http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
미세먼지입자의 정전기력 부여에 따른 여과집진의 성능특성에 관한 연구
정진도,김진철,정관호 호서대학교 반도체제조장비국산화연구센터 2000 학술대회 자료집 Vol.2000 No.1
일반적으로 에어로졸 상의 고체입자에 대한 분리기술은 크게 전기집진기술과 여과집진기술, 습식기술 등으로 나눌 수 있다. 최근 연료의 탈황으로 인해 배출되는 먼지의 비저항성이 높아져 전기집진기술의 효율이 크게 떨어져 여과집진기술로 조금씩 대체되어가고 있다. 그러나 여과집진기술의 경우, Flow Gas 포집기작의 영향이 지배적이지 못한 1㎛ 미만의 입자들에 대한 제어가 효과적이지 못한 단점이 있다. 본 연구에서는 이러한 1㎛ 미만의 입자들에 대해 정진기력을 부여해서 전기적응집에 의한 입자성장을 유도하여 여과집진시에 필터 표면에 Dendrites Structure를 형성하게끔 유도하여 ΔP 증가율을 낮추고자 한다. 이에 따른 직접적인 효과는 탈진회수의 감소로 탈진시 소요되는 동력비의 감소와 탈진시 마모나 파손되는 여과포의 수명연장으로 실제 산업공정에 적용시 운전유지비의 감소효과를 꾀할 수 있을 것으로 사료된다.
Emulsion(B.C유+폐수)연료의 연소효율에 관한 실험적 연구
정진도 한국에너지학회 2003 에너지공학 Vol.12 No.4
Emulsion 연료는 연료절감과 오염방지특성에 의하여 많은 관심을 끌고 있다. 본 연구에서는 B-C유와 Emulsion 연료(B-C유와 폐수를 혼합하여 만든 연료)의 연소효율을 비교 분석하였다. 보일러의 양쪽에 R-Type Thermocouple과 광학온도계를 설치하였고, 연소가스배출구에 연소측정기를 설치하여 B-C유와 Emulsion 연료의 연소시 화염의 온도, 연소율 및 배기가스 농도를 측정 비교하였다. 이에 대한 실험 결과로서, 보일러 전$.$후반부의 화염온도는 B-C유의 화염온도보다 약 5$0^{\circ}C$ 낮았고, 이러한 온도차이의 원인은 Emulsion 연료의 폐수 속 수분 잠열로 인한 것으로 사료되어진다. 또한 Emulsion연료를 사용하였을 때 배출가스의 분석 결과는 오염물질의 같소 및 CO 농도 또한 매우 낮게 측정되어짐을 나타내고 있다. 3-C유와 Emulsion 연료의 연소 효율은 각각 85.5%와 84.8%이다. Emulsion fuel is a very attractive fuel because of its energy saving and pollution prevention properties. We investigated and compared the combustion efficiency of B-C oil and emulsion fuel i.e. fuel made from the mixture of B-C oil and waste water. By installing an R-type thermocouple and an optical pyrometer on each side of the boiler, and by placing a combustion analyzer at the point of gas emissions, We were able to measure and compare each flame temperature, combustion rate and the concentration of emitted gas when B-C oil and emulsion fuel are burned. The following results were obtained: The flame temperature of emulsion fuel at the front and rear of the boiler is about 50$^{\circ}C$ lower than the flame temperature of B-C oil. The reason for this difference in temperature is that both latent and sensible heat is lost due to the moisture in the waste water of emulsion fuel. An analysis of emitted gases shows that when emulsion fuel is used polluting substances decrease also the concentration of CO becomes considerably lower. The combustion efficiency for B-C oil and emulsion fuel is 85.5% and 84.8% respectively.
