http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
김향곤(Hyang-Kon Kim),김동욱(Dong-Ook Kim),김동우(Dong-Woo Kim),이기연(Ki-Yeon Lee) 대한전기학회 2009 대한전기학회 학술대회 논문집 Vol.2009 No.4
본 연구에서는 화재시 재실자의 안전한 피난을 유도하는 피난유도시설의 설치기준과 지하철역사, 대형편의점(마트), 종합병원 등 의료시설, 학교 등 교육시설과 같은 불특정 다수의 사람이 이용하는 건축물에 설치된 피난 유도동의 현장적용사례와 유지관리 실태를 조사하였다. 이러한 건축물에서 재실자의 피난에 영향을 미치는 요소, 예상되는 인명 안전 등에 대하여 분석하여 문제점을 도출하였다. 본 연구결과는 기존의 소방시스템의 문제점으로 지적되고 있는 화재 발생 위치와 확산 경로에 관계없이 획일적으로 피난 방향을 표시하고 있는 시스템의 개선을 위한 최적의 피난 경로를 표시하는 인공지능형 방향성 유도등 개발에 활용할 것이다.
수중에서의 LED 조명용 DC 전로의 누전 특성에 관한 연구
김향곤(Hyang-Kon Kim),길형준(Hyoung-Jun Gil),김동우(Dong-Woo Kim),문현욱(Hyun-Wook Moon),최효상(Hyo-Sang Choi) 대한전기학회 2010 대한전기학회 학술대회 논문집 Vol.2010 No.11
본 연구에서는 LED 가로등 및 경관조명의 DC 전로가 수중에서 누전되었을 때의 전기적 특성과 LED 조명의 동작 특성에 대하여 실험, 분석하였다. 분석결과, 컨버터(전원공급장치)의 구조(절연형, 비절연형)에 따라 누전에 있어 전기적 특성에 차이가 있었다. 특히, 비절연형 컨버터의 경우, 수중에서의 누전에 의해 누설전류가 접지극을 통하여 흘렀으며, 컨버터의 출력전압의 크기에 따라 +극 또는 -극과 접지극(판)의 접촉시 수중에서 아크가 발생함을 확인할 수 있었다 교류를 직류로 변환하여 공급하는 DC 전로에서서의 감전사고 예방을 위하여 LED 조명에 사용되는 컨버터는 반드시 절연형의 것을 사용하는 것이 필요하다. 앞으로 DC 누전 이외의 단락, 접촉불량 등 전기적 이상에 대한 지속적인 연구와 기술 개발이 필요하다.
친환경자동차의 인체 안전을 위한 전기적 연속성 측정 연구
김향곤(Hyang-Kon Kim),이기연(Ki-Yeon Lee),김동욱(Dong-Ook Kim),최효상(Hyo-Sang Choi) 대한전기학회 2009 전기학회논문지 P Vol.58 No.3
In this study, we analyzed and experimented about electric continuity for human body safety from green cars. And we compared power systems of HEV and examined about human body effect of current and time. We investigated internal and external standards and regulations for human body safety from high voltage electrical equipments. Indirect contact refers to contact between the human body and exposed conductive parts. According to UNECE R100, ISO 23273-3, ISO 6469-3 and Japanese Regulation Attachment 101, electric continuity between any two exposed conductive parts shall not exceed 0.1Ω. The value of electric continuity was measured below 0.1Ω at the actual condition of green car. We expected that the results of these experiments can utilize to data for electrical safety of green car.
옥외용 LED 가로등 및 보안등의 전력변환방식에 따른 출력 특성 분석
김향곤(Hyang-Kon Kim),김동욱(Dong-Ook Kim),김동우(Dong-Woo Kim),문현욱(Hyun-Wook Moon),최효상(Hyo-Sang Choi) 대한전기학회 2010 대한전기학회 학술대회 논문집 Vol.2010 No.4
본 연구에서는 LED 가로등 및 보안등의 전력변환장치(컨버터)의 구성에 따른 전기적 특성을 비교, 분석하였다. 실험결과, 별도의 외합을 갖는 외장형 컨버터의 출력특성이 양호한 것을 알 수 있었다. 주로 조명등기구 내부에 일체형으로 부착되는 트로이달 코일과 전력전자소자의 조합 또는 소형트랜스, 콘덴서, 전력전자소자로 조합되는 전력변환장치의 경우, 1차측의 전압, 전류 파형에 왜곡이 있었으며, 2차측의 출력전압과 전류파형에 있어서도 영점을 갖는 반파나 톱니파형을 나타냄을 볼 수 있었다. 이러한 전기적 특성은 LED 조명설비의 깜빡거리는 현상과 역륜, 성능, 수명에도 영향을 줄 것이다. 따라서, LED 조명의 특성에 적합한 컨버터의 성능 향상을 위한 지속적인 기술개발이 요구된다.
