http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
분극 엔지니어링을 통한 상시불통형 질화알루미늄갈륨 이종접합 전계효과 트랜지스터 설계
차호영,성혁기,Cha, Ho-Young,Sung, Hyuk-Kee 한국정보통신학회 2012 한국정보통신학회논문지 Vol.16 No.12
본 연구에서는 기존의 질화알루미늄갈륨/질화갈륨 이종접합 구조에서 강한 분극현상으로 인하여 구현하기 어려웠던 상시불통형 소자를 질화알루미늄갈륨 기판 혹은 버퍼층을 이용하여 구현하는 방법을 제안한다. 질화알루미늄갈륨 기판 혹은 버퍼층 위에 더 높은 Al 몰분율을 갖는 장벽층을 성장하고 최상부에 질화갈륨 층을 추가 성장하여 분극전하를 상쇄시키는 방법을 이용하여 선택적으로 게이트 아래의 채널만 공핍시켜 상시불통형 소자를 구현할 수 있다. 이를 통하여 본 연구에서는 상용 전력소자에서 요구하는 게이트 문턱전압 2 V 이상을 갖는 질화알루미늄갈륨 이종접합 전계효과 트랜지스터 에피구조를 제안한다. In this study, we propose a novel structure based on AlGaN substrate or buffer layer to implement a normally-off mode transistor that was difficult to be realized by conventional AlGaN/GaN heterojunction structures. The channel under the gate can be selectively depleted by growing an upper AlGaN barrier with a higher Al mole fraction and a top GaN charge elimination layer on AlGaN substrate or buffer layer. The proposed AlGaN heterojunction field effect transistor can achieve a threshold voltage of > 2 V, which is generally required in power device specification.
차호영(Ho Yeong Cha),옥정(Jeung Ok) 한국발달지원학회 2020 발달지원연구 Vol.9 No.2
본 연구는 ADHD 청소년을 대상으로 증상교육 프로그램을 개발하고 그 효과성을 검증하는 것을 목적으로 하였다. 연구대상은 서울 소재 청소년 정신재활시설을 이용하는 청소년 33명(12-15세, 남자 27명, 여자 6명)으로 ADHD 진단을 받고 약물을 복용하고 있는 임상군이다. 참여자를 대상으로 프로그램의 전과 후에 ADHD에 대한 인식 및 태도의 변화와 학교 및 가정 상황에서의 문제행동에 대해 평정하고, 단일집단 사전사후 설계로 대응표본 t검증과 Cohen’s d를 이용하여 효과크기를 검증하였다. 분석한 결과 본 프로그램에 참여한 청소년들은 시행 전과 비교하여 시행 후 ADHD에 대한 인식과 태도가 통계적으로 유의한 수준에서 긍정적으로 향상되는 것으로 나타났다. 이를 바탕으로 ADHD 청소년을 대상으로 한 증상교육 프로그램이 긍정적인 결과를 얻었음을 알 수 있으며, 표본집단을 늘려 증상교육 프로그램을 실시하여 추후 그 효과와 중요성을 재차 검증할 필요가 있다. The purpose of this study is to develope a symptom education program for ADHD clinical group adolescents and to verify its effectiveness. The study was conducted in 33 adolescents (12-15 years old, 27 males, 6 females) who are using mental rehabilitation facilities for adolescents in Seoul. Participants were evaluated for ADHD perception and attitude before and after the program, and the effect size was verified using t-test and Cohen s d as a single group pre-post design. As a result of analysis, the adolescents who participated in this program showed a statistically significant increase in perception and positive attitude toward ADHD after the program compared to before the program. Based on this, it can be seen that the symptom education program for the ADHD clinical group has obtained positive results, and it is necessary to revalidation the effectiveness and importance of the symptom education program by increasing the sample population.
