漢江下流部 水害輕減을 爲한 調査 硏究

金漢星,高在雄,李相鎔,玄義泰,柳興根 건국대학교 1974 學術誌 Vol.17 No.1

The effect of reducing flood magnitudes, flood stages, and flood damage by upstream reservoir regulation are investigated in this study. The analytical procedures which has been established newly, are treated through this study for 7 index stations and same numbr of reaches. The method of this study could be expressed briefly as following procedures. Using stage-frequency relations and the potential damage survey data, damage-frequency relations are established, and from this, average annual flood damages computed. By holding out portions of the floods with various amounts of flood control storage in 6 reservoirs in the basin, routing were made to establish modified stage-frequency relations. From damage frequency relation, average annual damages are computed with and without condition of each control volume. The study result are concluded as follows; (1) The relationtship of corresponding water level between nearby stations are useful tools to adjust error of the data due to observation error and change of the gaging location. (2) The number of records about 10 years could not be applied for the statistical methods of flood frequency analysis. (3) The regional skew factors are recommended to apply flood frequency study by the log-Pearson Type III method. (4) The effect of damage reductions are greatly affectedin accordance with the routed flood. Therefore application of the Typical Tributary Contribution Flood are reasonable for this type of study. (5) In the North Han, effect of damage reduction due to the lacation of control point are gradually increased from upstream to downward until the confluence of North and South Han. (6) In the South Han, control effect are increased from Chungju to Yeoju where the maximum effect are analyzed and then decrease gradually until the confluence. (7) Better hydrologic and topographic combinations for the flood control are existed in South Han to compare with North Han in this study results.

Circuit Weight Training이 비만 여고생의 신체조성 및 혈청지질에 미치는 영향

한재웅,고기준,이재규 한국스포츠리서치 2004 한국 스포츠 리서치 Vol.15 No.2

The purpose of this study was to determine the effects of Circuit Weight Training (CWT) on body composition and serum lipids in obese high school girls. The subjects were 11 obese highschool girls(BMI≥27㎏/㎡). They were to perform the Circuit Weight Training with 40~55% intensity of 1RM, for 50 mins/day, 3 times/week during 12 weeks. Before and after training, 10 ml blood was extracted from the antecubital vein of each subject for the purpose of analyzing its effects on serum lipids. The conclusion of this study is as follows : 1. In body composition and anthropometry profile after 12-week Circuit Weight Training was decreased significantly in %fat, BMI, body weight but LBM had no statistical signification. 2. 1. In serum lipid profile after 12-week Circuit Weight Training was increased significantly in TC, HDL - C and decreased significantly in PL but LDL - C had no statistical signification.

Circuit Weight Training이 여윈 여고생의 혈청 항산화 작용에 미치는 영향

이재규,한재웅 한국스포츠리서치 2004 한국 스포츠 리서치 Vol.15 No.4

The purpose of this study was to determine the effects of Circuit Weight Training(CWT) serum antioxidant activity in lean high school girls. The subjects were 10 lean highschool girls(BMI<19㎏/㎡). They were to perform the Circuit Weight Training with 40~55% intensity of 1RM, for 50 mins/day, 3 times/week during 12 weeks, Before and after training 10 ㎖ blood was extracted from the antecubital vein of each subject for the purpose of analyzing its effects on serum antioxidant activity. The conclusion of this study is as follows: 1. In serum antioxidant activity profile after 12-week Circuit Weight Training was increased significantly in H₂ O₂ OH, MDA. 2. In serum antioxidant activity profile after 12-week Circuit Weight Training was decreased significantly in Uric acid.

산업대학 건축공학과 교육과정 개발에 관한 연구

임응찬,한인웅,이승준,박재호,조방현,서형수,정구용,한기원,김진원,임상규,이재윤 三陟大學校 1996 論文集 Vol.29 No.2

By impproving the educational program of the Department of Architectural Engineering and studying the theory of learning and the applied method necessary for the development of nation and society, we should develop a satisfying course of education to meet the demand and skill in the industralized society for the purpose of cultivating men of baility with great personalities and creative minds. Therefore, this study focused on classifying several kinds of occupations in the prart of architectured related to what graduates from the department of Architectural Engineering go with into the society. Accordingly after choosing some works adequate to each occupation by the proposed curricula, we tried to establish the scope of education and courses corresponding to the jobs and thus and develop a satisfying curriculum.