PL에 근거한 LED 가로등의 결함 요소 발굴 및 분석
김향곤(Hyang-Kon Kim),최충석(Chung-Seog Choi) 대한전기학회 2009 전기학회논문지 P Vol.58 No.4
The purpose of this study is to present the range of defects mentioned in the Product Liability (PL) and to establish an objective basis and grounds for the analysis of accidents expected to happen by analyzing and presenting the external flame pattern and electrical characteristics of an LED streetlight lamp, a new lighting lamp. From the analysis of the cross-section of a cable carbonized by an external flame, it was observed that the wire’s strand and insulation material had solidly adhered, and that greater voids were formed at the surface than at the center. Irregular carbide lumps were formed in the globe directly exposed to the flame, and the globe carbonized by the indirect flame showed characteristics that they had melted and flowed downward. It was found that the forward and backward resistances of the normal LED were approximately 1.74 [㏁] and 140 [㏁], respectively. The lamp burnt by the strong flame exhibited infinite forward and backward resistances and the LED did not emit light. The carbonized LED lamp was gray and exhibited fine delaminations. According to the Product Liability, a product defect signifies a simple product defect. Most of the defects were caused by the lack of stability, and the defect of the product itself occurred during the design and manufacture. The defects in warnings and markings include an insufficiency of handling manuals and warnings, expressive warranty violations, defective markings, etc. In order to prevent an accident resulting from a product, it is necessary to prepare safety warnings and documentation, establish clear-cut lines of liabilities, and subscribe insurances. However, it could be seen that important factors against the Product Liability were product improvement, response to compensation requests and law suits, credit restoration, etc.
비닐절연코드의 기계적 피로에 의한 소손패턴 및 화재위험성 분석
김향곤(Hyang-Kon Kim),김동욱(Dong-Ook Kim),김형준(Hyoung-Jun Gil),김동우(Dong-Woo Kim),최효상(Hyo-Sang Choi) 대한전기학회 2009 대한전기학회 학술대회 논문집 Vol.2009 No.4
본 논문에서는 비닐절연코드의 기계적 피로에 의한 소손패턴과 화재위험성에 대하여 실험, 분석하였다. 비닐절연코드는 2중의 절연피복으로 되어 있으며 도체는 여러 가닥의 소손들로 구성되어 있다. 비닐코드는 반복적인 구부림이나 인장등 기계적 피로에 의해 피복 내 도체가 손상을 입게 되며 전기가 흐르고 있는 상태에서 끊어진 소선들이 접촉과 끊어짐을 반복함으로써 아크와 열이 발생하며 이때 발생한 아크와 열에 의해 피복이 탄화되어 결국에는 착화됨을 볼 수 있었다. 이러한 기계적 피로에 의한 국부 발열과 화재 예방을 위한 기술개발이 필요한 것으로 사료된다.
DC 전원설비 접속부에서의 접촉불량에 의한 발열특성 분석
김향곤(Hyang-Kon Kim),문현욱(Hyun-Wook Moon),이기연(Ki-Yeon Lee),김동우(Dong-Woo Kim),최효상(Hyo-Sang Choi) 대한전기학회 2009 대한전기학회 학술대회 논문집 Vol.2009 No.7
본 논문에서는 DC전원설비 접속부에서의 접촉불량에 의한 발열 특성에 대하여 실험, 분석하였으며 사용된 DC 전원설비는 상용 교류전원을 직류전원으로 변환하는 AC/DC 컨버터의 출력전원을 이용하는 LED 가로등 조명설비의 전원 접속부을 대상으로 하였다. 외부의 기계적 진동에 의해 동전선 접속부에 아크와 열이 발생하며 이때 발생한 발열 온도와 열 분포를 측정하였으며 적열부가 형성된 후 25분이 경과하였을 때 최고 842.68℃까지 온도가 상승하였으며 접속부의 접촉전압은 1.5~1.6V, 통전전류는 6.6~6.9A로 약간의 변화만 나타남을 볼 수 있었다. 또한 DC전원에서 동전선 접속부에서의 산화물 생성과 증식 거동에 대하여 분석하였으며 AC전원에서와 유사하게 산화물이 형성되어 성장함을 볼 수 있었다. 이러한 실험과 분석 결과는 향후, DC 전원설비에서의 전기화재 예방을 위한 자료로 활용 가능할 것으로 기대된다.