http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
전산유체역학을 이용한 직접 접촉식 히트파이프의 응축부 형상에 따른 성능비교
고요한(Ko Yo-han),강경문(Kang Kyung-Mun),서태범(Seo Tae-Beom) 한국태양에너지학회 2008 한국태양에너지학회 학술대회논문집 Vol.- No.-
The purpose of this study is to compare the different shapes of condenser of the direct contact heat transfer from the heat pipe condenser to the receiving water using CFD. The heat transfer from the working fluid of the heat pipe to receiving fluid flows through the manifolder is one of the important part in evacuated solar collector system. The retrenchment of the thermal resistance between the heat pipe and the manifolder could increase the thermal performances of the whole system. Recently, direct heat transfer from the heat pipe condenser wall to the receiving water was suggested and accompanied experiments were achieved. This experiment shows the better performances of the direct contact hear transfer analogically. Preceding calculations are carried out for the performance comparison: mesh dependence test, discretization method test and equation model test. with these preceding tests, 4 different shapes of condenser are compared and each case were set up for the same heat flux at the condenser wall. The calculation result shows that the efficiency of the extended surface condenser shape is 10% higher then the that of the others.
배열안테나 패턴 측정 거리에 따른 방향탐지, 간섭제거, 빔형성 성능 분석
고요한 ( Yo-han Ko ),강행익 ( Haeng-ik Kang ),이철수 ( Chul-soo Lee ),김도경 ( Do-kyung Kim ),김갑진 ( Kap-jin Kim ),박영범 ( Young-bum Park ) 한국항행학회 2017 韓國航行學會論文誌 Vol.21 No.6
본 논문에서는 배열안테나의 패턴을 측정하기 위한 배열안테나와 기준 신호원 사이의 거리에 따른 방향탐지, 간섭제거, 빔형성 성능을 분석한다. 배열안테나는 무선통신, 레이더, 소나 등 다양한 분야에서 사용되고 있다. 이러한 배열안테나를 사용하기 위해서는 배열안테나의 패턴을 알고 있어야 하며, 배열안테나의 패턴은 무반향 챔버에서 측정을 통해 얻을 수 있다. 하지만 무반향 챔버의 크기는 제한적이기 때문에 거리에 따른 측정 오차가 발생하게 된다. 이는 배열안테나를 사용하는 방향탐지, 간섭제거, 빔형성의 성능 저하를 유발시킨다. 본 논문에서는 컴퓨터 모의실험을 통해서 배열안테나 패턴 측정 거리에 따른 방향탐지, 간섭제거, 빔형성 성능을 분석하여 결과를 제시한다. This paper analyzes the performances of direction finding, interference cancellation, and beamforming performance by array antenna pattern measurement distance between the center of array antenna and reference emitter. Array antenna is widely adopted for example as wireless communications, radar, and sonar. In order to use array antenna, array antenna pattern must be known and it can be measured in anechoic chamber. However, the size of anechoic chamber is generally limited. So measurement error of array antenna can be occurred and this could effect performance decrease of direction finding, interference cancellation, and beamforming. It is verified by computer simulation that the performances of direction finding, interference cancellation, and beamforming by array antenna pattern measurement distance.
