http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
영구자석 동기전동기 Phase Fault 발생 시 토크제어 전략에 관한 연구
진원준,김동옥,황재엽,이근호 제어·로봇·시스템학회 2019 제어·로봇·시스템학회 논문지 Vol.25 No.1
In the torque control system using the permanent magnet synchronous motor (PMSM) in automobiles, it is essential to use fault-tolerant techniques to maintain continuous torque when a fault occurs. In this paper, we propose a fault remedial strategy to improve the torque control performance under the single-phase open condition. This method can also be utilized for emergency driving by preventing an accident from spreading by forcibly separating the inverter phase in a fault situation such as arm short due to the burnout of the power semiconductor device. Both the simulation and the experimental results proved that the proposed method could maintain continuous torque for driving the remaining two-phase condition when an open-phase state occurred.
폴리머 마이크로링 공진기를 이용한 광학적 마이크로웨이브 대역통과 필터
진원준,김도환,송주한,이상신,Chin, Won-Jun,Kim, Do-Hwan,Song, Ju-Han,Lee, Sang-Shin 한국광학회 2005 한국광학회지 Vol.16 No.5
An integrated photonic microwave bandpass filter has been proposed and demonstrated incorporating a coherently coupled microring resonator in low-loss polymers. The proposed device may feature compact site, simple structure, tuning via the thermooptic and electrooptic effect, and flexible integration with other electrical and optical devices. The resonator was designed to have an extremely small bandwidth so that it could be used to selectively pass the optical signal carrying the microwave signal to attain efficient bandpass filtering. We made and tested two resonators with a single ring and double rings, and performed a theoretical fitting of their measured transfer curves to predict the performance of the microwave filters based on them precisely. It was found that as the number of the rings used for the resonator increases, the bandwidth gets smaller, the rolloff sharper, and the band rejection higher. Finally our filter exhibited the center frequency of 10GHz, the 3-dB bandwidth of 1.0GHz, the corresponding quality (Q) factor of 10, and the rejection outside of the passband of more than 25dB. 본 논문에서는 코히런트하게 결합되는 폴리머 마이크로링 공진기를 이용한 광학적 방식의 마이크로웨이브 대역통과 필터를 제안하고 구현하였다. 제안된 소자는 소형이며 구조가 간단하고, 열광학 및 전기광학 효과를 통한 중심주파수 변화가 용이하고, 그리고 다른 전기소자나 광소자와의 집적성 등이 뛰어나다. 특히, 이 공진기는 마이크로웨이브 신호를 수반하는 광신호를 효과적으로 필터링하기 위해 아주 작은 대역폭을 갖도록 설계되었다. 본 논문에서는 한 개의 링과 두 개의 링으로 구성된 공진기를 각각 제작하여 특성을 확인하였다. 링 공진기의 측정된 전달 특성을 이론적으로 fitting하였으며, 이로부터 제안된 마이크로웨이브 필터의 특성을 정확하게 예측하였다. 공진기의 링 수가 증가할수록 대역폭은 감소하고 롤오(roll-off) 특성이 향상되며 대역 소멸비가 증가함을 알 수 있었다. 측정된 대역통과 필터의 중심주파수는 $\~10GHz$였고 3-dB 대역폭은 $\~0GHz$였다. 그리고 Q값(quality factor)은 $\~10$이었고 통과대역의 소멸비는 약 25dB였다.
나노 임프린트 기술을 이용한 폴리머 도파로 기반의 브래그 격자형 파장 가변 필터
김도환,진원준,이상신,안세원,이기동,Kim, Do-Hwan,Chin, Won-Jun,Lee, Sang-Shin,Ahn, Seh-Won,Lee, Ki-Dong 한국광학회 2006 한국광학회지 Vol.17 No.1
A tunable wavelength filter was proposed and demonstrated by using the UV nanoimprint technique. It consists of a Bragg grating in polymer waveguides and a heating electrode. The manufacturing of the grating was substantially simplified with the introduction of a smart imprint stamp containing a waveguide pattern integrated with the grating pattern. The center wavelength of the filter was successfully tuned by taking advantage of the thermooptic effect in polymers, which was induced by supplying electrical power to the electrode. For the fabricated device, a transmission dip of ${\~}$15 dB and a 3-dB bandwidth of 0.8 nm were obtained at the Bragg wavelength of ${\~}$l560 nm. The achieved thermooptic tuning efficiency was ${\~}$0.28 nm/mW, while the center wavelength was shifted from 1560 nm to 1558 nm with the electrical power consumption of 7 mW. 본 논문에서는 UV 나노임프린트 기술을 이용하여 파장가변 필터를 제안하고 구현하였다. 제안된 소자는 폴리머 도파로 기반의 브래그 격자와 열 광학효과를 위한 히팅용 전극으로 구성되어 있다. 도파로 패턴과 브래그 격자 패턴이 결합된 임프린트용 스탬프를 이용하여 브래그 격자를 구현하였다. 전극에 전력을 인가하여 폴리머의 열 광학효과를 통하여 필터의 중심파장을 효과적으로 이동시킬 수 있었다. 제작된 소자는 브래그 파장대역인 1560 nm 에서 대역저지 소멸비가 15 dB이며, 대역폭이 0.8 nm였다. 또한 소비전력이 7 mW일 때 중심파장은 1560 nm에서 1558 nm로 이동되었다. 이 때 열 광학효과 파장가변 특성이 약 0.28 nm/mW 였다.