http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
김현영,이성배,임철홍,이권섭,정용현,이종성,한정희,전윤석,황호순,이용묵 한국산업위생학회 2003 한국산업보건학회지 Vol.13 No.1
The CrO3 mostly used in plating. metal surface disposal, leather, cosmetic manufacturing, as an experiment material by repeatedly inhaling and exposure the male S.D. rats at a 0.00, 0.2., 0.50, 1.25 mg/㎡ concentration(particle size: 0.5-0.5 aerosol)6hours a day, 5day a week in 13weeks comparing with 2weeks, 8weeks of recovery group about the noxiousness of the experiment animal and the reduce scale of the CrO3 in the internal organ especially in blook and respiratory organ with the period of convalescent and clearance. The experiment results which we received are as follows. 1. In blood the RBC, HGB and HCT experiment, rats with 0.20, 0.50 mg/㎡ concentration showed that there were some decreases but not dependent. The kidneys absolute weight compared with control group was reduced intentionally(p〈0.05) and the lungs absolute weight compared with control group showed intentional increase(p〉0.05). 2. After the exposure of the experiment material, the whole blook, l\blood plasma and red blood cell in blood by (x): the period of convalescent, per (y); the decreasing of Cr concentration, was y=66.51 e -0.057x, y=67.2 e-0.101x, y=70.01 e-0.030 in 0.50 mg/㎡ exposure concentration by calculating the clearance coefficient of correlation, and the half life (day)was estimated 12.0, 6086, 23.0 each. 3, After the exposure of the experiment material, the experiment animals lung, liver and kidneys by(x); the period of convalescent, per (y); the decreasing of Cr conentration, was y=1808 e-0.00493x, y=12.02e-0.0297x, y=67.61 e-0.0292x in 0.50mg/㎡ exposure concentration by calculating the clearance coefficient of correlation, and the half life(day)was estimated 140.6, 23.3, 23.7, each, and including lung, liver with all of the experiment internal organs, the Cr clearance decreased as the exposure concentration increased.
백서에서 치아이동 후 보정기간 동안 교합이 치주조직섬유의 재형성에 미치는 영향
정권희,박영준,이기헌,황현식 대한치과교정학회 2003 대한치과교정학회지 Vol.33 No.2
본 연구는 실험적 치아이동 후 보정기간 동안 교합이 치주조직섬유의 물리적 강도에 미치는 영향을 알아보고자 시행되었다. 체중 200g 내외의 Sprague-Dawley계 백서 수컷에서 상악 양측 제1대구치와 2대구치 사이에 교정용 고무줄을 삽입하여 4일 동안 치아를 이동시킨 다음, 각 실험동물의 하악 좌측 베1, 2, 3대구치를 발치하여 우측은 대합치가 있는 교합측으로, 좌측은 비교합측으로 구분하였다. 상악 제1대구치와 2대구치 사이의 인접면에 유지구를 형성하고 광중합형 레진으로 채워 보정을 시행한 후 시작 0일, 4일, 8일, 12일, 16일 또는 20일 경과한 후 백서를 희생시킨 다음, 만능물성 시험기를 이용하여 상악 제1대구치를 발치할 때 필요한 최대인장강도를 측정 좌우간 비교 분석하여 다음과 같은 결과를 얻었다. 1. 교합측은 비보정군에서 보정 4일, 8일, 12일, 16일, 20일군으로 갈수록 최대인장강도사 증가하였고, 보정 12일군 이후부터 통계적으로 유의한 차이를 보였다(p<0.05). 2. 비교합측은 비보정군에서 4일, 8일, 12일, 16일, 20일군으로 갈수록 최대인장강도가 증가하는 경향을 보였으나 통계적으로 유의한 차이를 보이지 않았다(p<0.05) 3. 교합측과 비교합측의 최대인장강도를 비교한 결과 보정 8일군까지 통계적으로 유의한 차이를 보이지 않았으나 (p>0.05), 보정 12일군 이후 보정 20일군까지 통계적으로 유의한 차이를 보였다(p<0.05). 이상의 결과는 실험적 치아이동 후 보정기간 동안 교합이 치주조직 섬유의 재형성에 영향을 미침으로 보정장치의 선택, 기간설정 등 보정계획서 교합에 대한 고려가 필요함을 시사하였다. The purpose of this study was to valuate the effect of occlusion on the mechanical strength of periodontal fibers during retention periods after experimental tooth movement. In the Sprague-Dawley male rats weighing 200g or more, the intraoral elastics were inserted into the both right and left interproximal space between upper first and second molars for tooth movement. After 4 days later, the left lower first, second, and third molars were extracted for differentiating the non-occlusal side from the occlusal side in the same mouth. At the same time the elastics were removes and than light cured resin was placed in the space between upper first and second molard following undercut was made for retention bilaterally. From the beginning of retention, 7 rats were sacrificed at 0, 4, 8, 12, 16, 20 days respectively. For evaluating of magnitude on the mechanical strength of periodontal tissue, the maximal shear load of the upper first molars were measured bilaterally during extraction using Instron Universal Testing Machine. The results of this study were obtained as follows : 1. In the occlusal side, the maximal shear load was increased from no retention to retention 20 days group as time was going and statistically difference was shown from retention 12 days group (p<0.05). 2. In the non-occlusal side, the maximal shear load was increased slightly from no retention 20 days group as time was going but there was no statistically difference (p>0.05) 3. The result compared with the maximal shear load between occlusal and nonocclusal side showed no statistically difference until retention 8 day group (p>0.05), but showed statistically difference from retention 12 day to 20 day group (p<0.05). These results show that occlusion had an effect on mechanical strength of the periodontal fibers during retention periods after experimental tooth movement; therefore, it is suggested that occlusion should be considered while the retainer types and retention period are planned.
