http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
220V/100W 백열전구의 온도특성에 따른 화재분석에 관한 연구
송길목,한운기,김영석,최충석 한국화재소방학회 2006 한국화재소방학회논문지 Vol.20 No.1
In this paper, we are studied on the temperature characteristics and fire progress of an incandescent electric lamp at 220V/100W. In the case of stationary state, the ignition possibility of the incandescent electric lamp due to the heat generation was low because the temperature was measured at 161.9oC. the temperature was increased at 538.1oC in the airtight chamber, but it does not generated the fire because the oxygen was not exist in the airtight chamber. When the lamp is broken, the filament of lamp was melted in the air. The gas of lamp interior spurted to the weakest part by external flame. Thus, the incandescent electric lamp is high possibility of fire when oxygens from airtight space. Also, it is known that the possibility of ignition is very high if combustion materials(sawdust) exists on surrounding. These experimental results will be utilized for the data in the investigation electrical fire cause. 본 논문은 조명설비 중 220V/100W 백열전구의 온도특성과 화재분석에 관하여 연구하였다. 백열전구의 발열에 의한 발화가능성을 실험한 결과 정상상태에서는 최고 161.9oC로 측정되었다. 밀폐된 공간에서 축 열이 되면 약 538.1oC까지 상승하는 것으로 나타났다. 유리구를 파손하였을 경우 필라멘트는 공기 중에서 용단되었다. 외부 열에 의한 경우 전구 내부의 가스가 약한 부분으로 분출되었다. 따라서 백열전구는 산소 의 공급이 원활하면서 폐쇄된 공간에서 화재의 가능성이 높으며, 가연성 물질 등이 주변에 있다면 화재 가능성이 매우 높은 것으로 나타났다. 백열전구의 외형변화, 재료특성의 변화 등을 통해 화재원인을 규명 하는 중요한 자료로 이용될 것이 기대된다.
송길목,최충석,김향곤,김영석,Shong, Kil-Mok,Choi, Chung-Seog,Kim, Hyong-Kon,Kim, Young-Seok 한국조명전기설비학회 2006 조명·전기설비학회논문지 Vol.20 No.1
이 논문은 화재원인판정에 있어서, 교류전류에 의해 용융된 나전선의 발열특성을 기술한 것이다. 실험을 위해 동전선은 1.2[mm], 1.6[mm], 2.0[mm]의 직경인 것을 준비하였다. 단면분석을 통해 용단전류가 전선에 공급되었을 때, 수지상 조직은 약40[$^{\circ}$] 또는 60[$^{\circ}$]의 각도로 성장하는 것을 확인하였다. 용단전류가 커지면 커질수록 수지상 조직의 성장각도는 줄어들었다. 그것은 주상조직과 유사하다는 것을 확인하였다. For a fire cause judgement this paper describes the heating characteristics of electric bare wire melted by AC current. The cower wires prepared for the experiment were 1.2[mm], 1.6[mm], and 2.0[mm] in diameter. Through the cross section analysis(CSA), it was confirmed that the dendrite structure grew at the angle of about 40[$^{\circ}$] or 60[$^{\circ}$] when the fusing current was applied to the wires. The larger the fusing current is, the more decreased the growth angle of the dendrite structure is. It was confirmed that the dendrite structure was arranged like the columnar structure.
송길목,한운기,김종민,김영석,김명수,김혁수,Shong, Kil-Mok,Han, Woon-Ki,Kim, Jong-Min,Kim, Young-Seok,Kim, Myoung-Soo,Kim, Hyeok-Soo 한국화재조사학회 2008 한국화재조사학회 논문지 Vol.11 No.1
본 연구는 현장에서 발생한 가로등 화재에 대한 원인을 규명하기 위한 것으로 검증실험과 다양한 분석을 수행하였다. 이물질이 부착된 250W 메탈할라이드등은 $410.4^{\circ}C$로 급격하게 온도가 상승하였다. 따라서 환기 및 방진에 대한 개선이 요구된다. MH 램프에 의한 열은 발광판에서 유리구, 등기구로 이어지며 확산되었다. 메탈할라이드등의 사고원인은 등기구 내부의 이물질이 침적되어 축열 및 화재로 이어진 것으로 추정되며, 등기구의 설계에 있어서 외부 이물질 또는 분진이 침적되지 않으면서 축열이 되지 않는 구조 개선이 요구된다. This paper carried out a variety of analysis for a finding out the causes of fire on the street lamp. The glass bulb of 250W metal-halide(MH) lamps attached with the impurities rose the temperature by at $410.4^{\circ}$ in normal condition. Therefore, a lamp apparatus is needed the improvement for ventilation and the protection against dust. The heat of MH lamps is diffused through out the luminous tube, a glass bulb, and apparatus by degrees. The accident cause of the lamp is presumed that the accumulated heat by deposits of the inner part. It will be recommended the improvement of the structure that aren't the external impurity and accumulated heat in the MH lamps set.
송길목,최충석,노영수,곽희로 대한전기학회 2004 전기학회논문지C Vol.53 No.1(C)
This paper describes the carbonization characteristics of a phenolic resin deteriorated by tracking under the environment of a fire. In the experiment, a liquids droplet of 1[%] NaCl was dripped on the phenolic resin to cause a tracking with 110[V], 220[V] voltages applied. It can be addressed from the experimental results that when an insulator is carbonized by an external fire, its structure is amorphous. If an insulator is carbonized by electrical cause, on the other hand, its structure would be crystalline. In order to observe the surface change of the phenolic resin, the tracking process was analyzed by using SEM. In the case that the materials are carbonized under heat or fire, the exothermic peak appears around 500[℃]. This is one of the important factors to determine the cause of fires. As a result of DTA, the exothermic peaks of an untreated sample showed at 333.4[℃], 495.7[℃] but those of a sample deteriorated by tracking appeared at 430.6[℃], 457.6[℃] in a voltage of 110[V], and at 456.2[℃], 619.7[℃] in a voltage of 220[V]. It is possible, therefore, to distinguish a virgin sample from carbonized samples(graphite) by the exothermic peak.