http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Lu Wu,Yan Lai,Ying Wang,Lixia Tan,Lizhen Wen,Huasheng Yang 한국식품영양과학회 2020 Journal of medicinal food Vol.23 No.4
Hordei Fructus Germinatus (HFG) has been used as a traditional medicine to treat functional dyspepsia (FD) in China. Stir fried HFG (F-HFG) containing Maillard reaction products (MRPs) is used more widely than the raw HFG (R-HFG). However, the exact mechanisms in its functionality remain unclear. This article investigated the effect of R-HFG, F-HFG, and MRPs on brain-gut peptides, gut microbiota, and digestive enzymes using an FD animal mode. After administration of R-HFG, F-HFG, and MRPs, higher mRNA expression level of gastrin (GAS) and lower mRNA expression level of vasoactive intestinal peptide (VIP) were exhibited in F-HFG and MRPs rats than R-HFG rats (P < .05). Furthermore, compared with the R-HFG group, the contents of motilin (MTL) and GAS showed an upward tendency, whereas the contents of VIP and chokcystokinin (CCK) showed a downward tendency in the F-HFG group. In addition, bacterial communities in the control, F-HFG, and MRPs groups clustered closely to one another, and bacterial communities in the model and recovery groups clustered together, whereas the bacterial communities in the R-HFG group were clustered into a category. Moreover, there were no apparent differences in brain-gut peptides and gut microbiota between the F-HFG and MRPs groups. However, after the oral administration of R-HFG, F-HFG, and MRPs, the level of digestive enzyme did not show a significant change as compared with the recovery group. These results indicated that the stronger effect of F-HFG could be attributed to the MRPs produced during stir frying, and MRPs possessed the effect of regulating brain-gut peptides and gut microbiota.
Yong Zhang,Lizhen Wang,Aiqin Zhang,Yanhua Song,Xiaofeng Li,Xingbing Wu,Peipei Du,Lv Yan 한국화학공학회 2011 Korean Journal of Chemical Engineering Vol.28 No.2
To improve the specific capacitance and energy density of electrochemical capacitor, nanostructured NiO was prepared by high temperature solid-state method as electrode material. The crystal structure and morphology of as-parepared NiO samples were investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Cyclic voltammetry (CV) measurement was applied to investigate the specific capacitance of the NiO electrode. Furthermore,a novel mixed electrolyte consisting of NaOH, KOH, LiOH and Li_2CO_3 was prepared for the NiO capacitor,and the component and concentration of the four different electrolytes was examined by orthogonal test. The results showed that the NiO sample has cubic structure with nano-size particles, and the optimal composition of the electrolyte was: NaOH 2 mol L^(−1), KOH 3 mol L^(−1), LiOH 0.05 mol L^(−1), and Li_2CO_3 0.05 mol L^−1. At a scan rate of 10 mV s^(−1), the fabricated capacitor exhibits excellent electrochemical capacitive performance, while the specific capacitance and the energy density were 239 F g^(−1) and 85 Wh kg^(−1), which was higher than one-component electrolyte.
Kai Wen,Baiqing Xiong,Yongan Zhang,Zhihui Li,Xiwu Li,Lizhen Yan,Hongwei Yan,Hongwei Liu 대한금속·재료학회 2021 METALS AND MATERIALS International Vol.27 No.5
Precipitation characteristics influencing fatigue crack propagation contained matrix precipitate, grain boundary precipitateand precipitate free zone for Al–Zn–Mg–Cu alloys. Over-aging treatment could effectively regulate precipitation and then tobe able to change fatigue crack propagation behavior compared with the peak aging state. In the current work, typical T651and T7651 aging tempers of the alloy were extracted via hardness, electrical conductivity and mechanical properties underone-step and two-step aging treatments. Fatigue crack propagation (FCP) rate under them was tested and correspondingprecipitation characteristics and fracture morphology were observed. The results indicated that fatigue crack propagationresistance for the T7651 temper possessed an obvious improvement on the side of that for the T651 temper, which was alsosupported by fracture appearance, including tearing ridge, tearing dimple and fatigue striation. The precipitation observationshowed that the T651 alloy contained GPI zone, GPII zone and ηʹ phase while the T7651 alloy possessed ηʹ phase and η phase.Compared with the T651 temper, matrix precipitate for the T7651 temper distinctly owed an expanding of size distributionand an enlargement of average size while cuttable phase still remained the dominance for both tempers. Grain boundaryprecipitate and precipitate free zone manifested no obvious difference between the two aging tempers. Cut and bypass mechanismsof dislocation–precipitate interactions were used for explanation and it revealed the reinforced cuttable phase was infavor of enhancing fatigue crack propagation resistance. A theoretical model which directly correlated FCP rate with matrixprecipitate characteristics was employed to calculate FCP rate by substituting quantitative precipitate characteristics and thecalculation results were vaguely consistent with the experimental measurement, which proved its reliability and feasibility.
Kai Wen,Baiqing Xiong,Yongan Zhang,Zhihui Li,Xiwu Li,Shuhui Huang,Lizhen Yan,Hongwei Yan,Hongwei Liu 대한금속·재료학회 2018 METALS AND MATERIALS International Vol.24 No.3
In the present work, the infl uence of various retrogression treatments on hardness, electrical conductivity and mechanicalproperties of a high Zn-containing Al–Zn–Mg–Cu alloy is investigated and several retrogression regimes subjected to a samestrength level are proposed. The precipitates are qualitatively investigated by means of transmission electron microscopy(TEM) and high-resolution transmission electron microscopy techniques. Based on the matrix precipitate observations, thedistributions of precipitate size and nearest inter-precipitate distance are extracted from bright-fi eld TEM images projectedalong ⟨110⟩ Al orientation with the aid of an imaging analysis and an arithmetic method. The results show that GP zonesand η′ precipitates are the major precipitates and the precipitate size and its distribution range continuously enlarge with theretrogression regime expands to an extent of high temperature. The nearest inter-precipitate distance ranges obtained arequite the same and the average distance of nearest inter-precipitates show a slight increase. The infl uence of precipitates onmechanical properties is discussed through the interaction relationship between precipitates and dislocations.