Comparison of Six Automated Immunoassays With Isotope-Diluted Liquid Chromatography–Tandem Mass Spectrometry for Total Thyroxine Measurement

Songlin Yu,Weiyan Zhou,Xinqi Cheng,Qinghui Meng,Honglei Li,Li’an Hou,Jun Lu,Shaowei Xie,Qian Cheng,Chuanbao Zhang,Ling Qiu 대한진단검사의학회 2019 Annals of Laboratory Medicine Vol.39 No.4

Background: Accurate serum total thyroxine (TT4) measurement is important for thyroid disorder diagnosis and management. We compared the performance of six automated immunoassays with that of isotope-diluted liquid chromatography-tandem mass spectrometry (ID-LC-MS/MS) as the reference method. We also evaluated the correlation of thyroid stimulating hormone (TSH) with TT4 measured by ID-LC-MS/MS and immunoassays. Methods: Serum was collected from 156 patients between October 2015 and January 2016. TT4 was measured by immunoassays from Abbott (Architect), Siemens (ADVIA Centaur XP), Roche (E601), Beckman-Coulter (Dxi800), Autobio (Autolumo A2000), and Mindray (CL-1000i), and by ID-LC-MS/MS. Results were analyzed using Passing–Bablok regression and Bland–Altman plots. Minimum requirements based on biological variation were as follows: a mean bias of ≤4.5% and total imprecision (CV) of ≤3.7%. Results: All immunoassays showed a correlation >0.945 with ID-LC-MS/MS; however, the slope of the Passing–Bablok regression line varied from 0.886 (Mindray) to 1.23 (Siemens) and the intercept from -12.8 (Siemens) to 4.61 (Mindray). Only Autobio, Beckman-Coulter, and Roche included the value of one in the 95% confidence interval for slope. The mean bias ranged from -10.8% (Abbott) to 9.0% (Siemens), with the lowest value noted for Roche (3.5%) and the highest for Abbott (-10.8%). Only Abbott and Roche showed within-run and total CV ≤3.7%. Conclusions: Though all immunoassays correlated strongly with ID-LC-MS/MS, most did not meet the minimum clinical requirement. Laboratories and immunoassay manufacturers must be aware of these limitations.

NEW METHODOLOGY FOR DETERMINATION OF LOAD SPECTRA FOR THE VEHICLE ACCELERATED DURABILITY TESTING ASSOCIATED WITH THE TIME CORRELATED FATIGUE DAMAGE ANALYSIS METHOD

Jiawei Yu,Songlin Zheng,Jinzhi Feng,Lihui Zhao 한국자동차공학회 2017 International journal of automotive technology Vol.18 No.3

The generation of valid and effective test spectra from proving ground recorded load spectra is critical for automotive durability testing. Traditional methods mostly based on spectrum damage were used to select load spectra. Statistical characteristics of load spectra were taken into account, and a new load spectra determination method based on a concatenation of a multi-section minimum standard deviation spectrum (CMSD) was proposed. The CMSD spectra were created and based on proving ground recorded load spectra. Fatigue damage analyses showed that the CMSD spectra approximated the mean damage spectra and were representative of proving ground load spectra. Subsequently, the CMSD spectra were edited by applying the time correlated fatigue damage (TCFD) analysis method to generate accelerated loading spectra. The spectra editing process of the TCFD was discussed in detail. Validation of the accelerated spectra was conducted from amplitude and frequency domains. The same fatigue damage and identical spectrum properties were retained in the accelerated spectra. A vehicle 4-post testing was finally conducted where the accelerated loading spectra were applied as the target spectra. Several fatigue fracture phenomena occurred during our test, which showed good agreement with the field test. Therefore, the load spectra determination method CMSD associated with the load spectra editing method TCFD were demonstrated reasonable and practical.

Effect of Increasing Diffusion Gradient Direction Number on Diffusion Tensor Imaging Fiber Tracking in the Human Brain

Xufeng Yao,Tonggang Yu,Beibei Liang,Tian Xia,Qinming Huang,Songlin Zhuang 대한영상의학회 2015 Korean Journal of Radiology Vol.16 No.2

To assess the effects of varying the number of diffusion gradient directions (NDGDs) on diffusion tensor fiber tracking (FT) in human brain white matter using tract characteristics. Twelve normal volunteers underwent diffusion tensor imaging (DTI) scanning with NDGDs of 6, 11, 15, 21, and 31 orientations. Three fiber tract groups, including the splenium of the corpus callosum (CC), the entire CC, and the full brain tract, were reconstructed by deterministic DTI-FT. Tract architecture was first qualitatively evaluated by visual observation. Six quantitative tract characteristics, including the number of fibers (NF), average length (AL), fractional anisotropy (FA), relative anisotropy (RA), mean diffusivity (MD), and volume ratio (VR) were measured for the splenium of the CC at the tract branch level, for the entire CC at tract level, and for the full brain tract at the whole brain level. Visual results and those of NF, AL, FA, RA, MD, and VR were compared among the five different NDGDs. The DTI-FT with NDGD of 11, 15, 21, and 31 orientations gave better tracking results compared with NDGD of 6 after the visual evaluation. NF, FA, RA, MD, and VR values with NDGD of six were significantly greater (smallest p = 0.001 to largest p = 0.042) than those with four other NDGDs (11, 15, 21, or 31 orientations), whereas AL measured with NDGD of six was significantly smaller (smallest p = 0.001 to largest p = 0.041) than with four other NDGDs (11, 15, 21, or 31 orientations). No significant differences were observed in the results among the four NDGD groups of 11, 15, 21, and 31 directions (smallest p = 0.059 to largest p = 1.000). The main fiber tracts were detected with NDGD of six orientations; however, the use of larger NDGD (≥ 11 orientations) could provide improved tract characteristics at the expense of longer scanning time.

