http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
박희범,엄인섭,김성민 한국도로학회 2010 한국도로학회논문집 Vol.12 No.4
This research was conducted to analyze the behavior of Single-PTAS (Single Post-Tensioned Approach Slab) under tensioning and environmental loads by performing field tests when the demonstration Single-PTAS was being constructed. The temperature measurement sensors were installed at different depths, and the displacements in the approach slab under environmental loads and tensioning were measured using displacement transducers. As an experimental result, an abrupt change in the longitudinal displacement due to tensioning was not observed. The daily temperature change in the approach slab was negligible where the depth is over about 35cm. The temperature gradient in the approach slab adjacent to bridge was smaller than that adjacent to pavement. The patterns and magnitudes of vertical displacements were directly related to the temperature gradient at the measuring location. The behavior of Single-PTAS was very similar to that of concrete pavement. Therefore, a new design methodology for approach slabs is needed to include the pavement concept and to overcome drawback of current design procedures based on the simple beam concept. 본 연구는 프리스트레스가 도입된 접속슬래브(Single-PTAS: Single Post-Tensioned Approach Slab)의 긴장력 도입에 따른 거동과 환경하중에 대한 거동을 분석하기 위하여 시험시공 현장에서 실험을 통해 수행되었다. 실험을 위해 온도측정센서를 슬래브의 깊이에 따라 장착하였으며, 변위측정게이지를 슬래브의 여러 위치에 설치하여 환경하중 및 긴장력 도입에 따른 슬래브의 변위 변화를 3차원적으로 측정하였다. 실험결과 접속슬래브는 길이가 짧아 긴장력 도입에 의한 급격한 종방향 변위 변화는 관찰되지 않았다. 접속슬래브의 깊이별 일일 온도변화는 깊이가 약 35cm보다 깊을 경우에는 거의 발생하지 않았으며, 수직온도구배는 접속슬래브의 두께가 큰 교대부근에서는 포장과 인접하는 부근에서 보다 작아졌다. 컬링 시 수직변위의 변화 양상 및 크기는 측정 지점의 수직온도구배와 직접적으로 관계가 있었다. Single-PTAS의 거동을 분석한 결과 콘크리트 포장 슬래브와 매우 유사한 거동을 보였으며, 따라서 차륜하중만을 고려하여 단순보로 설계하고 있는 접속슬래브에 포장체의 개념을 도입한 설계방안의 정립이 필요한 것으로 판단되었다.
조문진,강민수,이경하 한국도로학회 2015 한국도로학회 학술발표회 논문집 Vol.2015 No.10
실제 주행 시 운전자가 느끼는 승차감을 평가하기 위하여 Das등(1999)은 접속부 부등침하량이나 접근 경사 대신 IRI를 평가에 사용하였다. 측정방법은 그림 1과 같이 차량으로 조사하는 방법과 도보로 측정하 는 방법이 있다. 현재 국도 및 고속도로의 경우에는 차량을 이용하여 전구간을 조사하고 있으며 차량을 이용한 조사방법은 교통차단을 하지 않고 빠른시간에 조사를 할 수 있다는 장점이 있으나 단구간 토목구 조물인 접속슬래브 구간의 경우는 국부적인 처짐이나 단차가 발생하는 곳에서는 현실을 반영하는 데는 어 려움이 따른다. 또한 포장유지관리 시스템(Pavement Management System, 이하 PMS) 상의 분석자료 는 프로그램 알고리즘 상 교량과 접속슬래브 조인트가 포함된 10m 구간의 자료는 교량으로 편입되게 되 어 있고, 단위 구간이 100m를 평균한 자료여서 실제 접속슬래브 IRI 값이라고 하기에는 한계가 따른다. 따라서 본 연구에서는 접속슬래브 부근(이하 접속부)의 국부적인 처짐이나 단차를 정밀측정 할수 있는 도 보식 측정장비인 Walking Profiler을 이용하여 접속부 평탄성을 조사하였다. 그림 2는 단구간에서 PMS 자료와 Walking Profiler의 편차를 보여주고 있다.
