http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
다중 안테나를 이용한 직교 부호 도약 다중화 시스템의 성능향상
정방철,이우재,박연식,전성근,Jung, Bang-Chul,Lee, Woo-Jae,Park, Yeoun-Sik,Jeon, Seong-Keun 한국정보통신학회 2011 한국정보통신학회논문지 Vol.15 No.10
직교부호 도약 다중화기술(Orthogonal Code Hopping Multiplexing)은 CDMA기반 이동통신시스템에서 가용한 직교부호의 수보다 많은 수의 사용자를 수용하기 위해 제안된 통계적다중화기반 하향링크 기술이다. 본 논문에서는 최근 다양한 이동통신시스템에 제안되고 있는 다중안테나 기술인 MIMO기술을 사용하여 기존의 직교부호 도약 다중화기술의 성능을 향상시키는 기술을 제안한다. 각 변조된 심벌은 N번 반복되고 반복된 기 심볼은 N개의 송신 안테나로 동시에 전송된다. 반복을 통하여 기존 직교부호 도약 다중화 기술에서 제기되었던 천공(Perforation)의 영향은 반복된 심볼로 분산된다. 반복된 모든 심볼이 모두 천공될 확률은 급격히 줄어드는 것을 확인할 수 있다. 본 논문에서는 시뮬레이션을 통하여 다중안테나를 이용하여 기존의 직교부호 도약 다중화기술이 가지고 있던 단점이 보상될 수 있음을 보인다. An orthogonal code hopping multiplexing (OCHM) technique has been proposed for accommodating a large number of users with low channel activities than the number of orthogonal codewords through statistical multiplexing in downlink cellular systems. In this paper, a multiple input multiple output (MIMO) antenna based OCHM system is proposed to improve the performance. Each modulated symbol is repeated N times and the N repeated symbols are transmitted simultaneously using N transmit antennas. Through repetitions, the effect of perforations that the OCHM system experiences is decentralized among the repeated symbols and the full perforation probability is significantly reduced. Each receiver detect the transmitted signal using its pre-assigned code hopping pattern. Simulation results show that the proposed scheme saves the required energy for a given frame error rate (FER).
이남기,이문수,전성근 국립경상대학교 공과대학 부설 첨단소재연구소 1992 尖端素材 Vol.2 No.-
A stripline holder is desinged and fabricated in order to measure complex permittivity (??) and permeability (??) simultaneously over a broad band. ?? and ?? are computed from S - parameter (S₁₁ and S₂₁) measurements made on a stripline sample holder loaded with the material under test. Measured ?? and ?? data for teflon and polyethylene are relatively accurate over the 0.5 GHz - 5.5 GHz band.
全聖根,朴承模,李文秀,鄭宗哲 慶尙大學校 工科大學 自動化및컴퓨터應用技術硏究所 1994 自動化 및 컴퓨터應用技術 Vol.1 No.1
An X-band highly frequency-stabilized MIC Gunn oscillator using a dielectric resonator is fabricated. Resonant frequency is obtained by a variational method and it is studied how the oscillating characteristics can be affected by several factors. By the optimizing these factors, we can realize the stabilized oscillator output of 250 mW with 5-7 percent efficiency at 10 GHz. It has the favorable characteristics with frequency variation of 70 KHz/℃ and the output variation within 3 dB over the temperature range from 0 to 70 ℃.
李鍾龍,全聖根 國立統營水産專門大學 附設 水産科學硏究所 1992 수산과학연구소보고 Vol.3 No.-
接地된 인닥턴스의 simulator를 두개의 演算增幅器를 가진 回路로 구성하고 回路解析과 誤差分析 및 設計節次에 대해 기술했다. 이 回路는 增幅器의 利得을 디지탈로 制御하므로서 인닥턴스의 값을 可變시킬 수 있고 사용 周波數 범위내에서는 理論値에 대한 最大誤差가 3%였다. 그러므로 이 回路는 낮은 주파수 범위에서 精度가 높은 可變인탁터로서 적합하다. A circuit with two amplifiers for simulation of grounded inductance is given. The inductance can be controlled digitally or manually, by the gain of one of the amplifier, while the quality factor is constant. The influence of the real amplifier parameters is considered. The circuits for linear digital control are given, analyzed and experimented.