http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
IoT 기반 화재탐지시스템의 연기 및 온도감지기 비화재보 신호 패턴 분석
박승환,김두현,김성철,Park, Seunghwan,Kim, Doo-Hyun,Kim, Sung-Chul 한국안전학회 2022 한국안전학회지 Vol.37 No.2
Fire-alarm systems are safety equipment that facilitate rapid evacuation and early suppression in case of fire. It is highly desirable that fire-alarm systems have low false-alarm rates and are thus reliable. Until now, researchers have attempted to improve detector performance by applying new technologies such as IoT. To this end, IoT-based fire-detection systems have been developed. However, due to scarcity of large-scale operational data, researchers have barely studied malfunctioning in fire-alarm systems or attempted to reduce false-alarm rates in these systems. In this study, we analyzed false-alarm rates of smoke/temperature detectors and unwanted fire-alarm signal patterns at K institution, where Korea's largest IoT-based fire-detection system operates. After analyzing the fire alarm occurrences at the institution for five years, we inferred that the IoT-based fire-detection system showed lower false-alarm rates compared to the automatic fire-detection equipment. We analyzed the detection pattern by dividing it into two parts: normal operation and unwanted fire alarms. When a specific signal pattern was filtered out, the false-alarm rate was reduced to 66.9% in the smoke detector and to 46.9% in the temperature detector.
코로나로 인한 조사모드의 변화에 따른 오차 보정 방법론과 소지역 추정 개선에 관한 연구
박승환 ( Seunghwan Park ) 한국조사연구학회 2022 조사연구 Vol.23 No.4
The number of cases in which the survey mode changes in one survey is increasing as a result of COVID-19, and the use of mixed-mode surveys is expanding accordingly. The transition from face-to-face to non-face-to-face investigation can overcome the difficulty of face-to-face contact and result in an increase in response rate. In order to estimate the change in survey mode in a survey, an error due to mode selection must be corrected. This study proposes a method of estimating in a mixed-mode survey based on a change in survey mode from face-to-face to non-face-to-face in the household financial welfare survey. Based on the measurement error model, the error caused by the change in survey mode is corrected using the missing pack replacement method. We present variance estimation using Taylor linearization for the proposed method as well as simulation results to demonstrate the performance of the proposed method.
스마트카드를 이용한 프록시 재 암호화 기법 기반 콘텐츠 공유 메커니즘에 관한 연구
박승환(Seunghwan Park),구우권(Woo Kwon Koo),김기탁(Kitak Kim),문혜란(Hyeran Mun),이동훈(Dong Hoon Lee) 한국정보보호학회 2011 정보보호학회논문지 Vol.21 No.3
OMA(Open Mobile Alliance)는 모바일 디바이스 분야에서 DRM 기술에 대한 가장 활발한 표준화 활동을 벌이고 있으며, 2007년에는 OMA-DRM v2.1 표준을 발표하였다. 이후 2009년에는 OMA-DRM v2.1의 확장이라고 할 수 있는 OMA-SRM(Secure Removable Media)과 SCE (Secure Contents Exchange)등 DRM 기술과 공유 모델에 대한 표준을 발표하였다. SCE는 사용자도메인을 구성하여 OMA-DRM v2.1에서 정의된 모바일 디바이스뿐만 아니라 일반 가전기기(Phone, PC, 카오디오 등)간의 콘텐츠 및 권리(Rights)를 공유할 수 있다. 본 논문에서는 OMA-DRM과 SCE의 기술과 공유 모델에 대하여 분석을 하고, 프록시 재 암호기법을 사용하여 공유된 콘텐츠와 권리를 이용하기 위한 각 개체들의 키 분배방법을 제시하고자 한다. OMA(Open Mobile Alliance) is one of the most active group about DRM technology in mobile device field. OMA announced an OMA-DRM v 2.1 standardization in 2007. After then OMA announced OMA-SRM(Secure Removable Media) and SCE(Secure Contents Exchanges) that are the extension of OMA-DRM v2.1. In SCE, a user can form user domain to share contents and rights. So the user can share contents and rights with not only the the OMA-DRM v2.1 but also home devices like mobile phones, personal computers and audios. In this paper, we analyze a sharing technology of OMA-DRM and SCE, and then propose key distribution method using proxy re-encyption and smart card to use shared contents and rights.
공동주택에서 미세먼지 특성 평가를 위한 정량적 지표 개발 연구
박승환(Seunghwan Park),송두삼(Doosam Song) 대한설비공학회 2016 대한설비공학회 학술발표대회논문집 Vol.2016 No.11
Recently, hazardous gases and fine dust deteriorate the IAQ. The air cleaner and AHU can be used for removing indoor fine dust. Most studies related to fine dust removal was accomplished in chamber. Thus, it is necessary for domestic researches to study on the removal of fine dust in residential building. Further, in the actual residence different from the chamber, existing method is difficult to compare and analyze quantitatively because it is hard to match the initial value and generation concentration varies greatly in each case or activity. Therefore, this study will propose several methods that can solve these problems. The results are as follows; -In the fine dust generation and removal, despite the same conditions, the initial value and the generation concentration was different for each case. Also, although fine dust was removed quickly when the air-volume is strong, the stabilization concentration became similar at a certain point of time regardless of the air-volume. -Fine dust removal efficiency and speed were very differ. Removal speed is capable of quantitative comparison and analysis due to comparing the concentration of a common section during the decrease interval in each case. -After appropriate time, operating intermediate air-volume is more effective than the only operating strong air-volume. This is because fine dust of low concentration can be resuspended by the strong air-volume, which increase indoor ambient concentration. In other words, there is a proper air-volume in removal time zone.
