http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Kai, X.Z.,Li, Z.Q.,Fan, G.L.,Guo, Q.,Xiong, D.B.,Zhang, W.L.,Su, Y.S.,Lu, W.J.,Moon, W.J.,Zhang, D. Elsevier Sequoia 2013 Materials science & engineering. properties, micro Vol.587 No.-
Reinforcement agglomeration always leads to severe stress concentration and porosity, which is detrimental to the deformation ability and mechanical properties of particulate-reinforced metal matrix composites. In this study, uniform distribution of 32vol%B<SUB>4</SUB>C has been achieved in B<SUB>4</SUB>C/Al composite by means of flake powder metallurgy (Flake PM), in which flake Al powder is used as the starting material. The flake Al powder exhibits higher apparent volume than spherical powders of the same mass, and thus can provide more space to accommodate the B<SUB>4</SUB>C particles. Therefore, compared with conventional PM, Flake PM can lead to more uniform distribution of B<SUB>4</SUB>C particles in the composite powder as well as in the consolidated composite. Meanwhile, the flake Al powder has a nano skin of Al<SUB>2</SUB>O<SUB>3</SUB>, which could be fractured and dispersed inside the fine matrix grains during consolidation, and were found to induce a higher normalized strain hardening rate for the composite during deformation. As a result, the Flake PM 32vol%B<SUB>4</SUB>C/Al composite exhibits an ultimate tensile strength of 305MPa and a uniform elongation of 6.6%, 63% stronger and 13% more ductile than its counterpart fabricated by conventional PM.
Loss-Separation Study on Silica-insulated Gas-atomized Fe-Si-Al Soft Magnetic Composites
T. T. Xu,B. W. Zhang,Z. Shi,W. W. Guan,K. Wan,X. Y. Shi,W. Liu,H. L. Su,Z. Q. Zou,Y. W. Du 한국자기학회 2020 Journal of Magnetics Vol.25 No.2
Fe-Si-Al soft magnetic composites were composed of gas-atomized Fe-9.6wt.%Si-5.4wt.%Al alloy powders insulated with silica nanoparticles. The influence of silica insulation content on the core’s magnetic properties was studied. It was found that increasing the silica mass ratio deteriorated the effective permeability and core loss in the frequency range of 40-120 kHz, while improved the quality factor at 100 kHz and DC-bias performance. The effective demagnetizing field reflected by density and the core’s volume resistivity may cause the variations of these magnetic parameters. Loss separation fitting was performed using the Bertotti formula, indicating that silica insulation increased the hysteresis loss and reduced the eddy-current loss. The hysteresis loss took over at the frequency lower than 120 kHz in this work. With increasing the frequency, the eddy-current loss grew more quickly than the hysteresis loss. Therefore, different methods should be adopted to reduce the core loss according to the core’s application frequency.