http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
장대원(JANG, Daewon),김덕길(KIM, Duckgil),김연수(KIM, Yonsoo),최우일(Choi, Wooil) 한국습지학회 2018 한국습지학회지 Vol.20 No.1
강우-유출 모의를 수행할 때 기상 및 강우관측소의 자료를 이용하는 것이 일반적이다. 그러나 유역면적이 클 경우 기상 및 강우관측소의 자료만으로 신뢰성 있는 유출량을 산정하기란 어렵다. 따라서 본 연구에서는 이용되는 강우자료에 따라 준분포형 모형에 의해 산정되는 유출량에 미치는 영향을 검토하기 위해 대상유역에 위치하고 있는 기상관측소의 강우자료, 기상 및 강우관측소의 강우자료, 크리깅 기법에 의해 기상 및 강우관측소의 강우자료를 공간적으로 분포시켜 얻은 가상지점의 관측 강우자료를 이용해 각 소유역의 면적 강우량을 산정하였다. 또한 각각의 강우자료들을 비교하였으며, 분포형 모형인 SWAT모형을 이용하여 각각의 강우자료에 따른 유출량을 비교 분석하였다. 본 연구는 공간 분포된 면적강우량을 이용해 산정된 유출량의 정확성을 검토하기 위한 것으로써 분석 결과, 공간 분포된 면적 강우량을 이용한 유출량이 기상 및 강우관측소의 강우량을 이용한 유출량보다 실제 유출량을 보다 더 잘 모의하는 것으로 나타났다. 이는 공간 분포된 강우가 실제 강우패턴을 가장 잘 반영한다고 할 수 있다. In general, the rainfall-runoff simulation is performed using rainfall data from meteorological and observational rain gauge stations. However, if we only use rainfall data from meteorological and observational rain gauge stations for runoff simulation of a large watershed, the problem in the reliability of the simulated runoff can be occurred. Therefore, this study examined the influence of the rainfall data on the simulated runoff volume by a Semi-distributed model. For this, we used rainfall data from meteorological stations, meteorological and observational stations, and a spatially distributed rainfall data from hypothetical stations obtained by kriging method. And, we estimated the areal rainfall of each sub-basin. Also the estimated areal rainfall and the observed rainfall were compared and we compared the simulated runoff volumes using SWAT model by the rainfall data from meteorological and observational rain gauge stations and runoff volume from the estimated areal rainfall by Kriging method were analyzed. This study was performed to examine the accuracy of calculated runoff volume by spatially distributed areal rainfall. The analysis result of this study showed that runoff volume using areal rainfall is similar to observed runoff volume than runoff volume using the rainfall data of weather and rain gauging station. this means that spatially distributed rainfall reflect the real rainfall pattern.
함정균 ( Jeonggyun Ham ),장대원 ( Daewon Jang ),이아름 ( Areum Lee ),김미정 ( Mijeong Kim ),김주현 ( Juhyeon Kim ),조홍현 ( Honghyun Cho ) 조선대학교 공학기술연구원 2018 공학기술논문지 Vol.11 No.2
An experimental study on the flow distribution characteristics according to the inlet direction of the working fluid and an analytical study on the flow characteristics according to the variation of the outlet width were carried out in order to present the optimal design of welded plate heat exchanger. In the experiment results on the flow distribution according to the inflow direction of the working fluid, the flow distribution in the welded plate heat exchanger is mainly formed around the center channel. As the inflow flow rate increases, the flow distribution ratio at the center channel decreases, whereas the flow distribution ratio at the side channel increases, thereby improving the distribution effect. The increase inflow rate of working fluid brings the incre of the pressure drop in the channel while the increase in width at the outlet reduces the pressure drop. Besides, it can be seen the dead zone where the fluid flow stagnates at the opposite corner of the outlet side.