ID기반 온라인/오프라인 사인크립션(Signcryption) 기법
박승환(Seunghwan Park),김기탁(Kitak Kim),구우권(Woo Kwon Koo),이동훈(Dong Hoon Lee) 한국정보보호학회 2010 정보보호학회논문지 Vol.20 No.5
ID기반 사인크립션(Signcryption) 기법은 메시지의 기밀성과 메시지 인증을 동시에 제공한다. 하지만 높은 연산 비용이 요구되기 때문에 스마트카드나 PDA와 같은 저전력 디바이스 환경에서는 사용되기 어렵다. 이러한 문제점을 해결하기 위한 새로운 개념의 기법이 온라인/오프라인 기법이다. 온라인/오프라인 기법은 서명이나 암호화의 연산 단계를 두 단계로 나누어서 한다. 첫 번째 단계는 오프라인 단계로서 서명 또는 암호화될 메시지를 알기 전에 수행할 수 있는 연산을 미리 하는 단계이다. 두 번째 단계는 온라인 단계로서 보낼 메시지와 수신자의 공개키를 알고 나서 서명 또는 암호화 연산을 수행하는 단계이다. 온라인 단계에서는 가능한 한 페어링이나 지수승 같은 연산 비용이 높은 연산을 하지 않게 설계되어 진다. 이러한 온라인 단계의 효율성 때문에 온라인/오프라인 기법은 스마트카드와 같은 연산 비용의 한계가 있는 디바이스에서 유용하게 사용될 수 있다. 본 논문에서는 기밀성과 메시지 인증을 제공하는 ID기반 사인크립션을 제안하고, 저전력 디바이스에서 사용될 수 있는 ID기반 온라인/오프라인 사인크립션 기법을 제안한다. 이 기법은 랜덤오라클 모델에 안전성을 두지 않는 최초의 ID기반 온라인/오프라인 사인크립션 기법이다. Signcryption is a cryptographic primitive which offers authentication and confidentiality simultaneously with a cost lower than signing and encrypting the message independently. We propose a new cryptographic notion called Identity-based online/offline signcryption. The notion of online/offline scheme can be divided into two phases, the first phase is performed offline prior to the arrival of a message to be signed or encrypted and the second phase is performed online phase after knowing the message and the public key of recipient. The Online phase does not require any heavy computations such as pairings or exponents. It is particularly suitable for power-constrained devices such as smart cards. In this paper, we propose ID-based signcryption scheme and ID-based online/offline signcryption scheme where the confidentiality and authenticity are simultaneously required to enable a secure and trustable communication environment. To our best knowledge, this is the first ID-based online/offline signcryption scheme that can be proven secure in the standard model.
박승환(Seunghwan Park),류민형(Minhyoung Ryu),조이상(Leesang Cho),조진수(Jinsoo Cho) 한국항공우주학회 2014 韓國航空宇宙學會誌 Vol.42 No.11
선풍기는 유도 전동기에 의해 구동되는 축류형 날개를 가진 기계이다. 본 연구에서는 기본 설계된 선풍기의 날개를 바탕으로 스태킹 라인의 최적 설계를 통해 선풍기의 성능향상을 목표로 하였다. 전산 해석을 위해 상용 툴인 Ansys 社의 CFX 14.5를 이용하였고, 난류 모델은 k-ωSST 를 사용하였다. 설계 변수는 스윕 각과 기울기 각으로 설정하였고, 유량과 토크를 목적함수로 설정하여 스태킹 라인의 최적화를 수행하였다. 최적화 결과 풍량이 증가하였고, 토크가 감소함을 확인 하였다. 최적화된 모델과 기본 모델은 KS C 9301을 이용하여 측정되었으며, 전산 해석 결과를 검증하였다. Electric fans, which consist of axial blades, are operated by the induction motor. In this paper, the objective of this study is the performance improvement of the base model fan using the design optimization. In order to aerodynamic analysis, computational simulations are performed using commercial tool ANSYS-CFX ver. 14.5. And k-ω SST turbulence model is used for the CFD analysis. The design variables are set up as sweep and lean angles. Volumetric flow rate and torque of the fan blades are fixed to objective function. The optimized model is shown the increment of the volumetric flow rate and the reduction of the torque compared with the base model. The experimental procedure is followed KS C 9301. CFD results and experimental results are fairly well matched.