Lack of Association between Pre-Operative Insulin-Like Growth Factor-1 and the Risk of Post-Operative Delirium in Elderly Chinese Patients

Che-Sheng Chu,Chih-Kuang Liang,Ming-Yueh Chou,Yu-Te Lin,Chien-Jen Hsu,Chin-Liang Chu,Po-Han Chou 대한신경정신의학회 2016 PSYCHIATRY INVESTIGATION Vol.13 No.3

ObjectiveaaPostoperative delirium (POD) is a highly prevalent complex neuropsychiatric syndrome in elderly patients. However, its pathophysiology is currently unknown. Early detection and prevention of POD is important; therefore, the aim of this study was to investigate the link between preoperative insulin growth factor 1 (IGF-1) levels in the serum and POD in the Chinese elderly patients. MethodsaaOne hundred and three patients who were undergoing an orthopedic operation took part in the study. Preoperative serum IGF-1 levels were measured. POD was determined daily using the Confusion Assessment Method (CAM) and DSM-IV TR. Baseline serum IGF-1 levels were compared between patients who did and did not develop POD. Correlation coefficients were calculated to evaluate relationship between baseline characteristics and serum IGF-1 levels. The relationship between baseline biomarkers and delirium status was investigated using logistic regression analysis, adjusting for potential confounding variables. ResultsaaTwenty-three patients developed POD. The POD group had lower MMSE scores and higher CCI scores and proportions of acute admission. Preoperative serum IGF-1 levels were correlated with MMSE scores and age (MMSE: r=0.230, p<0.05; age: r=-0.419, p<0.001). Baseline serum IGF-1 levels did not differ between patients who did and did not develop POD, even after adjusting for potential confounding factors, MMSE score, and age. ConclusionaaNo association was found between preoperative IGF-1 levels and POD, suggesting that they are not direct biomarkers of the incidence of POD among the Chinese elderly population. Further research with larger sample sizes is warranted to clarify the relationship.

Path Loss Exponent Estimation for Indoor Wireless Sensor Positioning

( Yu-sheng Lu ),( Chin-feng Lai ),( Chia-cheng Hu ),( Yueh-min Huang ),( Xiao-hu Ge ) 한국인터넷정보학회 2010 KSII Transactions on Internet and Information Syst Vol.4 No.3

Rapid developments in wireless sensor networks have extended many applications, hence, many studies have developed wireless sensor network positioning systems for indoor environments. Among those systems, the Global Position System (GPS) is unsuitable for indoor environments due to Line-Of-Sight (LOS) limitations, while the wireless sensor network is more suitable, given its advantages of low cost, easy installation, and low energy consumption. Due to the complex settings of indoor environments and the high demands for precision, the implementation of an indoor positioning system is difficult to construct. This study adopts a low-cost positioning method that does not require additional hardware, and uses the received signal strength (RSS) values from the receiver node to estimate the distance between the test objects. Since many objects in indoor environments would attenuate the radio signals and cause errors in estimation distances, knowing the path loss exponent (PLE) in an environment is crucial. However, most studies preset a fixed PLE, and then substitute it into a radio propagation loss model to estimate the distance between the test points; such method would lead to serious errors. To address this problem, this study proposes a Path Loss Exponent Estimation Algorithm, which uses only four beacon nodes to construct a radio propagation loss model for an indoor environment, and is able to provide enhanced positioning precision, accurate positioning services, low cost, and high efficiency.

Separation of Valuable Metal from Waste Photovoltaic Ribbon through Extraction and Precipitation

Chen, Wei-Sheng,Chen, Yen-Jung,Yueh, Kai-Chieh The Korean Institute of Resources Recycling 2020 資源 리싸이클링 Vol.29 No.2

With rapid increasing production and installation, recycling of photovoltaic modules has become the main issue. According to the research, the accumulation of waste modules will reach to 8600 tons in 2030. Moreover, Crystalline-silicon (c-Si) Photovoltaic modules account for more than 90% of the waste. C-Si PV modules contain 1.3% of weight of photovoltaic ribbon inside which contains the most of lead, tin and copper in the PV modules, which would cause environmental and humility problem. This study provided a valuable metal separation process for PV ribbons. Ribbons content 82.1% of Cu, 8.9% of Sn, 5.2% of Pb, and 3.1% of Ag. All of them were leached by 3M of hydrochloric acid in the optimal condition. Ag was halogenated to AgCl and precipitated. Cu ion was extracted and separated from Pb and Sn by Lix984N then stripped by 3M H2SO4. The effect of the optimal parameters of extraction was also studied in this essay. The maximum extraction efficiency of Cu ion was 99.64%. The separation condition of Pb and Sn were obtained by adjusting the pH value to 4 thought ammonia to precipitate and separate Pb and Sn. The recovery of Pb and Sn can reach 99%.

