http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Van Hoang, Nguyen,Hung, Chu Manh,Hoa, Nguyen Duc,Van Duy, Nguyen,Park, Inkyu,Van Hieu, Nguyen Elsevier Sequoia 2019 Sensors and actuators. B Chemical Vol.282 No.-
<P><B>Abstract</B></P> <P>Cost-effective fabrication of sensors and detection of ultralow concentrations of toxic gases are important concerns for environmental monitoring. In this study, the reduced graphene oxide (RGO)-loaded ZnFe<SUB>2</SUB>O<SUB>4</SUB> nanofibers (ZFO-NFs) were fabricated by facile on-chip electrospinning method and subsequent heat treatment. The multi-porous NFs with single-phase cubic spinel structure and typical spider-net morphology were directly assembled on Pt-interdigitated electrodes. The diameters of the RGO-loaded ZFO-NFs were approximately 50–100 nm with many nanograins. The responses to H<SUB>2</SUB>S gas showed a bell-shaped behaviour with respect to RGO contents and annealing temperatures. The optimal values of the RGO contents and the annealing temperatures were found to be about 1.0 wt% and 600 °C, respectively. The response of the RGO-loaded ZnFe<SUB>2</SUB>O<SUB>4</SUB> NFs to 1 ppm H<SUB>2</SUB>S gas was as high as 147 at 350°C while their cross-gas responses to SO<SUB>2</SUB> (10 ppm), NH<SUB>3</SUB> (100 ppm), H<SUB>2</SUB> (250 ppm), C<SUB>3</SUB>H<SUB>6</SUB>O (1000 ppm), and C<SUB>2</SUB>H<SUB>5</SUB>OH (1000 ppm) were rather low (1.8−5.6). The high sensor response was attributed to formation of a heterojunction between RGO and ZnFe<SUB>2</SUB>O<SUB>4</SUB> and due to the fact that NFs consisted of many nanograins which resulted in multi-porous structure and formation of potential barriers at grain boundaries.</P> <P><B>Highlights</B></P> <P> <UL> <LI> rGO-loaded ZnFe<SUB>2</SUB>O<SUB>4</SUB> nanofibers have simply prepared by electrospinning. </LI> <LI> rGO-loaded ZnFe<SUB>2</SUB>O<SUB>4</SUB> nanofiber sensors can detect H<SUB>2</SUB>S gas down to ppb level. </LI> <LI> The loading rGO can result in an enhancement of H<SUB>2</SUB>S gas ensing performance. </LI> </UL> </P>
Nguyen Van Hieu,Le Thi Ngoc Loan,Nguyen Duc Khoang,Nguyen Tuan Minh,Do Thanh Viet,Do Cong Minh,Tran Trung,Nguyen Duc Chien 한국물리학회 2010 Current Applied Physics Vol.10 No.2
In this paper, a very simple procedure was presented for the reproducible synthesis of large-area SnO2nanowires (NWs) on a silicon substrate by evaporating Sn powders at temperatures of 700, 750, and 800 ℃. As-obtained SnO2 NWs were characterized by field emission scanning electron microscopy (FESEM),transmission electron microscopy (TEM), X-ray diffraction (XRD), and Raman spectroscopy. They revealed that the morphology of the NWs is affected by growth temperature and the SnO2 NWs are single-crystalline tetragonal. The band gap of the NWs is in the range of 4.2–4.3 eV as determined from UV/visible absorption. The NWs show stable photoluminescence with an emission peak centered at around 620 nm at room-temperature. The sensors fabricated from the SnO2 NWs synthesized at 700 ℃ exhibited good response to LPG (liquefied petroleum gas) at an operating temperature of 400 ℃.
Nguyen Van Hieu,Nguyen Bich Ha,V. P. Gerdt,O. Chuluunbaatar,A. A. Gusev,Yu. G. Palii,Nguyen Van Hop 한국물리학회 2008 THE JOURNAL OF THE KOREAN PHYSICAL SOCIETY Vol.53 No.6
The Kondo and the Fano resonances in the two-point Green’s function of the single-level quantum dot were found and investigated in many previous works by means of different numerical calculation methods. In this report, we present a derivation of the analytical forms of the resonance terms in the expression of the two-point Green’s function. For that purpose, the system of Dyson equations for the two-point nonequilibrium Green’s functions in the complex-time Keldysh formalism was established to the second order in the tunneling coupling constants with the mean field approximation for the statistical averages of the products of four electron creation and destruction operators. This system of Dyson equations was solved exactly by means of the computer algebra and the analytical expressions for the resonance terms are derived. The conditions for the existence of the Kondo or the Fano resonances were found.
