http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
UV경화에 의한 폴리우레탄/유기화클레이 나노복합재료 제조와 물성 연구
신금식 ( Geum Sig Shin ),장영욱 ( Young Wook Chang ),김성우 ( Seong Woo Kim ) 한국접착및계면학회 2012 접착 및 계면 Vol.13 No.4
Polyurethane (PU)/organoclay nanocomposites were prepared by mixing UV curable urethane acrylate oligomer with organoclay, and a subsequent curing by UV irradiation. As organoclays, commercially available Cloisite 20A (C20A) and acrylsilane modified C20A were used. XRD and TEM analyses revealed that the UV cured PU/clay nanocomposites formed intercalated nanocomposites, and acrylsilane modified C20A are dispersed more finely than unmodified C20A in PU matrix. DMTA, pencil hardness and adhesion test onto PET substrate showed that the clay nanolayers induced an increase in the properties, and the enhancement in the properties was more pronounced in the PU/acrylsilane modified C20A nanocomposites than in the PU/unmodified C20A nanocomposites. It was also observed that the PU/surface modified clay nanocomposites showed remarkably lower shrinkage upon UV curing than the unfilled PU. The nanocomposites showed excellent optical transparency but lower gloss as compared to unfilled PU. UV 경화형 우레탄아크릴레이트 수지와 유기화클레이를 혼합한 후 UV를 조사하여 경화시킴으로써 폴리우레탄-클레이 나노복합체를 제조하였다. 유기화클레이로서는 Closite20A (C20A) 및 이를 실란처리하여 표면에 아크릴기를 도입한 아크릴변성 C20A를 사용하였다. XRD와 TEM 분석으로부터 제조된 나노복합체는 삽입형 나노복합체이며, 아크릴 변성시킨 C20A가 변성시키지 않은 C20A에 비해 더 잘 분산되는 것을 알 수 있었다. DMTA, 연필경도분석, PET 필름에의 부착성 시험으로부터 클레이 첨가에 의해 유리전이온도와 저장탄성률 및 연필경도가 증가하고 PET 필름에의 부착성이 향상되며, 이러한 물리적 특성의 증가는 아크릴 변성시킨 C20A를 함유한 나노복합체에서 더 크게 발현됨을 알 수 있었다. 또한, 클레이 첨가에 의해 UV경화 시 수반되는 수축을 저하시킬수 있음을 알았다. 한편, 제조된 나노복합체는 우수한 광투과도를 나타내었으나, 광택도는 나노입자를 함유하지 않은 경우에 비해 다소 저하되었다.
최종원,신금식,이문규 한국전자파학회 2004 한국전자파학회논문지 Vol.15 No.4
본 논문에서는 5.8 ㎓주파수 합성기에 대해 하모닉 발진을 적용하여 저가화 방안을 제안하였다. 제안한 주파수 합성기는 2.9 ㎓대역의 PLL 칩과 2.9 ㎓대역의 발진기, 그리고 5.8 ㎓대역의 버퍼 증폭기로 구성되어있다. 측정 결과는 5.65 ㎓에서 5.94 ㎓까지의 290 MHz주파수 가변범위와 약 0.5 ㏈m의 출력 전력, 그리고 100 KHz 오프셋 주파수에서 -107.67 ㏈c/Hz의 위상잡음을 보여준다. 기본 발진 전력(2.9 ㎓)을 포함한 모든 불요성분은 제안한 2차 하모닉 신호보다 적어도 15 ㏈c 이상 억압된다. A low cost solution employing harmonic oscillation to the frequency synthesizer at 5.8 ㎓ is proposed. The proposed frequency synthesizer is composed of 2.9 ㎓ PLL chip, 2.9 ㎓ oscillator, and 5.8 ㎓ buffer amplifier The measured data shows a frequency Outing range of 290 ㎒, ranging from 5.65 to 5.94 ㎓ about 0.5 ㏈m of output power, and a phase noise of -107.67 ㏈c/㎐ at the 100 ㎑ offset frequency. All spurious signals including fundamental oscillation power(2.9 ㎓) are suppressed at least 15 ㏈c than the desired second harmonic signal.
초광대역 응용 시스템을 위한 L밴드 전압제어발진기 설계
구본산,신금식,장병준,류근관,이문규,Koo Bonsan,Shin Guem-Sik,Jang Byung-Jun,Ryu Keun-Kwan,Lee Moon-Que 한국전자파학회 2004 한국전자파학회논문지 Vol.15 No.9
본 논문에서는 TV set-top tuner용으로 사용할 수 있는 옥타브 밴드를 갖는 전압제어 발진기를 설계하였다. 측정 결과, 주파수 튜닝 범위는 0.9 GHz~2.2 GHz로써 1.3 GHz의 발진 대역을 갖는다. 광대역 튜닝과 선형성, 그리고 일정한 위상 잡음 성능을 유지하기 위해 트랜지스터의 베이스와 에미터부에 모두 4개의 배랙터 다이오드를 사용한 것이 특징이다. 개발된 전압제어발진기는 0 V~20 V의 제어 전압과 10 V, 15 mA의 공급 전력을 필요로 한다. 출력 전력은 5.3 dBm을 중심으로 약 $\pm$1.1 dB의 편차를 갖고, 위상 잡음은 전 발진 대역에서 -94.8 dBc/Hz @ 10 kHz offset 이하의 값을 보인다. 선형성은 평균적으로 65 MHz/V이고 $\pm$10 MHz의 편차를 보인다. In this paper an octave tuning voltage controlled oscillator which is used in set-top TV tuner was designed. Oscillation frequency range is 0.9 GHz~2.2 GHz with 1.3 GHz bandwidth. By using 4 varactor diodes in base and emitter of transistor, wide-band tuning, sweep linearity and low phase noise could be achieved. Designed VCO requires a tuning voltage of 0 V ~ 20 V and DC consumption of 10 V and 15 mA. Designed VCO exhibits an output power of 5.3 dBm $\pm$1.1 dB and a phase noise below -94.8 dBc/Hz @ 10 kHz over the entire frequency range. The sweep linearity shows 65 MHz/V with a deviation of $\pm$10 MHz.