http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Takashi Abe(Takashi Abe ),Jeremy P. Loenneke(Jeremy P. Loenneke ) 사피엔시아 2021 Exercise Medicine Vol.5 No.-
Objectives: To maintain proper development, it is recommended that children/adolescents focus more on increasing physical activity than dietary restriction when treating obesity. In other words, adults are better able to tolerate the reductions in fat-free body mass that often occur when trying to lose fat mass. In contrast, children and adolescents should avoid losses in fat-free mass in order to ensure proper development. Therefore, when trying to reduce visceral fat in children via a negative energy balance (i.e., exercise with or without calorie restriction), it is necessary to set desirable conditions in order to minimize the loss of fat-free mass. To determine whether this is possible, we reviewed literature discussing the relationship between changes in visceral fat obtained by abdominal imaging and changes in total body fat and fat-free mass after exercise training with and without calorie restriction in children and adolescents. Methods: Literature review. Results and Conclusions: Previous work found no reduction in fat-free mass in the exercise interventions in which there was no dietary-induced calorie restriction. This supports the idea that reducing visceral fat by increasing physical activity is the preferred strategy over dietary restriction in children and adolescents. Although factors such as the type (e.g. aerobic and/or resistance) of exercise and the amount (i.e. energy expenditure) of exercise will likely have an effect on the magnitude of change in intra-abdominal visceral fat, the quantity of each that is needed without reducing fat-free mass is currently unknown.
Chang, P.,Abe, K.,Abe, K.,Abe, T.,Aihara, H.,Asano, Y.,Aulchenko, V.,Aushev, T.,Aziz, T.,Bahinipati, S.,Bakich, A.M.,Ban, Y.,Bay, A.,Bedny, I.,Bitenc, U.,Bizjak, I.,Bondar, A.,Bozek, A.,Brač,ko, Elsevier 2004 Physics letters: B Vol.599 No.3
<P><B>Abstract</B></P><P>We report the observation of <SUP>B0</SUP> decays to the <SUP>K+</SUP><SUP>π−</SUP><SUP>π0</SUP> final state using a data sample of 78 fb<SUP>−1</SUP> collected by the Belle detector at the KEKB <SUP>e+</SUP><SUP>e−</SUP> collider. With no assumptions about intermediate states in the decay, the branching fraction is measured to be (36.6−4.3+4.2±3.0)×<SUP>10−6</SUP>. We also search for <I>B</I> decays to intermediate two-body states with the same <SUP>K+</SUP><SUP>π−</SUP><SUP>π0</SUP> final state. Significant <I>B</I> signals are observed in the ρ<SUP>(770)−</SUP><SUP>K+</SUP> and <SUP>K*</SUP><SUP>(892)+</SUP><SUP>π−</SUP> channels, with branching fractions of (15.1−3.3−1.5−2.1+3.4+1.4+2.0)×<SUP>10−6</SUP> and (14.8−4.4−1.0−0.9+4.6+1.5+2.4)×<SUP>10−6</SUP>, respectively. The first error is statistical, the second is systematic and the third is due to the largest possible interference. Contributions from other possible two-body states will be discussed. No <I>CP</I> asymmetry is found in the inclusive <SUP>K+</SUP><SUP>π−</SUP><SUP>π0</SUP> or <SUP>ρ−</SUP><SUP>K+</SUP> modes, and we set 90% confidence level bounds on the asymmetry of −0.12<<SUB>ACP</SUB><0.26 and −0.18<<SUB>ACP</SUB><0.64, respectively.</P>
Ahmed K. Abed,Riyadh Mansoor,Ali K. Abed 한국통신학회 2022 ICT Express Vol.8 No.1
Orthogonal Frequency Division Multiplexing (OFDM) is the best choice for wireless and wired high data rate communications. The OFDM system has many advantages such as high spectral efficiency, robustness to channel fading, and immunity to impulse interference. However, it has a main drawback, which is the Peak to Average Power Ratio (PAPR). Selecting Mapping (SLM) and Partial Transmit Sequences (PTS) are the two essential techniques for reducing the PAPR; however, they need to send side information to indicate how the transmitter generates signals. In this paper, Particle Swarm Optimization (PSO)-based dummy sub-carriers are inserted with the data to reduce PAPR without transmitting side information. The incorporation of PSO-based Dummy Sub-carriers Insertion (DSI) method on this system is performed by measuring the PAPR at the IFFT output (Inverse Fast Fourier Transform) after adding 6 adaptive sub-carrier sequences to the input data of IFFT. The PSO-based dummy algorithm decides to send the data once the PAPR of this data sequence and dummy sub-carrier is under a specific threshold. Using MATLAB as a mathematical simulation tool, simulation results are presented for a standard OFDM network model. The network model has been simulated in an Additive White Gaussian Noise (AWGN) channel environment to investigate PAPR and Bit-Error Rate (BER) performance. The simulation results show that the dummy sequence based on PSO reduces PAPR down to 4 dB compared to a conventional OFDM system and down to 3 dB compared with the clipping technique for the same BER performance.
