han Lee,Ik‑Hyun Oh,Jun‑Ho Jang,Ju‑Hun Kim,Sung‑Kil Hong,Hyun‑Kuk Park 대한금속·재료학회 2021 METALS AND MATERIALS International Vol.27 No.5
In this study, Al, Cr and Si fine powders were alloyed by planetary ball milling to investigate their microstructural evolution,following their mechanical alloying behavior. The formation of Al(Cr) supersaturated solid solution by the Cr grainsembedded in Al-matrix, which contributed substitutional structure is discussed in relation to their structural evolution inaccordance with the distortion of a crystal lattice. The compacts of Al–Cr–Si alloys were prepared by rapid sintering withina short time by dense consolidation above the density of 99.9% as the formation of intermetallics, except in the case of thedistribution of single-phases induced by the Al-melting. The formation behavior of intermetallics was dominated by dependenceon the structures of the milled-powder and subsequent sintering temperature. To estimate the consolidated behaviorsof compacts, various approaches derived from TEM and XRD analysis were taken to obtain microstructural evidences ofthe inter-diffusion, following the presence of thermally stable intermetallics.