바이오매스를 이용한 농업용 난방계획의 경제성 검토

홍성구,Hong, Seong-Gu 한국농공학회 2005 한국농공학회논문집 Vol.47 No.2

Biomass is one of the most competitive renewable energy resource and can be used for heating for rural applications. A economic assessment was made of biomass heating, using the tool BIOH2000 from $RETScreen^{\circledR}$ International Clean Energy Decision Support Centre. For a 260kW heating system for 50 farm houses, the assessment showed a very promising results. Internal rate of return was $19.7\%$ and year-to-positive cash flow was 5.1 years. Relative price of biomass over fossil fuel significantly affected the economic feasibility of the project. Heating demand was directly related to annual demand of biomass and economic feasibility. Relative cost of distribution pipe over the total initial costs also affected the economic feasibility of the project. The economic feasibility was expected to be improved by the probable greenhouse emission reduction credit and reduction of initial costs through utilizing existing heating system for peak or back up heating system.

경기 남부지역 풍력자원의 평가와 농업분야 활용방안

홍성구,Hong, Seong-Gu 한국농공학회 2006 한국농공학회논문집 Vol.48 No.3

Wind energy is one of the promising renewable energies that could provide electricity and other mechanical power. Wind energy market is dramatically growing in many European countries, but wind power is only 0.2% of the total renewable energy uses that is only about 2% of the primary energy consumption in Korea. It is widely accepted that wind resources fur power generation are only limited in some areas including coastal regions and mountainous areas in Gangwon province in Korea, particularly in terms of large scale wind power developments. In this study, wind velocity data were analyzed with respect to the potential utilization. The data provided from National Weather Service were used for the analysis. In addition, field wind data were also collected and analyzed for the comparison between the national data. The comparison showed that there were significant differences between the experimental station and the national station that are about 5km away. Annual average wind speed at the experimental station was less than 2 m/s, which is not enough fur wind power generation. It seemed that the topographic condition resulted in a significant difference in wind speed. When 600 W and 2.5 kW wind turbines were used, annual power productions were only 186 kWh and 598 kWh, respectively. When the average wind speed is lower, wind pumping is an alternative use of wind. At the experimental station, the average pumping rate of $3m^3/h$ at the head of 3 m was expected at a 2.5 m rotor under the conditions that efficiencies of the rotor and the pump were 40% and 80%, respectively. It did not seem that the wind pumping was not applicable at the station either. A higher wind speed was required to install the wind machines. Meanwhile, wind pumping would be applicable in conditions with lower pumping heads. Other applications were introduced far further wind energy utilization, including wind powered ventilation and friction heat generation in greenhouses.

316L 스테인리스 강의 고온 저주기 피로 수명식 개발

홍성구,이순복,Hong, Seong-Gu,Lee, Soon-Bok 대한기계학회 2002 大韓機械學會論文集A Vol.26 No.3

In this paper, tensile behavior and low cycle fatigue behavior of 316L stainless steel which is currently favored structural material for several high temperature components such as the liquid metal cooled fast breeder reactor (LMFBR) were investigated. Research was performed at 55$0^{\circ}C$, $600^{\circ}C$ and $650^{\circ}C$ since working temperature of 316L stainless steel in a real field is from 40$0^{\circ}C$ to $650^{\circ}C$. From tensile tests performed by strain controls with $1{\times}10^{-3}/s,\; l{\times}10^{ -4}/s \;and\; 1{\times}10/^{ -5}/ s $ strain rates at each temperature, negative strain rate response (that is, strain hardening decreases as strain rate increases) and negative temperature response were observed. Strain rate effect was relatively small compared with temperature effect. LCF tests with a constant total strain amplitude were performed by strain control with a high temperature extensometer at R.T, 55$0^{\circ}C$, $600^{\circ}C$, $650^{\circ}C$ and total strain amplitudes of 0.3%~0.8% were used and test strain rates were $1{times}10^{-2} /s,\; 1{times}10^{-3} /s\; and\; 1{times}10^{-4} /s$. A new energy based LCF life prediction model which can explain the effects of temperature, strain amplitude and strain rate on fatigue life was proposed and its excellency was verified by comparing with currently used models.

