http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
다양한 주행 조건별 병렬형 하이브리드 차량의 연비 성능 분석
권문성,성주연,박성천,임원식 한국기계기술학회 2015 한국기계기술학회지 Vol.17 No.4
The major complaint of hybrid vehicle driver is that real fuel economy is lower than the certified fuel economy. Therefore, it is important to analyze the cause of low fuel economy and to improve the fuel consumption at real driving condition. In this study, the various speed profile is measured by driving urban road with considering different traffic jam. By using backward simulation, the fuel economy characteristics of the acquired driving modes are analyzed. From the simulation results, the operating points of engine and motor analyzed and the cause of decrease of real fuel economy is examined.
권문성,강경희,김대은 한국트라이볼로지학회 2018 한국윤활학회지(윤활학회지) Vol.34 No.6
In this work the friction and wear characteristics of the gray cast iron surface processed by broaching method, which is widely used in the machinery industry, were investigated. The broaching process is mainly used for mass production because it has high dimensional accuracy and processing speed, but the defects on surface can be easily generated. In order to improve the tribological characteristics, the approach was to reduce the roughness and hardness of the surface by adding a machining process to the broaching specimen. The secondary machining process using abrasive grains produces low roughness and hardness than broaching because it has high tool accuracy and removes the work hardened surface. The friction coefficient and the wear rate were assessed using a reciprocating-type tribotester to analyze the effects of surface finishing on the tribological properties. The friction tests were conducted under dry and lubricated conditions. The test results showed that the reduction of surface roughness and hardness through secondary machining process in lubricated condition improved the friction and wear characteristics. The reason why the same results did not appear in a dry condition was that wear occurred more rapidly than in lubricated condition. Thus, the positive effect of roughness and hardness of the surface obtained through the secondary machining process was not observed.