차호영(Hoyoung Cha),전창현(Changhyun Jun),이진욱(Jinwook Lee),백종진(Jongjin Baik) 한국방재학회 2023 한국방재학회논문집 Vol.23 No.2
본 연구에서는 월별 풍향과 풍속 데이터를 이용하여 대기오염 측정망에 대한 적절성 평가를 수행했다. 이를 위해 먼저, 2020년의 Air Quality Monitoring system (AQMs)에 대한 위·경도를 이용하여 가장 가까운 기상관측소를 파악했다. 다음, 가장 가까운 기상관측소에서 2010년부터 2021년까지 측정한 풍향과 풍속 데이터를 AQMs에 적용했다. 마지막으로 대기오염 영향각과 영향거리를 변동시키면서 대기오염 영향범위가 그려져 있는 지도를 제작했다. 다양한 조건을 변동시키면서 지도에 표시한 대기오염 영향범위의 형태를 살펴본 결과, 강원도에 대기오염 영향범위가 속하지 않는 지역이 존재했다. 전체 면적에 대한 영향범위에 속하지 않은 면적의 비율은 대기오염 영향각 및 대기오염 영향거리와 반비례관계를 가지고 있음을 보여주었으며, 다양한 조건에서 최소 0.01%부터 최대 48.86%까지 나타났다. 이를 통하여, 대기오염 측정소를 추가로 설치할 수 있는 위치를 고려할 수 있을 것으로 판단된다. 또한, 영향범위에 속하지 않은 면적의 비율은 대기오염 측정소의 추가 설치에 대한 여부의 기준으로 고려될 수 있다는 것으로 기대된다. In this study, we suggested a methodology for evaluating the appropriateness of an air quality network using monthly wind direction and speed. First, the nearest weather station was identified using the latitude and longitude of the Air Quality Monitoring system (AQMs) in 2020. Next, the wind direction and wind speed data measured by the nearest weather station from 2010 to 2021 were applied to AQMs. Finally, a map with the range of air pollution influence was produced while varying air pollution influence distance and air pollution influence angle. On varying conditions, there were consistent areas in Gangwon-do that were without a range of air pollution influence. The percentage of areas without a range of air pollution influence in entire areas called percentage by non-measurement. The results derived are as follows: it showed that the percentage by non-measurement had an inverse relationship with the air pollution influence angle and distance, then it was from 0.01% to 48.86% for each condition. The method could propose additional AQMs locations based on the range of air pollution influence. The results indicate that the proportion of areas excluded from the impact range of air pollution should be considered when establishing regulations for additional installation of air quality monitoring systems.
최적화 기법을 적용한 매체 이송 시스템의 이송속도 및 비틀어짐 제어기의 이득값 결정
차호영(Ho-Young Cha),범선호(Sun-Ho Bum),김민수(Min-Soo Kim),이순걸(Soon-Geul Lee) 대한기계학회 2009 大韓機械學會論文集A Vol.33 No.6
In this paper, we made a simple paper feeding system which is one of MTS (media transport system) and controllers. The plant has a flexible paper and two driving rollers and two driven rollers. The control system has two conventional PID controllers. Skew angle and feeding speed of MTS deteriorate the quality of feeding system. In order to control a feeding speed and skew of feeding paper, we control rotational velocity of two driving rollers. Therefore, this controller has two inputs and two outputs as MIMO (multi-input and multi-output) system. The control inputs were the feeding speed and the skew displacement of the paper. The control outputs were the rotational velocity to each driving roller. To find appropriate PID gains of two controllers, we proposed an optimization technique. We assume the system variables and performance of a whole system as follows. PID gains of two controllers for skew and feeding speed are system variables. System performance is both skew and feeding speed. We simulates to making mathematical correlation using global Kriging interpolation. To find appropriate value of system variables, optimization method is simulation in sequence as following method. First, the optimization solver simulates with DOE (design of experiment) tables to find correlation equation of both system variable and performances. Then, the solver guesses the appropriate values and simulates if the system variables are appropriate or not. If the result of validation doesn’t satisfy the convergence and iteration tolerance, the solver makes a new Kriging models and iterates this sequence until satisfy the tolerances.