Comparison of Direct and Extraction Immunoassay Methods With Liquid Chromatography-Tandem Mass Spectrometry Measurement of Urinary Free Cortisol for the Diagnosis of Cushing’s Syndrome

Mu Danni,Fang Jiadan,Yu Songlin,Ma Yichen,Cheng Jin,Hu Yingying,Song Ailing,Zhao Fang,Zhang Qi,Qi Zhihong,Zhang Kui,Xia Liangyu,Qiu Ling,Zhu Huijuan,Cheng Xinqi 대한진단검사의학회 2024 Annals of Laboratory Medicine Vol.44 No.1

Background: Twenty-four-hour urinary free cortisol (UFC) measurement is the initial diagnostic test for Cushing’s syndrome (CS). We compared UFC determination by both direct and extraction immunoassays using Abbott Architect, Siemens Atellica Solution, and Beckman DxI800 with liquid chromatography-tandem mass spectrometry (LC-MS/MS). In addition, we evaluated the value of 24-hr UFC measured by six methods for diagnosing CS. Methods: Residual 24-hr urine samples of 94 CS and 246 non-CS patients were collected. A laboratory-developed LC-MS/MS method was used as reference. UFC was measured by direct assays (D) using Abbott, Siemens, and Beckman platforms and by extraction assays (E) using Siemens and Beckman platforms. Method was compared using Passing–Bablok regression and Bland–Altman plot analyses. Cut-off values for the six assays and corresponding sensitivities and specificities were calculated by ROC analysis. Results: Abbott-D, Beckman-E, Siemens-E, and Siemens-D showed strong correlations with LC-MS/MS (Spearman coefficient r=0.965, 0.922, 0.922, and 0.897, respectively), while Beckman-D showed weaker correlation (r=0.755). All immunoassays showed proportionally positive bias. The areas under the curve were 0.975 for Abbott-D, 0.972 for LC-MS/MS, 0.966 for Siemens-E, 0.948 for Siemens-D, 0.955 for Beckman-E, and 0.877 for Beckman-D. The cut-off values varied significantly (154.8–1,321.5 nmol/24 hrs). Assay sensitivity and specificity ranged from 76.1% to 93.2% and from 93.0% to 97.1%, respectively. Conclusions: Commercially available immunoassays for measuring UFC show different levels of analytical consistency compared to LC-MS/MS. Abbott-D, Siemens-E, and Beckman-E have high diagnostic accuracy for CS.

Reference Intervals for Thyroid-Associated Hormones and the Prevalence of Thyroid Diseases in the Chinese Population

Zou Yutong,Wang Danchen,Cheng Xinqi,Ma Chaochao,Lin Songbai,Hu Yingying,Yu Songlin,Xia Liangyu,Li Honglei,Yin Yicong,Liu Huaicheng,Zhang Dianxi,Zhang Kui,Lian Xiaolan,Xu Tengda,Qiu Ling 대한진단검사의학회 2021 Annals of Laboratory Medicine Vol.41 No.1

Background: Thyroid diseases are highly prevalent worldwide, but their diagnosis remains a challenge. We established reference intervals (RIs) for thyroid-associated hormones and evaluated the prevalence of thyroid diseases in China. Methods: After excluding outliers based on the results of ultrasound screening, thyroid antibody tests, and the Tukey method, the medical records of 20,303 euthyroid adults, who visited the Department of Health Care at Peking Union Medical College Hospital from January 2014 to December 2018, were analyzed. Thyroid-associated hormones were measured by the Siemens Advia Centaur XP analyzer. The RIs for thyroid-associated hormones were calculated according to the CLSI C28-A3 guidelines, and were compared with the RIs provided by Siemens. The prevalence of thyroid diseases over the five years was evaluated and compared using the chi-square test. Results: The RIs for thyroid stimulating hormone (TSH), free thyroxine (FT4), free triiodothyronine (FT3), total thyroxine (TT4), and total triiodothyronine (TT3) were 0.71–4.92 mIU/L, 12.2–20.1 pmol/L, 3.9–6.0 pmol/L, 65.6–135.1 nmol/L, and 1.2–2.2 nmol/L, respectively. The RIs of all hormones except TT4 differed significantly between males and females. The RIs of TSH increased with increasing age. The prevalence of overt hypothyroidism, overt hyperthyroidism, subclinical hypothyroidism, and subclinical hyperthyroidism was 0.5% and 0.8%, 0.2% and 0.6%, 3.8% and 6.1%, and 3.3% and 4.7% in males and females, respectively, which differed from those provided by Siemens. Conclusions: Sex-specific RIs were established for thyroid-associated hormones, and the prevalence of thyroid diseases was determined in the Chinese population.

J 적분을 이용한 압전세라믹의 절연파괴 해석

Song Lin,김유환(Yu Hwan Kim),범현규(Hyeon Gyu Beom) Korean Society for Precision Engineering 2008 한국정밀공학회지 Vol.26 No.1