Determinants Influencing Housing-Option Decision of Gen Y: The Case of Vietnam
Ha Thu LUONG(Ha Thu LUONG ),Dung Manh TRAN(Dung Manh TRAN ),Dan Linh Ngoc NGUYEN(Dan Linh Ngoc NGUYEN ),Van Bao NGUYEN(Van Bao NGUYEN ),Anh Thuc LE(Anh Thuc LE ),Hieu Van PHAM(Hieu Van PHAM ) 한국유통과학회 2023 유통과학연구 Vol.21 No.7
Nguyen Ngoc-Viet,Van Manh Hoang,Van Hieu Nguyen 한국유변학회 2022 Korea-Australia rheology journal Vol.34 No.4
Circulating tumor cells (CTCs) detection has become one of the promising solutions for the early diagnosis of cancers. Thus, the separation of CTCs is of great importance in biomedical applications. In addition, microfluidic technology has been an attractive approach to the manipulation of biological cells. This study presents the parametric investigations relevant to the volumetric throughput of a microfluidic platform with the dielectrophoresis (DEP)-based cell manipulation technique for the continuous CTCs separation. A low potential voltage at an appropriate frequency was applied to slanted planar electrodes to separate CTCs from normal cells in blood samples due to mainly the cell size difference. The performance of the separation process was analyzed by evaluating the cell trajectories, purity, and recovery rates. Several inlet flow rates of buff er and cell sample fluid streams were examined. Various channel configurations with different outlet and height dimensions were also investigated to enhance the isolation of CTCs. During the simulation, the size and shape of cells were assumed as fixed-sized, solid spheres. The results showed that CTCs could be separated from blood cells, including white blood cells (WBCs), red blood cells (RBCs), and platelets (PLTs) with recovery and purity factors up to 100% at the cell sample throughput of 10 μL/ min by utilizing a suitable microchannel design. The current study significantly contributes valuable insights into the design of the microchip devices to effectively and selectively isolate different cancerous cells in biofluids.
Nguyen Duc Cuong,Tran Thai Hoa,Dinh Quang Khieu,Nguyen Duc Hoa,Nguyen Van Hieu 한국물리학회 2012 Current Applied Physics Vol.12 No.5
The development of a low cost and scalable gas sensor for the detection of toxic and flammable gases with fast response and high sensitivity is extremely important for monitoring environmental pollution. In this work, we introduce two different synthesis pathways for the preparation of scalable Fe2O3nanoparticles for gas sensor applications. One is co-precipitation and the other is hydrothermal method. The gas sensing properties of the a-Fe2O3 nanoparticles (NPs) fabricated by different synthesis pathways were studied and compared. The performance of the NPs in the detection of toxic and flammable gases such as carbon dioxide, ammonia, liquefied petroleum gas, ethanol, and hydrogen was evaluated. The Fe2O3 NP-based gas sensors exhibited high sensitivity and a response time of less than a minute to analytic gases. However, the NPs fabricated by the one-step direct method exhibited higher sensitivities than those generated by the a-Fe2O3 NPs obtained by co-precipitation synthesis possibly because of their nanoporous structure. This performance is attributed to the large specific surface area of the NPs, which results in higher sensitivity. The development of a low cost and scalable gas sensor for the detection of toxic and flammable gases with fast response and high sensitivity is extremely important for monitoring environmental pollution. In this work, we introduce two different synthesis pathways for the preparation of scalable Fe2O3nanoparticles for gas sensor applications. One is co-precipitation and the other is hydrothermal method. The gas sensing properties of the a-Fe2O3 nanoparticles (NPs) fabricated by different synthesis pathways were studied and compared. The performance of the NPs in the detection of toxic and flammable gases such as carbon dioxide, ammonia, liquefied petroleum gas, ethanol, and hydrogen was evaluated. The Fe2O3 NP-based gas sensors exhibited high sensitivity and a response time of less than a minute to analytic gases. However, the NPs fabricated by the one-step direct method exhibited higher sensitivities than those generated by the a-Fe2O3 NPs obtained by co-precipitation synthesis possibly because of their nanoporous structure. This performance is attributed to the large specific surface area of the NPs, which results in higher sensitivity.
