http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
FTA 기법에 의한 원전기동전원의 신뢰성 예측과 신뢰성이 발전소의 경제성에 미치는 영향 연구
최규식 建陽大學校 1999 建陽論叢 Vol.- No.7
원자력발전소에는 발전기의 가동 및 정지시, 그리고 발전소의 비상시를 대비하여 기동변압기나 소내대기변압기가 설치되어 있다. 이러한 변압기를 이용한 소내전원계통의 구성은 발전소의 안전성과 경제성에 매우 중요한 위치를 차지하고 있기 때문에 구성요건, 부지특성, 신뢰성 및 이용율을 심각하게 고려하여 결정되어야 한다. 이렇게 중요한 사안에 대해서 지금까지는 안전성요건과 초기 건설비만을 고려하여 기동전원방식을 결정하였다. 본 연구에서는 1,000㎿급 2개 호기 표준원자력발전소의 기동전원계통에 대해서 3개의 기동전원구성안을 제시하여 FTA기법을 이용하여 기기와 시스템 및 구성의 신뢰성과 이용불능도를 산출한다. 산출된 이용불능도가 발전소의 경제성에 미치는 영향을 평가하고, 기동전원구성의 초기건설비, 철손비 및 철손비를 포함한 종합적인 평가를 하여 최적안을 결정하고자 하였다. The Start-up transformers or on-site stand-by transformer(s) are installed against the start-up and shut-down of generator and emergency status in nuclear power plant. The on-site power supply configuration using these transformers must be determined by considering configuration requirements, site characteristics, reliability and availability severely because it is remarkably important for safety and economy of plant. The start-up or stand-by power supply configuration has been determined considering only safety requirements and construction cost up to now in Korea. This paper proposes 2. unit based 3 alternatives for the start-up power supply system of 1,000㎿ standardized nuclear power plant. It determines the reliability and unavailability of equipment, system and configuration using FTA methodology. It estimates the effect of determined unavailability influencing the economy of nuclear power plant, and then, attempts to determine the optimized alternative through resultant estimation including initial construction cost, core loss, and copper loss of start-up or stand-by power supply.
Che, Gyu-Shik,Park, Man-Heung 建陽大學校 1994 建陽論叢 Vol.- No.3
지중송전케이블의 강제냉각방식중의 하나인 전력구트라프내 간접수냉방식에서의 송전용량 병화에 대해 고찰하였다. 강제냉각방식이 적용된 지중송전케이블계통의 전류용량을 결정하기 위하여 열해석을 수행하였으며, 각각의 인입냉각수 온도, 유량, 인입공기의 온도, 냉각구간별로 각종 파라미터를 이용하여 해석하고 그 결과를 고찰하였다. As one of forced cooling methods for the underground power transmission cable, external water cooled system within trough in tunnel in tunnel was investigated. The heat transfer analysis has been performed to determine the current carrying capacity of the underground power transmission system furnished with the forced cooling facility A parametric study was performed for each inlet cooling water temperature, flow rate, inlet air velocity and cooling span. This study shows that the current carrying capacity varies within the maximum permissible limit in compliance with the variation of inlet cooling water temperature and flow rate. It exhibits little variations for the most intervals in compliance with the variation of inlet cooling air temperature and flow rate. But, the current carrying capacity is reduced rapidly for a specified interval and consequently influences the underground transmission system. As a result, when an actual forced cooling system is designed, the design condition of inlet air has to be seriously considered as a most important parameter in determining the current carrying capacity.
최규식(Che Gyu-Shik) 한국콘텐츠학회 2006 한국콘텐츠학회 종합학술대회 논문집 Vol.4 No.1
H/W와 달리 S/W는 개발당시부터 그 속에 오류로 존재하고 있다가 어떤 특수한 기능을 필요로 할 때 드디어 검출되게 된다. 이로 인하여 소프트웨어의 고장이 발생할 수 있다. 본 논문에서는 소프트웨어의 테스트 단계 및 운영단계에서 검출되는 오류 및 이로 인한 고장 원인을 분석한다. 테스트 단계와 운영단계중 어느 쪽이 어떤 오류가 더 많이 발생하는가를 현장 경험을 통한 오류데이타 수집에 의하여 분석한다. The S/W error is in the S/W from the development stage other than H/W, and it may come out when the specific function is necessary. The S/W failure may happen due to these errors. I analyze causes of the fault detected during testing stage and operational stage, and fgailure caused by it. And then, I analyze which case of testing stage and operational stage is much severe than the other case by real failure data acquisition.
최규식 ( Gyu Shik Che ) 한국정보처리학회 2007 한국정보처리학회 학술대회논문집 Vol.14 No.1
그동안 소프트웨어의 신뢰도가 테스트중은 물론 운영중에도 고장을 검출 및 수벙함으로써 성장될 수 있다는 가정 하에 SRGM이 연구되어왔다. 한편, 어떤 논문에서는 운영중에 소프트웨어를 수정한다는 것이 특히 범용 소프트웨어인 경우 불가능에 가깝기 때문에 테스트노력이 일정한 것으로 가정하기도 하였다. 저자는 소프트웨어의 신뢰도 현상에 접근할 수 있는 단순한 기법을 제안하여 기존신뢰도 모델을 수정하지 않고 고장률을 줄일 수 있도록 하는 방안을 제시한다.