풍건 목편을 이용한 합성가스 생산에 대한 실험적 고찰

홍성구,왕용,Hong, Seong-Gu,Wang, Long 한국농공학회 2011 한국농공학회논문집 Vol.53 No.6

Biomass gasification provides synthesis gas or syngas that can be used for internal combustion engines as fuel or chemical synthesis as feedstock. Among different types of gasifiers, downdraft gasifier can produce relatively clean syngas with lower tar contents. In this study, a downdraft gasifier was fabricated with 150 mm of hearth diameter to gasify woodchip that is commercially available in this country. After drying woodchip to about 20 %, gasification experiments were conducted measuring temperature, pressure, air and gas flow rates. The volumetric concentrations of CO, $H_2$, $CO_2$, $CH_4$ were 10.7~14.5, 16.5~21.4, 12.5~16.6, and 2.3~2.9, respectively. They were overall within the ranges of the results that the previous studies showed. However, CO concentration was relatively lower and H2 was slightly higher than those from other studies. It seemed that water gas shift reaction was occurred due to the moisture in the fuel woodchip. Additional drying process coupled with syngas cooling would be required to improve the overall efficiency and syngas quality.

Carbon Monoxide Consumption in Digestate and its Potential Applications

홍성구,Hong, Seong-Gu The Korean Society of Agricultural Engineers 2009 한국농공학회논문집 Vol.51 No.2

Acetogen과 같은 일부 혐기성미생물은 소위 acetyl-CoA 경로에 의해 아세트산, 에탄올, 그리고 몇 가지 생화학 물질을 생산한다. 이 경로에서는 일산화탄소를 기질로 이용할 수 있다. 일산화탄소 이외에 수소가 이용될 수 있다. 즉 이들 미생물은 독립영양생물로서 이산화탄소와 태양광에너지를 이용하는 녹색식물과 비유될 수 있으며, 일산화탄소는 탄소원으로서 동시에 에너지원으로서 이용된다. 본 연구에서는 혐기성 소화액 중 아세트산을 생성하는 미생물이 존재한다고 가정하고, 일산화탄소와 수소가 주 가연성분인 합성가스를 공급하면 추가의 메탄이 생성가능성을 평가하였다. 혐기성 소화과정에서 발생되는 메탄은 주로 아세트산으로부터 만들어지므로 일산화탄소를 공급하는 경우 추가로 메탄이 생성될 것으로 추측할 수 있기 때문이다. 이를 확인하기 위하여 현재 운영중인 바이오가스 생산 설비로부터 얻은 혐기성 소화액을 생물반응조에 넣은 후, 합성가스를 순환-공급하여 가스 생산량의 변화 및 조성을 분석하였다. 질소가스를 공급한 대조구와는 달리 일산화탄소 또는 합성가스를 공급한 경우에는 메탄가스가 생산되는 것을 확인하였다. 질소가스를 공급한 대조구와는 달리 일산화탄소 또는 합성가스를 공급한 경우에는 메탄가스가 생산되는 것을 확인하였다. 일산화탄소만을 공급했을 때에는 이산화탄소의 생성으로 가스 생산량이 증가하였으나, 수소가 포함된 합성가스를 공급하였을 때에는 이산화탄소가 탄소원이로 소비되어 가스 저장도 내의 가스량이 감소하는 것을 확인할 수 있었다. 가스화공정에 으해 얻어지는 합성가스는 온도와 가스 조성을 고러할 때, 바이오가스 생산을 위한 혐기성 소화조와 연계하면 소화조의 가온에 필요한 열을 공급할 수 있고 바이오가스 중 이산화탄소 농도를 낮추어 발열량을 개선할 수 있을 것으로 판단된다.

에너지수지를 고려한 혐기성소화시설의 운영방안

홍성구,권순국,Hong, Seong-Gu,Kwun, Soon-Kuk 한국농공학회 2008 한국농공학회논문집 Vol.50 No.4

Anaerobic digestion system is getting more attractive in that it produces biogas in the process of organic waste stabilization. Net energy production is important when biogas production is concerned. In this study, net energy production was evaluated with respect to biogas production and heat losses in a hypothetical digester. Under the condition of digester operation with slurry inflow of 5% of TS, additional fuel is required to maintain digester temperature during the winder season. Substrate therefore, needs to have higher VS contents through co-digestion of silage or food waste that has greater values of methane production rate. Heating input slurry is important in cold season, which covers over 80% of heating requirement. Heat recovery from digestate is valuable to reduce the use of biogas for heating. It seems desirable to minimize slurry inflow when temperature is very low. Psychrophilic digestion may be a feasible option for reducing heating requirement.