Nguyen Van Hieu,Vu Van Quang,Nguyen Duc Hoa,김도진 한국물리학회 2011 Current Applied Physics Vol.11 No.3
The large-scale nanowire-like (NW) structure of tungsten oxide is synthesized by the deposition of tungsten metal on the substrate of porous single-wall carbon nanotubes (SWCNTs) film, followed by thermal oxidation process. The morphology and crystallinity of the synthesized materials are analyzed by SEM, TEM, XRD, and Raman spectroscopy. Results showed that tungsten oxide NWs deposited on SWCNTs have a porous structure with an average diameter of about 70 nm and a length of up to micrometers. The NH3 gas-sensing properties of tungsten NWs were measured at different temperatures. A maximum response of 9.7―1500 ppm at 250 ℃ with rapid response and recovery times of 7 and 8 s are found,respectively. In addition, the gas sensing mechanism of fabricated NWs is also discussed in term of surface resistivity and barrier height model.
Van Hoa, Nguyen,Quyen, Tran Thi Hoang,Nghia, Nguyen Huu,Van Hieu, Nguyen,Shim, Jae-Jin Elsevier 2017 Journal of alloys and compounds Vol.702 No.-
<P><B>Abstract</B></P> <P>Hierarchical flower-like V<SUB>2</SUB>O<SUB>5</SUB> growth on graphene and nickel foam electrodes was fabricated by using chemical vapor deposition and hydrothermal methods for electrochemical capacitors. Taking advantages of the high conductivity of graphene, high capacitance of well-defined V<SUB>2</SUB>O<SUB>5</SUB> flower-like structure and open framework of three-dimensional nickel foam, the resulting electrodes exhibited rapid electron and ion transport, large electroactive surface area, and excellent structural stability. The specific capacitance was as high as 1235 F g<SUP>−1</SUP> at a current density of 2 A g<SUP>-1</SUP>, suggesting its potential as a high performance electrode for supercapacitors.</P> <P><B>Highlights</B></P> <P> <UL> <LI> Hierarchical flower-like V2O5/graphene/nickel foam electrodes was fabricated. </LI> <LI> The electrodes exhibited rapid electron and ion transport, large electroactive surface area. </LI> <LI> The specific capacitance was as high as 1235 A g−1 at a current density of 2 A g−1. </LI> </UL> </P> <P><B>Graphical abstract</B></P> <P>[DISPLAY OMISSION]</P>
Nguyen Thi Thuy,Phuong Dinh Tam,Mai Anh Tuan,Anh-Tuan Le,Le Thi Tam,Vu Van Thu,Nguyen Van Hieu,Nguyen Duc Chien 한국물리학회 2012 Current Applied Physics Vol.12 No.6
The present paper introduces a facile and cost-effective route for the direct dispersion of multi-walled carbon nanotubes (MWCNTs) in DNA solution. Their application in detecting Escherichia coli O157:H7using DNA biosensorwas demonstrated. The dispersion state of theMWCNTswas characterized via UVeVis spectroscopy, transmission electron microscopy, and field emission scanning electron microscopy. The interaction between DNA sequence and the MWCNTs was investigated using Raman spectroscopy and Fourier transform infrared spectroscopy. As-obtainedMWCNT solutionwas used in the preparation of DNA sensor. Results revealed that the developed DNA sensor can detect a DNA target as low as 1 nM in a buffer solution. The sensitivity of the DNA sensor reached approximately 0.19 nM/mV. The effect of dispersion parameters, including pH values, DNA concentration, ion strength, and sonication time, on sensor response was also studied. TheDNA sensor can respondwell to 120 min of sonication time, a pH value of 9, and 20 mM of DNA sequence concentration. The results of the present study showed a potential application of the DNA sensor in the detection of Escherichia coli O157:H7.