http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
DCI 시스템에서 코일 배치에 따른 성능 특성에 대한 수치해석 연구
최광돈,우수형,권영명,최민기 한국자동차공학회 2023 한국 자동차공학회논문집 Vol.31 No.9
In this study, numerical analysis was conducted to investigate the performance characteristics of a DCI system according to the coil arrangement. An analysis was carried out to develop the DCI system through numerical analysis research. Unlike the ignition system of a gasoline engine, which typically consists of a single coil, the DCI system used in this study consists of two coils. This system increases combustion stability in lean burn by using high ignition energy and various ignition control strategies. Since the DCI system uses two ignition coils, the magnetic fields formed around the coils can influence each other when they are used simultaneously, even if primary coil input conditions remain the same. Therefore, with the use of numerical analysis models, the differences in performance characteristics according to the placement of the two coils will be studied and utilized in the control strategy of the DCI system.
최광돈,이종현,손병기,신종욱,Choi, Kwang-Don,Lee, Jong-Byung,Sohn, Byung-Ki,Shin, Jong-Ug 대한전자공학회 1988 전자공학회논문지 Vol. No.
Porous실리콘 形成反應에서 HF濃度, 電流應度, 反應時間 및 基叛의 表面狀態가 PSL (Porous Silicon Layers)의 porosity에 미치는 影響을 실험적으로 조사하였다. PSL을 陽배化 시켜서 室溫에서 FIPPOS-SOI를 제조하는 방법을 연구하였다. 이 방법으로 100um폭의 SOI strip line을 제조하였으며 SOI의 stress제거를 위해 2단계 PSL 형성법을 이용하였다. 또한 이 실온 SOI 제조기술을 이용하여 이미 소자공정을 끝낸 집적회로를 SOI화 시킬 수 있는 방법을 제안하였다. An experimental study of the influences of HF concentration, current density, reaction time and the silicon surface, on the formation and properties of porous silicon are reported. The SOI (Silicon-On-Insulator) strip lines with 100 um width are fabricated at room temperature by anodic oxidation of PSL (Porous Silicon Layers). The stress on the silicon island induced by the anodic oxidation can be avoided by the two-step PSL formation technique. At the final step of IC fabrication process, device isolation will be achieved at room temperature by this method.
OFDM 시스템에서 PAPR의 감소를 위한 사전-스크램블링 기법의 성능분석
최광돈,김시철,박상규 한국통신학회 2004 韓國通信學會論文誌 Vol.29 No.5A
OFDM(Orthogonal Frequency Division Multiplexing)은 주파수 이용 효율을 높이고 고속의 데이터 전송이 가능하며 주파수 선택적 페이딩에 강한 전송 방식이지만, 다수 부반송파(sub-carrier)들의 중첩현상으로 인해 전송 신호의 PAPR(Peak to Average Power Ratio)이 크다는 문제점이 있다. 본 논문에서는 PAPR의 감소와 PAPR의 연산량 감소를 위해, PAPR간 분석을 통하여 상관기를 도입하는 사전-스크램블링 기법을 제안한다. 모의실험을 통해 제안한 기법과 기존의 PTS(Partial Transmit Sequence) 기법의 CCDF(Complementary Cumulative Distribution Function)간을 비교하여 복잡도를 크게 줄이면서도 PAPR를 낮출 수 있음을 보여준다. OFDM is a very attractive technique for achieving high-bit-rate data transmission and high spectrum efficiency. However, one of disadvantages of OFDM signal is the high PAPR characteristic when multi-carriers are added up coherently. In this Paper, we propose-scrambling scheme using correlator for PAPR reduction and reducing the amount of PAPR calculations. The simulation results show that this scheme has less computational complexity and reasonable PAPR reduction capability compared to PTS technique.
최적 송신전력 할당을 이용한 준직교성 시공간 블록부호의 복호화 성능
최광돈,김봉준,조영하,박상규,Choe Kwang don,Kim Bong joon,Cho Young ha,Park Sang kyu 한국통신학회 2005 韓國通信學會論文誌 Vol.30 No.4A
송신다이버시티 시스템에 사용되는 시공간 블록부호(space time block code)는 송신안테나가 2개보다 많은 경우 최대 전송률과 최대 다이버시티 이득을 동시에 제공할 수 없다. 송신안테나가 4개인 경우 최대 전송률을 제공하면서 간섭을 최소화하는 준직교성 블록부호가 있다. 최근에는 준직교성에 의해 발생하는 블록부호의 간섭을 제거하는 단순상관제거 알고리즘이 제안되어 최대전송률과 최대 다이버시티 이득을 얻을 수 있게 되었다. 본 논문에서는 신호의 전송전력을 다르게 할당하고 수신단에서의 빼기 연산에 의한 간단한 간섭제거로 잡음 증가 없이 성능을 개선하는 복호화 과정을 제안한다. The space time block code(STBC) can not provide simultaneously both full diversity and full transmission rate in a transmit diversity system having more than two transmit antennas.. There are a quasi orthogonal STBC for four transmit antennas that provides full transmission rate and minimized interference. Recently, a simple correlation canceling algorithm is introduced to achieve full diversity from STBC considering four transmit antennas. In this paper, we propose a new decoding procedure using the power allocation at the transmitter and subtraction interference process at the receiver to achieve a better performance without noise enhancement.