Hwang, Yeong-Hyeon,Hwang, Inchan,Cho, Won-Ju American Scientific Publishers 2014 Journal of Nanoscience and Nanotechnology Vol.14 No.11
<P>The influence of composition ratio on the bipolar resistive switching behavior of resistive switching memory devices based on amorphous indium-gallium-zinc-oxide (a-IGZO) using the spin-coating process was investigated. To study the stoichiometric effects of the a-IGZO films on device characteristics, four devices with In/Ga/Zn stoichiometries of 1:1:1, 3:1:1, 1:3:1, and 1:1:3 were fabricated and characterized. The 3:1:1 film showed an ohmic behavior and the 1:1:3 film showed a rectifying switching behavior. The current-voltage characteristics of the a-IGZO films with stoichiometries of 1:1:1 and 1:3:1, however, showed a bipolar resistive memory switching behavior. We found that the three-fold increase in the gallium content ratio reduces the reset voltage from -0.9 to - 0.4 V and enhances the current ratio of high to low resistive states from 0.7 x 10(1) to 3 x 10(1). Our results show that the increase in the Ga composition ratio in the a-IGZO-based ReRAM cells effectively improves the device performance and reliability by increasing the initial defect density in the a-IGZO films.</P>
Hwang, Hyeon-Shik,Choe, Seon-Yeong,Hwang, Ji-Sup,Moon, Da-Nal,Hou, Yanan,Lee, Won-Joon,Wilkinson, Caroline Callaghan and Co 2015 Journal of forensic sciences Vol.60 No.4
<P>The purpose of this study was to establish the reproducibility of facial soft tissue (ST) thickness measurements by comparing three different measurement methods applied at 32 landmarks on three-dimensional cone-beam computed tomography (CBCT) images. Two observers carried out the measurements of facial ST thickness of 20 adult subjects using CBCT scan data, and inter- and intra-observer reproducibilities were evaluated. The measurement method of 'perpendicular to bone' resulted in high inter- and intra-observer reproducibility at all 32 landmarks. In contrast, the 'perpendicular to skin' method and 'direct' method, which measures a distance between one point on bone and the other point on skin, presented low reproducibility. The results indicate that reproducibility could be increased by identifying the landmarks on hard tissue images, rather than on ST images, and the landmark description used in this study can be used in the establishment of reliable tissue depth data using CBCT images.</P>
총설 : 니켈담지촉매에서 합성가스 제조시 La 조촉매의 영향
황재영 ( Hwang Jae Yeong ),김영국 ( Kim Yeong Gug ),임연수 ( Im Yeon Su ),박홍수 ( Park Hong Su ),함현식 ( Ham Hyeon Sig ) 한국유화학회 2004 한국응용과학기술학회지 Vol.21 No.1
N/A The effect of La promoter on the carbon deposition and catalytic activity in the synthesis gas production with supported Ni catalysts was investigated. Active component was Ni and support was CeO_(2) and the promoter used was La. The reaction was carried out in a fixed reactor at 1 atm and 650~800℃. The catalysts were prepared by two methods, the impregnation method and urea method. The catalysts prepared by the urea method showed 10 times higher surface area than those of prepared by the impregnation method. By the introduction of La promoter in the catalyst system, carbon deposition was remarkably reduced from 16% to 2%. It appears that the promoter facilitates the formation of a stable fluoride-type phase, which reduces the carbon deposition. The best atalytic activity and CO and H_(2) selectivities were obtained with 2.5wt% Ni/Ce(La)Ox catalyst at 750℃, giving 90% methane conversion, 93 and 80% of CO and H_(2) selectivities, respectively.