http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
RF 플라즈마에 의해 생성된 산소 플라즈마의 발광 스펙트럼
김도엽,김민수,김태훈,김군식,최현영,조민영,전수민,박성동,김진하,김은도,황도원,임재영,Kim, Do-Yeob,Kim, Min-Su,Kim, Tae-Hoon,Kim, Ghun-Sik,Choi, Hyun-Young,Cho, Min-Young,Jeon, Su-Min,Park, Sung-Dong,Kim, Jin-Ha,Kim, Eun-Do,Hwang, Do-Weon 한국진공학회 2009 Applied Science and Convergence Technology Vol.18 No.2
본 연구에서는 ZnO 박막을 성장하기 위한 plasma-assisted molecular beam epitaxy (PAMBE)에 장착된 플라즈마건에 13.56 MHz의 rf 전력을 인가하였을 때 발생되는 산소 플라즈마의 발광 스펙트럼을 광발광 분광기(optical emission spectroscopy: OES)를 이용하여 조사하였다. 실험은 산소 가스 유량을 1 sccm에서 20 sccm, rf 전력을 25W에서 250 W 범위에서 플라즈마건의 오리피스의 직경을 각각 3 mm 와 5 mm로 달리하여 행해졌다. 산소 플라즈마를 발생시켰을 때 오리피스의 직경에 상관없이 전형적인 산소 플라즈마의 발광 스펙트럼이 관측되었다. 특히 776.8 nm와 843.9 nm에서 $3p^{5}P-3s^{5}S^{0}$, $3p^{3}P-3s^{3}S^{0}$ 천이에 기인하는 강한 산소 원자 발광선이 관측되었다. 산소 유량과 rf 파워가 증가함에 따라 776.8 nm와 843.9 nm의 발광 세기는 증가하였고, 776.8 nm의 스펙트럼 발광 세기의 증가율이 843.9 nm의 스펙트럼 발광 세기 증가율보다 컸다. 또한 오리피스 직경이 3 mm일 때가 5 mm일 때보다 산소 플라즈마가 더 안정적으로 발생하였다. We investigated optical emission of oxygen plasma discharged by 13.56 MHz radio frequency (rf) by using optical emission spectroscopy (OES). Experimental measurement is done at a range of oxygen flow rate of 1$\sim$20 seem, rf power of 25$\sim$250 W, and orifice 3 and 5 mm in diameter. When oxygen plasma was generated, typical emission spectra for oxygen plasma were observed regardless of diameter of orifice. Strong atomic emission lines are observe at 776.8 an 843.9 nm, corresponding to the $3p^{5}P-3s^{5}S^{0}$ and $3p^{3}P-3s^{3}S^{0}$ transitions, respectively. The emission intensity of line at 776.8 and 843.9 nm increased with increasing the oxygen flow rate and rf power. The increasing rate of emission intensity of 776.8 nm line was larger than that of 843.9 nm line. When the diameter of orifice was 3 mm, the oxygen plasma was more stably generated than orifice 5 mm in diameter.
김도엽,이재완,장형진,용부중,Kim, Doyup,Lee, Jaewan,Chang, Hyungjin,Yong, Boojoong 한국자동차안전학회 2011 자동차안전학회지 Vol.3 No.2
Side collisions (or side crash) account for 51.6% of all car to car accidents occurred in 2010. It is necessary to analyze those vehicles' structure deformation and passengers' injuries in the side collisions. A moving barrier (950kg) is currently used in the KNCAP side impact test. However, in order to enhance a passengers' safety in the side collisions, we introduce an AE-MDB (1500kg) which provides more severe conditions for this test. In this study, the test results using both barriers are compared and analyzed.
합성 조건이 분무열분해 공정에 의해 합성되는 Co<sub>3</sub>O<sub>4</sub> 분말의 특성에 미치는 영향
김도엽,주서희,구혜영,홍승권,강윤찬,Kim, Do-Youp,Ju, Seo-Hee,Koo, Hye-Young,Hong, Seung-Kwon,Kang, Yun-Chan 한국재료학회 2006 한국재료학회지 Vol.16 No.1
[ $Co_3O_4$ ] particles with non-aggregation characteristics were prepared by various conditions such as preparation temperature, flow rate of carrier gas, and concentration of spray solution using spray pyrolysis. The morphology and crystallinity of the preformed particles obtained by spray pyrolysis at various conditions affected the mean size and morphology of the post-treated $Co_3O_4$ particles. The preformed particles with hollow and porous morphology obtained from spray solution with citric acid and ethylene glycol turned to $Co_3O_4$ particles with nano size, regular morphology and non-aggregation characteristics after post-treatment at $800^{\circ}C$. On the other hand, the preformed particles obtained by the preparation conditions of short residence time of particles inside hot wall reactor and high reactor temperature turned to $Co_3O_4$ particles with aggregated morphology after post-treatment. The mean crystallite size and particle size of the $Co_3O_4$ particles prepared from optimum preparation conditions were 47 nm and 210 nm at post-treatment temperature of $800^{\circ}C$.