Alpinate Oxyphyllae Fructus Inhibits IGFII-Related Signaling Pathway to Attenuate Ang II-Induced Pathological Hypertrophy in H9c2 Cardiomyoblasts

Chuan-Te Tsai,Yung-Ming Chang,Shu-Luan Lin,Yueh-Sheng Chen,Yu-Lan Yeh,Viswanadha Vijaya Padma,Chin-Chuan Tsai,Ray-Jade Chen,Tsung-Jung Ho,Chih-Yang Huang 한국식품영양과학회 2016 Journal of medicinal food Vol.19 No.3

Angiotensin II (Ang II) is a very important cardiovascular disease inducer and may cause cardiac pathological hypertrophy and remodeling. We evaluated a Chinese traditional medicine, alpinate oxyphyllae fructus (AOF), for therapeutic efficacy for treating Ang II-induced cardiac hypertrophy. AOF has been used to treat patients with various symptoms accompanying hypertension and cerebrovascular disorders in Korea. We investigated its protective effect against Ang II-induced cytoskeletal change and hypertrophy in H9c2 cells. The results showed that treating cells with Ang II resulted in pathological hypertrophy, such as increased expression of transcription factors NFAT-3/p-NFAT-3, hypertrophic response genes (atrial natriuretic peptide [ANP] and b-type natriuretic peptide [BNP]), and Gαq down-stream effectors (PLCβ3 and calcineurin). Pretreatment with AOF (60–100 μg/mL) led to significantly reduced hypertrophy. We also found that AOF pretreatment significantly suppressed the cardiac remodeling proteins, metalloproteinase (MMP9 and MMP2), and plasminogen activator, induced by Ang II challenge. In conclusion, we provide evidence that AOF protects against Ang II-induced pathological hypertrophy by specifically inhibiting the insulin-like growth factor (IGF) II/IIR-related signaling pathway in H9c2 cells. AOF might be a candidate for cardiac hypertrophy and ventricular remodeling prevention in chronic cardiovascular diseases.

Bamboo Charcoal/Quick-Dry/Metallic Elastic Knits: Manufacturing Techniques and Property Evaluations

Jia-Horng Lin,Chih Hung He,Mong-Chuan Lee,Yueh-Sheng Chen,Ching-Wen Lou 한국섬유공학회 2019 Fibers and polymers Vol.20 No.7

Protective clothing with electromagnetic shielding effectiveness (EMSE) is a functional textile, which shieldselectromagnetic waves to protect the human body from the far infrared rays. Traditional EMSE garments primarily usemetallic plates for reflecting electromagnetic interference (EMI). However, they also have disadvantages of a heavy weight,easy corrosion, and high production cost. In this study, three different functional yarns are combined, during which the twistnumber of metallic wires is changed for a better shielding effect. A crochet machine is used to fabricate functional elasticknits with the metallic composite yarns as the warp- and weft-inlaid yarns. The test results show that double (D) functionalelastic knits exhibit EMSE of above 20 dB when the EMI are between 1.0 and 3.0 GHz. In addition, the knit structure canimprove breaking tensile strength by 170 % and increases bursting strength by 58 %, but undermines the tear strength by10 %. Although changing twist number of metallic composite yarns does not affect water absorption rate along the weftdirection, it helps increasing elastic recovery rate by 3.1 %, water absorption rate along the warp direction by 106 %, farinfraredemissivity by 2.3 %, water vapor transmission rate by 20 %, and air permeability by 6 %.

Fabrication of a Biodegradable Multi-layered Polyvinyl Alcohol Stent

Mei-Chen Lin,Ching-Wen Lou,Jan-Yi Lin,Ting An Lin,Yueh-Sheng Chen,Jia-Horng Lin 한국섬유공학회 2018 Fibers and polymers Vol.19 No.8

This study aims to develop biodegradable vascular stents that prevent permanent damage caused by rejection of the immune system of the human body. Polyvinyl alcohol (PVA) yarns are twisted to enhance their strength. The twisted yarns are braided and then coated with chitosan (CS). The CS-coated PVA vascular stents are chemically crosslinked with genipin (GP) to improve their flexibility and biodegradability. Their morphological characteristics are also observed using a stereoscopic microscope, and their properties are evaluated through scanning electron microscopy, Fourier transform infrared, bending test, biodegradability test, drug release measurement, and MTT assay. Results reveal that wet PVA-CS-GP vascular stents coated with multiple CS layers can maintain a tubular structure when they are bent. After crosslinking is performed, the compressive strength of the PVA-CS-GP stents is 17.04 times higher than that of pure PVA. The weight loss rate of the PVA-CS-GP vascular stents as <3 % after 30 days. The PVA-CS-GP vascular stents composed of 0.10 % heparin sodium show a good drug release effect. Biological activity test indicates that these stents exhibit good proliferation, and our structural model verifies that they are good vascular stents.