http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
길흥배,강상규,조준상,Gil, Heungbae,Kang, Sang Gyu,Cho, Jun Sang 한국강구조학회 2008 韓國鋼構造學會 論文集 Vol.20 No.1
강재 박스거더교의 바닥틀을 구성하며, 바닥판의 활하중과 고정하중을 지지하는 가로보와 세로보의 설계 합리화를 위한 연구가 수행되었다. 가로보는 일반 거더교의 수직 브레이싱 규정을 근거로 6m 이하의 간격으로 조밀하게 배치되며, 세로보는 가로보 사이에 배치된다. 또한 가로보와 세로보는 바닥판과 슬래브 앵커로 연결되지만, 허용응력은 횡비틀림좌굴의 발생을 고려하여 보수적으로 결정 된다. 강박스거더교의 경제성을 도모하고 가설 및 유지관리시의 편의성을 증진시키기 위하여 가로보의 간격을 10m로 증가시켜 세로보와 가로보 의 단면 및 이음부 설계에 대해 검토하였다. 세로보의 지간이 증가함에 따라 응력이 증가하여 고강도의 강재를 사용해야 하지만, 제작 및 유지관리면에서 세로보의 지간을 증가시키는 것이 바람직하며, 경제적으로도 유리할 것으로 판단된다. 바닥판과 세로보 및 가로보의 부착 강도를 충분히 확보하기 위해서는 기존에 사용되고 있는 슬래브 앵커 보다는 전단연결재를 활용하는 것이 바람직한 것으로 판단된다. This research carried out to optimize crossbeams and stringers of steel box girder bridges, which are parts of floor system and support loading from the bridge deck. In the current design practice, the crossbeam is densely deployed with a spacing of 6 meters, and the stringer is placed between the crossbeams. The crossbeams and stringer are connected to the deck through slab anchors but the allowable stress of the compression flange is determined by the lateral-torsional buckling. To increase economic efficiency of the steel box girder bridges. the increased spacing of the crossbeam was studied. The study shows that the spacing can be increased up to 10 meters. However, higher strength steel plates are necessary. Shear studs rather than slab anchors are also recommended to prevent lateral-torsional buckling strength of the crossbeams and stringer.
마찰복원형 지진격리장치가 설치된 케이블교량의 성능 기반 내진설계법 개선(II-내진설계 절차 제안)
길흥배,박선규,한경봉,윤완석,Gil, Heungbae,Park, Sun Kyu,Han, Kyoung Bong,Yoon, Wan Seok 한국지진공학회 2020 한국지진공학회논문집 Vol.24 No.4
In a previous paper, ambient vibration tests were conducted on a cable stayed bridge with resilient-friction base isolation systems (R-FBI) to extract the dynamic characteristics of the bridge and compare the results with a seismic analysis model. In this paper, a nonlinear seismic analysis model was established for analysis of the bridge to compare the difference in seismic responses between nonlinear time history analysis and multi-mode spectral analysis methods in the seismic design phase of cable supported bridges. Through these studies, it was confirmed that the seismic design procedures of the "Korean Highway Bridge Design Code (Limit State Design) for Cable Supported Bridges" is not suitable for cable supported bridges installed with R-FBI. Therefore, to reflect the actual dynamic characteristics of the R-FBI installed on cable-supported bridges, an improved seismic design procedure is proposed that applies the seismic analysis method differently depending on the seismic isolation effect of the R-FBI for each seismic performance level.
길흥배,강상규,Gil, Heungbae,Kang, Sang Gyu 대한토목학회 2013 대한토목학회논문집 Vol.33 No.5
교량의 내구성과 설계수명 평가에 있어 대형화물차와 같은 중차량의 총중량 크기와 분포 특성은 큰 영향을 미치며, 총중량의 특성은 WIM 시스템에서의 측정 데이터를 활용하여 파악하고 있다. 고속도로상에 설치된 고속 WIM 시스템을 통해 측정된 중차량의 분포를 분석한 결과, 대부분의 중차량은 7종, 10종, 12종 화물차에서 발생하였다. 이들 화물차의 전체적인 총중량 분포와 상위 총중량 분포에 대한 확률분포 모델을 추정하였다. 전체적인 총중량 분포는 정규확률 분포에 근접하는 것으로 분석되었으며, 상위 10% 데이터는 극치분포의 하나인 Weibull 3 확률분포에 가장 높은 적합도를 갖는 것으로 나타났다. The design life and durability of the bridges are strongly affected by the Gross Vehicle Weight(GVW) of heavyweight trucks. The Weigh-In-Motion(WIM) systems are typically used to collect information on truck total weight and speed. The statistical analysis of the GVW measured using High Speed WIM systems showed that most of heavy vehicles were from Vehicle Type 7, 10, and 12. The analysis was also carried out to determine goodness of fit with theoretical probability distributions. The normal distribution was shown to best describe the overall distribution of GVW. The top 10% of the GVW appeared to best fit by the Weibull 3 probability distribution.