환경하중에 의한 교량 프리스트레스 접속슬래브의 컬링 거동 수치 해석적 분석
박희범,엄인섭,김성민,이석근 한국도로학회 2011 한국도로학회논문집 Vol.13 No.3
본 연구는 프리스트레스 접속슬래브(PTAS: Post-Tensioned Approach Slab)가 환경하중을 받아 컬링할 때의 거동을 수치해석을 통해 적절히 분석하기 위하여 수행되었다. PTAS의 한쪽 단부가 교대에 힌지로 연결되는 부분을 해석 모형에 적합하게 포함시킬 수 있는 방법을 마련하였으며, 접속슬래브의 헌치 부분을 삭제한 단순 형상의 접속슬래브 모델의 사용성도 분석하였다. 개발한 모델을 이용하여 교대 뒤채움부 침하에 의한 접속슬래브의 컬링 응력 특성을 분석하였다. 연구 결과, PTAS의단순화 힌지를 포함한 단순 형상 모델은 실제 형상 모델의 최대인장응력을 산출하기에 적합한 것을 알 수 있었다. 또한 컬업시에는 하부지반 침하가 없는 PTAS에서 최대인장응력이 도출되었으며, 컬다운 시에는 하부지반 침하가 진행된 PTAS에서 최대인장응력이 발생하므로 이러한 컬링 응력을 고려하여 설계를 수행하는 것이 적절할 것으로 분석되었다. The numerical analyses were performed to investigate the curling behavior of the post-tensioned prestressed concrete approach slab (PTAS)under environmental loads. A technique to include properly the boundary conditions of one end of PTAS that was connected to the bridge abutment using hinges was proposed for the numerical model. The applicability of a simplified model not having hunches was also investigated. By using the developed models, the curling behavior of PTAS was analyzed when the foundation settlement occurred. The analysis results showed that the maximum tensile stress obtained from the simplified model involving a simplified hinge connection was very closed to that obtained from a rigorous model. When the slab curled up, the maximum tensile stress occurred in the model including no foundation settlement, but when the slab curled down, the maximum stress occurred in the model including partial settlement of the foundation. Therefore, the design of PTAS should be performed considering those maximum tensile stresses.
일체식교량의 접속슬래브 연결철근 형상에 따른 연결부 구조거동에 대한 실험연구
유성근 ( Sung Kun You ),김나연 ( Na Yeon Kim ),김호섭 ( Ho Seop Kim ),김현기 ( Hyun Gi Kim ),김영호 ( Young Ho Kim ) 한국복합신소재구조학회 2014 복합신소재구조학회논문집 Vol.5 No.4
An experimental study on the structural behavior of connection types between approach slab and integral abutment has been done for three typical bar connections. Typical hinge style reinforcing bar detail for its connection is preferred in order to accommodate rotation of the approach slab among engineers. However, the straight horizontal bars can be used as connection detail accomodate structural capacity. Total six specimens with three types of rebar detail are tested for direct tensile and bending load. The characteristic structural behaviors are carefully monitored and all the strain gauge data obtained are analyzed. It is shown that the structural performance of all the specimens well exceed its design allowance. Several design suggestions are given based on careful reviews on the experiment.
일체식교량의 접속슬래브 연결철근 형상에 따른 연결부 구조거동에 대한 실험연구
유성근,김나연,김호섭,김현기,김영호 한국복합신소재구조학회 2014 복합신소재구조학회논문집 Vol.5 No.4
An experimental study on the structural behavior of connection types between approach slab and integral abutment has been done for three typical bar connections. Typical hinge style reinforcing bar detail for its connection is preferred in order to accommodate rotation of the approach slab among engineers. However, the straight horizontal bars can be used as connection detail accomodate structural capacity. Total six specimens with three types of rebar detail are tested for direct tensile and bending load. The characteristic structural behaviors are carefully monitored and all the strain gauge data obtained are analyzed. It is shown that the structural performance of all the specimens well exceed its design allowance. Several design suggestions are given based on careful reviews on the experiment.