김도엽,Sung-O Kim,김민수,임광국,임재영,김소아람,남기웅,이동율 한국물리학회 2012 THE JOURNAL OF THE KOREAN PHYSICAL SOCIETY Vol.60 No.1
The authors used a sol-gel method to deposit Al-doped ZnO (AZO) thin films on Si substrates and a hydrothermal method to grow ZnO crystals on the as-prepared AZO seed layers. Though the crystallinity of the seed layers was enhanced by Al doping, for Al doping up to 3 at.%, the full width at half maximum (FWHM) of the ZnO (002) diffraction peak increased, resulting in a decrease in the average grain size. The intensity of the ZnO (002) diffraction peak of ZnO crystals grown on AZO seed layers increased as the Al doping concentration was increased to 1.0 at.%. The narrowest FWHM in the photoluminescence spectrum, 132 meV was obtained at an Al doping concentration of 1.0 at.%. These results indicate that the structural and the optical properties of ZnO crystals grown on seed layers can be enhanced by introducing a small amount of an Al dopant into the seed layers.
AE-MDB를 이용한 측면충돌안전성 평가시 인체상해 특성에 관한 연구
김도엽(DoYup Kim),장형진(HyungJin Chang),이창석(Changseok Lee),김창현(Changhyun Kim),이재완(JaeWan Lee),김규현(GyunhYun Kim) 한국자동차공학회 2012 한국자동차공학회 부문종합 학술대회 Vol.2012 No.5
The domestic car to car accident Perpendicular to side car crash in a car accident case, the proportion was the highest. Safety regulations and New Car Assessment Program tests to ensure safety in side impacts tend to strengthen regulatory requirements. Side Pole Impact of the road, trees and utility pole, etc. aspects of vehicle side impact crash tests and more intensive deformation and impact energy after the collision mitigation occurs due to a lack of space and will cause fatal injury to the driver. Being studied in this paper AE-MDB side impact test and Side Pole test change the body injury results data analysis and evaluation methods KNCAP hatch side impact applied to the phase comparison should investigate.
김도엽 ( Do Yeob Kim ),정봉진 ( Bongjin Jeong ),윤조호 ( Joho Yun ),박춘상 ( Choon-sang Park ),배규태 ( Gyu Tae Bae ),태흥식 ( Heung-sik Tae ),이형근 ( Hyung-kun Lee ) 한국물환경학회 2020 한국물환경학회·대한상하수도학회 공동 춘계학술발표회 Vol.2020 No.-
마이크로시스티스 (microcystis) 및 아나베나 (anabaena), 오실라토리아 (oscillatoria), 아파니조메논 (aphanizomenon)과 같은 유해남조류에 의해서 발생하는 녹조현상 (algal bloom)의 주된 원인으로 지목되는 부영양화 (eutrophication)의 정도 관리를 위해서는 인 또는 질소와 같은 영양물질과 클로로필-a 등의 부영양화 지표에 대한 주기적인 모니터링이 필요하다. 현재는 호소·하천의 인 정량분석을 위해서 시료를 현장에서 채수한 후 수질자동측정기기 또는 원격지 (실험실)에서 다양한 형태로 존재하는 인을 용존무기인 (PO<sub>4</sub><sup>3-</sup>)으로 분해시키는 화학적 전처리를 진행하고, 시료의 발색 반응에 의한 흡광도 측정법을 주로 이용하고 있다. 하지만, 이러한 분석 방법은 화학물질 사용으로 인한 환경 영향성뿐만 아니라 고가의 시설 투자비용 및 운전비용 등의 문제점이 있다. 이에 본 연구에서는 친환경적이며, 저가의 비용으로 현장에서 실시간으로 용존총인 농도 모니터링이 가능한 경·소형 분석 시스템에 대해 보고한다. 해당 분석 시스템은 필터, 마이크로 펌프, 밸브 등의 부품을 포함하며, 자동·반복적으로 시료 취·배수 동작이 가능하다. 또한, 유·무기 화합물 형태의 용존총인을 산화 분해하기 위해서 기존의 화학적 전처리 방법 대신 상압 플라즈마를 이용한 전처리 기술을 도입함으로써 처리비용과 시간을 획기적으로 줄일 수 있으며, 이온선택성전극을 이용하여 단시간에 용존총인 농도 분석이 가능하다.