http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Gang Zhang,Chang Ho Ra,Hua-Min Li,Tian-zi Shen,Byung-ki Cheong,Won Jong Yoo IEEE 2010 IEEE transactions on electron devices Vol.57 No.11
<P>This paper proposes a modified engineered-potentialwell (MW) for NAND flash memory application. The MW was formed by using a transitional SiO<SUB>2</SUB>/SiO<SUB>x</SUB>,Na-TiO<SUB>x</SUB>,N<SUB>y</SUB> tunnel barrier, a trap-rich TiO<SUB>2</SUB> trapping layer, and an abrupt SiO<SUB>2</SUB> block barrier. The transitional tunnel barrier shrinks to enhance the tunneling of carriers during programming/erasing (P/E) and extends to suppress charge loss during data retention. Deep-level transient spectroscopy suggests that this tunnel barrier has few shallow traps after a N<SUB>2</SUB> + O<SUB>2</SUB> thermal treatment, and the TiO<SUB>2</SUB> trapping layer has deep electron traps. With the variable tunnel barrier and deep electron traps, the MW device showed promising performance in fast programming (<; μs) at low-voltage operation (7-10 MV/cm), good P/E endurance (> 10<SUP>6</SUP> P/E cycles), large threshold voltage window (ΔV<SUB>th</SUB> =M> V), as well as improved data retention at 125 °C.</P>
Effect of processing parameters on the quality of fresh-cut button mushroom(Agaricus bisporus)
Ji Gang Kim,Ji Weon Choi,Seung Yu Kim,Seung Ryoung Cheong,Won-Sik Kong 한국버섯학회 2010 한국버섯학회지 Vol.8 No.4
This study was conducted to investigate optimum processing procedure of fresh-cut button mushrooms. The experiments were done with different processing parameters including washing method, washing time, sanitation, and cutting time. Fresh mushrooms were washed by swirling water (SW), lift type-immersion washing (LIW), or combined LIW and water spray (LI+WS). Mushroom samples were washed by LIW for 0, 1, 3, and 5 minutes separately. Mushrooms were sanitized with 0, 50, or 100 ㎕L-1 chlorine solution (pH 7) for 60 seconds. Mushrooms were sliced at different times (before washing, after washing, or after drying). The combined washing treatment, LIW+WS was effective in maintaining better appearance and higher Lightness color value among treatments. Optimum washing time to remove foreign materials and maintain color was 3 minutes when mushrooms were washed by LIW. Samples sanitized with 50 ㎕L-1 chlorine reduced initial aerobic bacterial population and had only slight residual chlorine odor. Fresh-cut mushrooms sliced after washing had the lowest loss among samples. The optimized washing, sanitation, and cutting time parameters can be used for sequential processing of fresh-cut button mushrooms.
$Ca^{2+}-ATPase$ 3차원 결정의 Lamellar면 구조분석
정강원,Cheong, Gang-Won 한국현미경학회 1997 Applied microscopy Vol.27 No.2
Cylinder-like crystals of $Ca^{2+}-ATPase$ provide views parallel to the lamellar plane, from which parameters of lamellar stacking can be directly measured. These parameters were measured using different preparation methods. Assuming that molecular packing is the same, data from lamellar plane could supplement those obtained by tilting large, thin plate-like crystals. However, base on data obtained .by electron microscopy and x-ray powder patterns, the plate-like crystal may have another scheme for stacking the lamellar. The projection map (h, 0, 1) from cylinder-like crystals using cryoelectron microscopy suggest the lamellar spacing can be variable.
정강원,Cheong, Gang-Won 한국현미경학회 2000 Applied microscopy Vol.30 No.3
전자현미경을 이용한 단백질 구조분석은 약 30여년간 발전되어 왔다. Bacteriorhodopsin과 porin 등의 near atomic resolution의 구조분석은 전자현미경의 발전과 진행을 보여주는 하나의 예로 설명될 수 있다. 전자현미경을 이용한 거대분자의 3차원 구조를 규명하기 위해 필요한 기본과정 즉, 시료준비, 자료수집과 자료처리 등에 대하여 토론하였다. Electron microscopy has used for analysing the structure of protein over 30 years. Bacteriohodopsin and porins are used as examples to illustrate the progress that has recently been made in attaining resolutions which hitherto were regarded as exclusive to the realm of x-ray crystallography. To determine a protein structure used by electron microscopy, one must pass through a number of basic steps including preparation of specimen , data acquisition and data processing.
승용차 틴팅이 조급한 성향의 후미차량에 미치는 영향에 대한 실험적 분석
강종호(Gang, Jong-Ho),이청원(Lee, Cheong-Won) 대한교통학회 2008 대한교통학회 학술대회지 Vol.58 No.-
자동차 창유리 틴팅(Window tinting) 암도규제를 위한 도로교통법 개정이 상당기간 논란이 되고 있다. 이는 과도한 틴팅이 안전에 위협을 준다는 가설에 기초한다. 장일준 (2004)에 따르면 자동차 창유리의 가시광선 투과율이 40%이하일 때 운전자의 시인성과 조작반응성이 현저히 감소하는 것으로 분석했다. 유사 연구결과에 따르면 2005년 도로교통법 시행령은 투과율에 대한 규제를 강화하기에 이르렀다. 그러나 일부 운전자들은 여전히 이를 불필요한 규제로 보는 시각도 상존한다. 한편, 틴팅차량이 교통류에 미치는 영향을 직접적으로 자료를 취득하여 분석한 구체적인 실험연구는 전무하다. 본 연구는 시각을 달리하여 과도한 틴팅차량이 후미차량의 감·가속 및 가속소음 등에 영향을 끼쳐 용량저해 요인으로 작용할 수도 있다는 가설을 세우고 이를 분석하기 위한 자료수집 방법을 구상하고 실현하여 취득한 현장자료로 가설이 참임을 입증하기 위한 개연성을 확인하는 기초연구를 수행한다.
강종호(Gang, Jong-Ho),이청원(Lee, Cheong-Won) 대한교통학회 2006 대한교통학회 학술대회지 Vol.53 No.-
대기오염 중 자동차에서 배출되는 오염물질이 차지하는 비중이 ’92년 60.8%에서 ’99년 85.2%로 점차 증가하고 있는 현실을 반영하여 자동차 배기가스 인한 대기오염문제는 최근 몇년 동안 교통 및 환경분야에서 중요한 연구과제로 주목 받고 있다. 본 연구에서는 교풍환경관련분야의 국내외 최근 논문 100여편을 복합적으로 분석하여 이 분야의 연구동향 및 시사점을 제시함을 연구목적으로 한다. 본 연구의 결과는 향후 우리나라의 교통환경관련연구의 방향을 보다 합리적으로 설정하고 교통환경정책 및 교통관리전략의 수립에 중요한 지표가 될 것이다.