생물자원의 효율적 이용과 개발을 위한 농공학(지역운영공학전공)

홍성구,Hong, Seong-Gu 한국농공학회 2007 韓國農工學會誌 : 전원과 자원 Vol.49 No.1

열역학적 평형모델을 이용한 바이오매스 연료조건에 따른 합성가스 조성의 예측

홍성구,Hong, Seong-Gu 한국농공학회 2015 한국농공학회논문집 Vol.57 No.1

A thermochemical equilibrium model was constructed for predicting composition of synthesis gas in biomass gasification. The model included estimation of equilibrium constants using Gibbs free energy. After constructing the model, the results were compared with the experimental values and predictions from a previous model. Gas compositions were reasonably well agreed with them and showed effects of operational and fuel condition. When the reaction temperature increased, the lower heating values decreased due to the decrease in CH4 concentrations. The methane concentrations were lower than those observed in experimental results. The model was used to predict the gas composition and heating values for the cases of mixed fuel of charcoal and un-dry woodchips. Although downdraft gasifiers require fuels less than 15% of moisture contents, the model results indicated that the mixed fuel with charcoal and woodchips which had over 25% of moisture contents could be used in the downdraft gasifiers. It might be explained by increase in energy density resulting from mixing charcoal. The results imply that the efforts and costs for drying biomass fuels could be reduced by mixing charcoal or fuels with higher calorific values.

수리모형 실험에 의한 선박 부착형 오탁방지막의 거동특성 구명

홍성구,강구,Hong, Seong Gu,Kang, Ku 한국농공학회 2012 한국농공학회논문집 Vol.54 No.6

Silt curtains are constructed for minimizing pollution of sediment dispersion in water bodies. In spite of wide uses of the silt curtains, there are few studies for analyzing the effectiveness of them with respect to their dimension and hydraulic characteristics. Currently, the market of silt curtains does not provide the various dimension of them due to the limit of information regarding its effectiveness on reducing sediment pollution. In this study, a series of experiments were conducted to investigate hydraulic characteristics around the silt curtains under the different flow conditions. For this study, a silt curtain was fabricated and an open channel with 30cm of width and 40cm of depth was used. The results indicated that the silt curtain was not effective in preventing dispersion at flow velocities over 0.5m/s in real conditions. Based on the experimental results, it is required that approaching velocity should be minimized and the weight of bottom be increased in order to reduce deformation. The results of this study will provide information required to design appropriate dimension of silt curtains in various water environment such as velocity and water depths.

농촌지역 바이오매스 에너지 보급 활성화 전략 - 시설재배 난방을 중심으로 -

홍성구,Hong, Seong Gu 한국농공학회 2015 한국농공학회논문집 Vol.57 No.6

The demand of renewable energy is expected to grow in the long run in spite of current stable lower oil prices. Energy consumption for heating in horticulture greenhouse is large and affects the profits of the farms. This study analyzed the availability of biomass in rural area and proposed the strategies for utilizing the biomass for greenhouse heating. Data reveal the annual average fuel consumption in greenhouses is about 78 TOE/ha. Considering biomass resource in rural areas, agricultural residues are not sufficient to meet the biomass demand from greenhouses. Therefore it is recommended to secure further biomass including wild herbaceous biomass and woody biomass from forest. Based on the conditions of biomass gasification equipment investment and fuel prices, maximum allowable price of biomass turned out about 100,000 KRW/t to be competitive to kerosine. Biomass supply chain should be established for facilitating biomass trading between biomass consumers and biomass producers such as farmers who provide crop residues. An online trading system is an example of the system where consumers who utilize biomass make payments to suppliers and get the information about the biomass. Intermediate collection storages are required to store biomass from distributed sources. Operation of biomass heating systems in demonstration greenhouses is necessary to get information to refine and further develop commercial biomass heating systems. Relatively large greenhouses are desirable to have biomass heating systems for economic viability. The location of the greenhouse farms should be selected within the area where enough biomass resources are available for feeding the biomass facility.