http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Cascade 방식을 이용한 순환곱셈코드의 시스템 설계
김신령,강창언 대한전자공학회 1985 전자공학회지 Vol.22 No.5
본 논문에서는 random 및 burst 에러를 동시에 정정할 수 있는 순환 곱셈 로드를 실현하였다. 우선 두 코드의 곱을 실현하는 방법을 제시하였고, (7, 4)순환 Hamming 코드와 (3,1)순환 꼬드를 이용하여 실제로 하드웨어를 구현하였다. 시스템은 인코더와 디코더 그리고 인터줴이스 회로로 구성하였고 마이크로 컴퓨터를 이용하여 실험을 하였다. 인코더는 각 부 코드의 인로더에 지연 소자만 넣어 실현하였고, 디로더는 가장 간단한 디로딩 방식인 에러 trapping 디코더를 cascade 연결하여 실현하였다. 본 연구의 결과로서 이 순환 곱셈 코드는 디로딩이 쉽고, 4개의 random 에러와 burst 길이 8인 에러를 정정할 수 있으며, 성능은 일반 순환 코드보다 102∼103 정도 좋음을 알 수 있었다. In this paper, the cyclic product codes which are capable of correcting random erros and burst errors simultaneously have been designed and constructed. First, the procedure for product of two cyclic codes is shown and thin the encoder and decoder system using the (7,4) cyclic Hamming code and the (3,1) cyclic code is implemented. The micro-computer is used for experiment and the system consists of encoder, decoder and interface circuits. The encoder of cyclic product code is implemented by interlacing encoders while the decoder is implemented by cascading decoders that interlace error trapping decoders. In conclusion, cyclic product codas are easily decodable and are capable of correcting four random errors and eight-burst errors. Better performance is obtained with low error rate.
김신령,최연석,강창언 한국통신학회 1990 韓國通信學會論文誌 Vol.15 No.4
본 논문에서는 효율적인 오류제어를 위하여 유한 버퍼용량을 갖는 SR ARQ방식과 (127, 119) 순환해밍코드를 결합한 하이브리드 ARQ 시스템을 설계하고 왕복지연시간 N이 7인 경우에 대하여 컴퓨터시뮬레이션을 수행하여 제안한 시스템의 동작을 확인하였으며 시스템성능을 분석하였다. 시뮬레이션 결과 재전송신호에 오류가 발생한 경우에도 재전송버퍼를 2N으로 함으로써 오류없이 원하는 신호를 찾아내었고, 수신단에서는 오류정정 및 검출을 하여 수신자에게 오류가 없는 데이터를 전달함을 알 수 있었다. 시스템의 성능분석은 채널오유율에 따른 전송효율에 대하여 이루어졌다. In this paper, the hybrid ARQ system involving the single error correcting and double error detection (127, 119) cyclic Hamming codes and the SR(selective repeat) ARQ schemes with a finite receiver buffer has been designed and constructed. The system performance has been analyzed and simulated. As a result of the simulation, it has been shown that the transmitter retransmitted those data blocks that were detected in errors especially the request signal errors using two retransmission. The system performance was measured by throughput efficiency due to channel error effects.
시스템 효율성 증대를 위한 그리드 컴퓨팅 기반의 위험 관리 시스템
정재훈,김신령,김영곤 한국인터넷방송통신학회 2016 한국인터넷방송통신학회 논문지 Vol.16 No.1
본 논문은 경제급전 최적화 문제에 균형-교환 방법을 제안하였다. 제안된 알고리즘은 모든 발전기를 가능한 한 밸브지점으로 운영한다고 가정한다. 초기치로 최대 발전량 로 설정하고, 각 발전기의 밸브지점 까지 발전량을 감소시켰을 때의 평균 발전단가 가 최대가 되는 발전기 의 발전량을 밸브지점 발전단가 로 감소시켰으며, 이면 의 발전기 발전량을 로 감소시켜 의 균형을 맞추었다. 다음으로, 의 범위에 대해 ”-10“ 간격으로 감소시키는 성인걸음법으로, 범위에 대해서는 ”-1“의 아기걸음법으로, 에 대한 이면 , 로 발전량을 교환하는 방법으로 최적화를 수행하였다. 다음으로 에 대해 미세한 교환을 수행하였다. 동적 경제급전 문제의 시험사례에 제안된 알고리즘을 적용한 결과 기존의 휴리스틱 알고리즘 최적화 발전비용을 크게 감소시켜 경제적인 이익을 극대화 시켰다. This paper proposes a balance-swap method for the dynamic economic load dispatch problem. Based on the premise that all generators shall be operated at valve-points, the proposed algorithm initially sets the maximum generation power at . As for generator with , which is the maximum operating cost produced when the generation power of each generator is reduced to the valve-point , the algorithm reduces ’s generation power down to , the valve-point operating cost. When , it reduces the generation power of a generator with of to so as to restore the equilibrium . The algorithm subsequently optimizes by employing an adult-step method in which power in the range of is reduced by 10; a baby step method in which power in the range of is reduced by 1; and a swap method for of , in which power is swapped to , . It finally executes minute swap process for . When applied to various experimental cases of the dynamic economic load dispatch problems, the proposed algorithm has proved to maximize economic benefits by significantly reducing the optimal operating cost of the extant Heuristic algorithm.