고요한,박창환,박경원,전원기,백종호,이석필,조용수,Ko, Yo-Han,Park, Chang-Hwan,Park, Kyung-Won,Jeon, Won-Gi,Paik, Jong-Ho,Lee, Seok-Pil,Cho, Yong-Soo 한국통신학회 2009 韓國通信學會論文誌 Vol.34 No.4
본 논문에서는 OFDMA(Orthogonal Frequency Division Multiple Access) 기반 동기식 디지털 이중화(Synchronous Digital Duplexing) 방식에 적합한 그룹핑 기법을 제안한다. SDD 방식은 상호 레인징(mutual ranging) 과정을 통해 획득한 상호 시간 정보와 상호 채널 정보를 이용하여 상 하향링크 신호를 동시에 전송 가능하기 때문에 자원 할당의 유연성과 데이터 전송 효율이 증가하는 장점을 갖는다. 그러나 AP(access point)와 각 SS(subscriber station), SS와 다른 SS 사이의 상호 시간 지연과 상호 채널 길이의 합이 CP(cyclic prefix) 길이보다 긴 경우에는 OFDMA 심볼의 직교성을 유지하기 위해 추가의 CS(cyclic suffix)를 삽입해야하는 단점이 있다. 본 논문에서는 SDD 방식에서 추가의 CS가 필요한 경우에 CS 길이를 최소화하기 위하여 셀 내에 존재하는 AP 혹은 SS를 그룹으로 구분하여 송수신 시간을 제어하는 그룹핑 기법을 제안하며, 모의실험을 통해 성능을 비교 분석한다. In this paper, we propose a grouping technique for the SDD(Synchronous Digital Duplexing) based on OFDMA(Orthogonal Frequency Division Multiple Access). The SDD has advantages of increasing data efficiency and flexibility of resource since SDD can transmit uplink signals and downlink signals simultaneously by using mutual time information and mutual channel information, obtained during mutual ranging process. However, the SDD has a disadvantage of requiring additional CS to maintain orthogonality of OFDMA symbols when the sum of mutual time difference and mutual channel length between AP(access point) and SS(subscriber station) or among SSs are larger than CP length. In order to minimize the length of CS for the case of requiring additional CS in SDD, we proposes a grouping technique which controls transmit timing and receive timing of AP and SS in a cell by classifying them into groups. Performances of the proposed grouping technique are evaluated by computer simulation.
고요한(Yo Han Ko),박창환(Chang Hwan Park),박경원(Kyung Won Park),전원기(Won Gi Jeon),백종호(Jong Ho Paik),이석필(Seok Pil Lee),조용수(Yong Soo Cho) 한국통신학회 2009 韓國通信學會論文誌 Vol.34 No.4C
본 논문에서는 OFDMA(Orthogonal Frequency Division Multiple Access) 기반 동기식 디지털 이중화(Synchronous Digital Duplexing) 방식에 적합한 그룹핑 기법을 제안한다. SDD 방식은 상호 레인징(mutual ranging) 과정을 통해 획득한 상호 시간 정보와 상호 채널 정보를 이용하여 상ㆍ하향링크 신호를 동시에 전송 가능하기 때문에 자원 할당의 유연성과 데이터 전송 효율이 증가하는 장점을 갖는다. 그러나 AP(access point)와 각 SS(subscriber station), SS와 다른 SS 사이의 상호 시간 지연과 상호 채널 길이의 합이 CP(cyclic prefix) 길이보다 긴 경우에는 OFDMA 심볼의 직교성을 유지하기 위해 추가의 CS(cyclic suffix)를 삽입해야하는 단점이 있다. 본 논문에서는 SDD 방식에서 추가의 CS가 필요한 경우에 CS 길이를 최소화하기 위하여 셀 내에 존재하는 AP 혹은 SS를 그룹으로 구분하여 송ㆍ수신 시간을 제어하는 그룹핑 기법을 제안하며, 모의실험을 통해 성능을 비교 분석한다. In this paper, we propose a grouping technique for the SDD(Synchronous Digital Duplexing) based on OFDMA(Orthogonal Frequency Division Multiple Access). The SDD has advantages of increasing data efficiency and flexibility of resource since SDD can transmit uplink signals and downlink signals simultaneously by using mutual time information and mutual channel information, obtained during mutual ranging process. However, the SDD has a disadvantage of requiring additional CS to maintain orthogonality of OFDMA symbols when the sum of mutual time difference and mutual channel length between AP(access point) and SS(subscriber station) or among SSs are larger than CP length. In order to minimize the length of CS for the case of requiring additional CS in SDD, we proposes a grouping technique which controls transmit timing and receive timing of AP and SS in a cell by classifying them into groups. Performances of the proposed grouping technique are evaluated by computer simulation.