원판 브레이크에서의 피로 파괴 해석

조재웅,한문식 한국공작기계학회 2008 한국공작기계학회 추계학술대회논문집 Vol.2008 No.-

This study investigates the fatigue life and the damage possibility of disk brake by the fatigue tool of Ansys workbench. Among nonconstant fatigue loads, the case of 'SAE Bracket History' which is severest at the variation of load tends to be most unstable. The case of 'Sample History' which becomes a little slow at the variation of load tends to be most stable. The maximum relative damage in case of 'SAE Bracket History' is occurred near the average stress '0' and this case can be shown to have the possibility to take more damage than another case.

동적 파괴 가속장치의 보정 및 시험장치 설계

조재웅,한문식 한국공작기계학회 2007 한국공작기계학회 추계학술대회논문집 Vol.2007 No.-

The force transducer in the acceleration plant due to dynamic fracture is calibrated by dynamically using the stress pulses from a longitudinal bar. The bar is supported by two strings attached to the ceiling. The bar velocities before and after impact are measured and a full bridge at bar and transducer is formed by the four strain gauges. A transient recorder is used to store the stress pulse signals of force transducer and bar. For the first test series, three point bend test specimens can be chosen by means of test rig design and the inspection as sample experiment in this presented paper is sufficient for proving with the numerical simulation of the specimen model.

판재에 있는 구멍 또는 이종재료 사이에서의 크랙 전파 거동

조재웅,한문식 한국공작기계학회 2005 한국공작기계학회 춘계학술대회논문집 Vol.2005 No.-

This study investigates the behavior of fatigue crack propagating between holes or holes filled with another materials. When holes or the holes bonded with another materials exist near center crack symmetrically, crack propagation rate is influenced by the bonding force of brazing part and the elastic modulus ratio of another material to matrix. It is experimentally and analytically confirmed that the center crack stops when its tip reaches near the center line of the holes and a small crack is initiated from the boundaries of holes or the holes filled with another materials and it propagates to final fracture. The mechanical behaviors of center crack near another materials are also investigated.

여고 테니스 우수선수와 비우수선수의 호흡순환기능에 관한 연구

고기준,이재규,김종인,이광무,한재웅,신군수,김태운,안병철,문혜경 釜山大學校 附設 體育科學硏究所 1999 體育科學硏究所 論文集 Vol.15 No.-

The purpose of this study was to evaluate a study on Cardiorespiratory Functions of Elite Tennis Player and Non-Elite Tennis Player in Female High-School. The subjects were included 2 group(each group n=7); Elite Tennis Player group and Non-Elite Tennis Player group. The conclusion of this study was as follows: 1. Elite Tennis Player group showed significantly high in VO2max(p<.001) 2. Elite Tennis Player group showed significantly high in VCO2(p<.001) 3. Elite Tennis Player group showed significantly high in VO2max/kg(p.05)

고온에서 회전하는 터빈엔진 디스크의 응력해석

황수철,국정한,조재웅,하영민 한국공작기계학회 1995 한국생산제조학회지 Vol.4 No.4

This study includes thermal plasticity analyses for a turbine rotor with the simple geometry and the boundary conditions. When centrifugal or thermal stress are applied at the high temperarture material of engine blade, stress distributions in material σ_rr, σ_θθ, τ_rθ. Mises stress) are analyzed by computer simulation(ABAQUS) as followings; 1. The maximum stress at the radial direction (σ_rr) is applied at the upper middle part of spline hole. 2. The maximum stress at the tangential direction (σ_θθ) is applied at the upper right boundary of spline hole. 3. The maximum shear stress (τrθ) in (-) direction is applied at the upper middle part of spline hole. 4. The maximum Mises stress is applied at the upper right boundary of spline hole. This stress is due to the critical stress by which rotor can be fractured according to elapsed time.

여고생의 BMI와 체력과의 상관관계

이광무,고기준,한재웅,김태운,김종원 釜山大學校 附設 體育科學硏究所 1998 體育科學硏究所 論文集 Vol.14 No.-

The purpose of this study was to investigate the correlation of BMI and physical fitness in high school girls. The subjects were high school girls(n=295). The measurement items are physical fitness, physique, physique index(BMI : Body Mass Index). The conclusion of this study was as follows; 1. The record of 100M sprint, standing long jump, and sit ups showed a slack downward curve(low record) as BMI rises. 2. The record of softball showed a slack upward curve(high record) as BMI rises. 3. The record of 800M run, sit-ups and softball throw, from the top to the bottom. 4. The order of correlation between BMI and physical fitness was, flexed-arm hang, 100M sprint, standing long jump, 800M run, sit-ups and softball throw, from the top to the bottom. Therefore, we concluded that correlation BMI and physical fitness showed not so high.