Wang, M.-Z.,Abe, K.,Abe, K.,Abe, T.,Adachi, I.,Aihara, H.,Asano, Y.,Aso, T.,Aulchenko, V.,Aushev, T.,Bakich, A. M.,Bay, A.,Bizjak, I.,Bondar, A.,Bozek, A.,Brač,ko, M.,Browder, T. E.,Chang, M.-C. American Physical Society 2004 Physical Review Letters Vol.92 No.13
<P>We report the first observation of a b-->u type charmless baryonic B decay, B+-->pppi(+), as well as b-->s type B0-->ppK0 and B+-->ppK(*+) decays. The analysis is based on a 78 fb(-1) data sample recorded on the Upsilon(4S) resonance with the Belle detector at KEKB. We find B(B+-->pppi(+))=(3.06(+0.73)(-0.62)+/-0.37)x10(-6), B(B0-->ppK0)=(1.88(+0.77)(-0.60)+/-0.23)x10(-6), and B(B+-->ppK(*+))=(10.3(+3.6+1.3)(-2.8-1.7))x10(-6). We also update B(B+-->ppK+)=(5.66(+0.67)(-0.57)+/-0.62)x10(-6) and present an upper limit on B(B0-->ppK(*0)) at the 90% confidence level. A common feature of the observed decay modes is threshold peaking in baryon pair invariant mass.</P>
Optimal Design Considerations of a Bus Converter for On-Board Distributed Power Systems
Abe, Seiya,Hirokawa, Masahiko,Shoyama, Masahito,Ninomiya, Tamotsu The Korean Institute of Power Electronics 2009 JOURNAL OF POWER ELECTRONICS Vol.9 No.3
The power supply systems, which require low-voltage / high-current output has been changing from the conventional centralized power system to a distributed power system. The distributed power system consists of a bus converter and POL. The most important factor is the system stability in bus architecture design. The overlap between the output impedance of a bus converter input impedance of POL causes system instability and has been an actual problem. By increasing the bus capacitor, the system stability can be easily improved. However, due to limited space on the system board, the increasing of bus capacitors is impractical. An urgent solution of this issue is strongly desired. This paper presents the output impedance design for on-board distributed power system by means of three control schemes of a bus converter. The output impedance peak of the bus converter and the input impedance of the POL are analyzed and then conformed experimentally for stability criterion. Furthermore, the design process of each control schemes for system stability is proposed.
Search for dark matter in the form of hidden photons and axion-like particles in the XMASS detector
Abe, K.,Hiraide, K.,Ichimura, K.,Kishimoto, Y.,Kobayashi, K.,Kobayashi, M.,Moriyama, S.,Nakahata, M.,Ogawa, H.,Sato, K.,Sekiya, H.,Suzuki, T.,Takachio, O.,Takeda, A.,Tasaka, S.,Yamashita, M.,Yang, B.S Elsevier 2018 Physics letters: B Vol.787 No.-
<P><B>Abstract</B></P> <P>Hidden photons and axion-like particles are candidates for cold dark matter if they were produced non-thermally in the early universe. We conducted a search for both of these bosons using 800 live-days of data from the XMASS detector with 327 kg of liquid xenon in the fiducial volume. No significant signal was observed, and thus we set constraints on the <SUP> α ′ </SUP> / α parameter related to kinetic mixing of hidden photons and the coupling constant <SUB> g A e </SUB> of axion-like particles in the mass range from 40 to 120 keV/ <SUP> c 2 </SUP> , resulting in <SUP> α ′ </SUP> / α < 6 × <SUP> 10 − 26 </SUP> and <SUB> g A e </SUB> < 4 × <SUP> 10 − 13 </SUP> . These limits are the most stringent over this mass range derived from both direct and indirect searches to date.</P>
FEM Analysis on Elastic-Plastic Deformation of Perforated Sheets
Abe, Takeji,Nakayama, Yasuhide,Kodama, Akira,Nagaki, Shigeru 대한금속재료학회(대한금속학회) 1998 METALS AND MATERIALS International Vol.4 No.3
The influence of distribution and growth of voids on macroscopic mechanical properties are important issues in the ductile fracture of metals. In the present paper, we consider perforated sheets with regularly distributed holes as a simple model for void containg materials. Elastic-Plastic deformation of perforated sheet, where circular holes are distributed regularly, was analyzed numerically under the plane stress condition by means of finite element method introducing the periodic boundary conditions. It is shown that the deformation behavior depends highly on the distribution and arrangement of holes. This results in anisotropy of yield stresses of perforated sheets, which is related to the stress concentration near the holes. It is also shown that the plastic region in perforated sheets does not develop simply in the direction to adjacent holes.
ABE, Fujiko,OHBUCHI, Yoshifumi,SAKAMOTO, Hidetoshi Korean Society for Engineering Education 2019 공학교육연구 Vol.22 No.5
Folded structure is widely applied in various engineering fields. Many of the Japanese folding fans in the Edo era (1603-1868) have been successfully blended with the processing technology of "natural materials" that is the origin of Japan's "Monodzukuri" (craftsmanship) and its application "artistic originality". The charm of a fan lies in the diversity of stereoscopic expression not born in plane representation. For example, the effects of folds, the expression of the front and back sides flowing from the front to the back by double-sided description, and the two-layer effect of raising the backside from the surface using the permeability of Japanese paper, the calculated depiction are also seen. Moreover, by handling the fan, it also produced an illusion effect which skillfully calculated the change due to movement of the viewpoint. Students experience the natural materials such as Japanese paper, bamboo and starch paste, which are the materials of paint and fan at the time, and processing method, and know the difference with the current one. This study is to verify the effectiveness of engineering education which gains experience by making concrete fans and to understand deeply this traditional technology with the artistry of a Japanese fan at the same time. And we can learn from the characteristics of the fan to Japan's history and culture.