정진도,김장우,배영필,Chung, Jin-Do,Kim, Jang-Woo,Bae, Young-Peel 대한환경공학회 2010 대한환경공학회지 Vol.32 No.1
본 연구의 목적은 대형 석탄 화력 발전소에 DSI (Dry Sorbent Injection)공정을 실제 적용 할 경우에 실현 가능성에 대한 연구로서 N 발전(주)의 S 화력발전본부에서 운용중인 500MW급 석탄화력 발전시설의 보일러 후단에서 전기 집진기 전 단까지를 모델로 삼아 Lab-scale 실험장치를 제작하여 탈황효율을 높이기 위한 실험을 수행하였다. 이를 위하여 Lobedplate와 Step-plate라는 혼합촉진장치를 고안하고 각각 형상을 달리하여 궁극적으로 탈황효율을 높이기 위한 혼합촉진장치의 최적 형상도출을 위한 실험을 수행하였으며 부수적으로 탈황제의 분사구의 개수에 따른 탈황효율 또한 분석하였다. 그 결과 혼합촉진장치가 설치된 경우가 더 높은 탈황 효율을 나타내었고 형상에서는 계단형상일 경우 가장 높은 탈황효율을 보였다. 또한, 탈황제의 분사구의 개수에 따른 탈황효율은 혼합 촉진 장치가 설치되지 않은 경우, 분사구의 개수가 증가할수록 높은 탈황 효율을 보였으나 혼합촉진장치가 설치된 경우는 분사구의 개수가 4개일 경우가 이론적 결과와 같이 가장 높은 탈황효율을 나타내었다. The aim of this study is to research applicable possibility of DSI (Dry Sorbent Injection) technique in $SO_2$ removal process using lab-scale facility based on 500MW in capacity coal-fired thermal power plant operated by South Korea N. Power Co., Ltd. To increase the $SO_2$ removal efficiency, it is considered the mixing enhancement as different shapes called lobed-plate and stepplate tested ultimately for optimum shape. Also it tested to analysis $SO_2$ removal efficiency by numbers of injection holes. At experimental it showed the $SO_2$ removal efficiency is higher using mixing enhancement than not installed mixing enhancement and case on the step-plate was shown the most $SO_2$ removal efficiency. Also, $SO_2$ removal efficiency was higher recording which will increase the injection holes case on not installed mixing enhancement. But, the $SO_2$ removal efficiency was higher 4 injection holes case on installed mixing enhancement.
공간정보 오픈플랫폼 수출을 위한 해외 국가 유형별 진출전략 수립에 관한 연구
정진도,한선희,이재용 한국지도학회 2014 한국지도학회지 Vol.14 No.2
세계 공간정보 인프라 환경은 급격하게 플랫폼 기반으로 변화하고 있으며, 우리나라가 구축 완료한 공간정보 오픈플랫폼은 세계 각국의 공간정보 인프라 구축을 위한 대안이 될 수 있다. 다만 수출 대상 시장을 확장하고 수출 대상 국가에 성공적인 공간정보 인프라를 구축하기 위해서는 각 국의 국가 특성에 적합한 수출 전략의 마련이 선행되어야 한다. 이를 위해 본 연구에서는 국가 특성을 반영하는 다양한 대리변수들에 대한 전문가 AHP 조사 및 통계 분석을 통해 진출 대상 국가의 우선순위를 산정하였으며, 진출 대상 국가를 각각의 특성에 따라 5개의 범주로 분류하였다. 또한 이를 기초로 하여 수출 전략 수립을 위한 이론적 기반을 제시하였으며, 이론적 기반을 토대로 5개 국가 분류 각각에 대한 공간정보 오픈플랫폼 수출 전략을 제시하였다. World geospatial infrastructure environment has changed dramatically to platform-based over the past years. So our Spatial Information Open Platform is a good alternative to establish geospatial infrastructure of overseas countries. But suitable export strategies of Spatial Information Open Platform for each country must take precedence over all others in order for new market creation and successful geospatial infrastructure establishment. To achieve this, this study set priority target countries through the AHP and statistics of variables which reflect the characteristics of countries, and classify them into five groups by characteristic. Based on this classification, the study draws theoretical framework to establish export strategies, and it also leads to suggest Spatial Information Open Platform export strategies for each class.