http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
허광희,이처근,허열,Heo, Gwang-Hee,Lee, Cheo-Keun,Heo, Yol 한국지반공학회 1995 지반 : 한국지반공학회지 Vol.11 No.3
WIPP에서 가스로 인한 파괴의 가능성을 해석적 계산과 수치해석 및 실내실첩을 통하여 연구하였다. 우선 본 연구와 관련된 화학반응식을 조사한 결과, 폐기물 내의 철이 산화하면서 다량의 가스가 발생될 수 있음을 알았다. 또한 간단한 지하수 흐름의 계산결과, 투수성이 높은 파쇄영역이 존재하지 않는 경우 이 가스량은 암염 내부와 약한 수평면에 인장균열을 초래하기에 충분히 높은 압력을 야기시킬 것이다. 해석적 계산은 선형탄성파괴역학의 개념을 사용하여 수행하였고, 수치해석은 유한요소법을 사용하여 행하였다. 또한 실내실험은 발생가능한 파괴 메카니즘을 설명하기 위하여 행하였다. 해석결과 약한 경석고층에서 수평으로 균열이 증가된 뒤에 그 균열은 이 층을 뜰고나가 암염 위쪽으로 계속 전폭되어 지표면 쪽의 수평방향과 53$^{\circ}$경사각을 갖고 지표면에 도달된다. 이와 같은 후자의 현상을 방지하기 위하여 경석고는 암염의 인성보다 0.5590배가 적은 파괴인성을 가져야 하는 것으로 나타났다. 실험결과 세 가지 형태의 균열(radial vertical cracks, horizontal circular cracks and cone -shaped cracks)이 관찰되었다. The possibility of the development of gas driven hydrofractures at the Waste Isolation Pilot Plant(WIPP) is investigated through analytical and numerical calculations and through laboratory experiments. First, an investigation of the chemical reactions involved shows that a large volume of gas could potentially be generated through the oxidation of iron in the waste. Simple ground water'flow calculations then show that unless regions of high permeability has been created, this gas volume will build up the pressure high enough to cause tensile damage in the horizontal planes of weakness or in the halite itself. The analytical calculations were performed using the concepts of linear elastic fracture mechanics and the numerical calculations were done using the finite element method. Also, laboratory tests were conducted to illustrate possible failure mechanisms. It is possible that after growing horizontal crack in the weaker anhydride layer, the crack could break out of this layer and propagate upward into the halite and toward the ground surface at an inclined argle of around 53$^{\circ}$ above horizontal. To prevent this latter phenomenon the anhydrite must have a fracture toughness less than 0.5590 times than that of the halite. Through the tests, three types of crack(radial vertical cracks, horizontal circular cracks and cone -shaped cracks) were observed.
SIF Calibration of Iosipescu Beam Using Stiffness Derivative Method
허광희,윤일로,Heo, Gwang-Hee,Yoon, Il-Ro 한국구조물진단유지관리공학회 1997 한국구조물진단유지관리공학회 논문집 Vol.1 No.2
Iosipescu Beam은 혼합 모드의 파괴 거동에 관하여 자주 이용되고 있는 보 중에 하나이다. 이 연구의 주요 목적은 Iosipescu 보의 모드 II 파괴계수(SIF)를 수치적 실험을 통하여 결정하는데 있다. 이 특별한 연구의 목적에 맞게 강도계수를 구하기 위하여 강성도법이 유도되고, 다양한 종류의 Iosipescu 보의 분석이 이루어진다. 수치적 실험을 위해 요구되어지는 정해를 얻기 위한 기술이 논의된다. 또한 이 수치 실험을 위하여 필요로 되어지는 Mesh의 기준과 요구되어지는 정해도를 위한 수렴 테스트를 실시한다. 약 500 개의 데이터 세트가 분석되어 결과가 이용하기 쉬운 약산식으로 유도되었다.
허광희,전승곤,서상구,김대혁,Heo, Gwang Hee,Jeon, Seung Gon,Seo, Sang Gu,Kim, Dae Hyeok 한국지진공학회 2019 한국지진공학회논문집 Vol.23 No.4
In this study, SMG(Smart Material with Grease) was developed, which was improved the precipitation minute particle in grease during long term standstill. Also, small-sized cylinder damper equipped with an electromagnet in a piston was developed for using a performance evaluation of the damper with SMG and the dynamic load test, and damping force using Power model and Bingham model was derived in order to compare to the result of that of the damper. The data obtained from the dynamic load test were analyzed and plotted, and then a dynamic range was calculated to evaluate the usability of the damper with SMG. The performance of the damper with SMG was compared to the damping forse derived from the Power and Bingham model. The result of this evaluation shown that the usability of SMG damper was demonstrated by this test as a semi-active controlling equipment of small-sized damper.
Diagnosis Techniques of Large Structural System Based on Measured Dynamic Properties
허광희,최만용,Heo, Gwang Hee,Cho, Man Yong 한국구조물진단유지관리공학회 1999 한국구조물진단유지관리공학회 논문집 Vol.3 No.1
구조물에 손상이 발생하게 되면 동적특성이 변하게 된다. 그러므로 이와 갈은 특성을 계측하여 구조물의 손상된 정도를 평가하게 되면 이를 상시감시에 활용할 수가 있다. 대표적인 손상기술들을 제작된 모형교량에 서로 다른 경계조건을 구현하여 손상도를 Simulation을 이용하여 결정하고 가장 적법한 방법과 대책을 연구했다. 모형교량은 I-DEAS의 Normal Mode Dynamic Solver를 이용하여 분석 제작되어 계측과 비교평가 되어 손상기술에 적용되었다. 24개의 가속도 감지기를 이용하여 데이터를 획득하였고, Residue법으로 모달인자를 추출하였다. 추출된 동적인자가 상시감시에 적용하도록 구조물의 손상검출기술을 제안한다
A Dynamic Characterization of Long Span Bridge Using Mean FRF
허광희,최만용,안병익,Heo, Gwang-Hee,Choi, Man-Yong,An, Byung-lk 한국구조물진단유지관리공학회 2000 한국구조물진단유지관리공학회 논문집 Vol.4 No.1
구조물의 동특성은 대형구조물을 상시감시 할 수 있는 장점으로 인하여 널리 활용된다. 상시감시를 위해 계측된 랜덤 데이터는 FFT를 통한 구조물의 동적 고유특성을 분석함으로써 이루어진다. 이 과정에서 Input Data와 Response Data사이에서 FFT Analyzer를 통하여 FRF가 측정된다. 특히 랜덤 데이터의 계측은 여건과 환경에 따라 발생하는 Noise로부터 가능한 정확한 FRF를 계측해야만 성공적인 구조물의 고유의 동적특성을 파악하게 된다. 랜덤 데이터에서 발생할 가능성이 높은 입력, 출력 Noise를 동시에 최소화 할 수 있는 새로운 개념의 FRF측정 알고리즘을 제안한다. 이 알고리즘에 의하여 장대형 모형교량으로부터 Modal 실험을 수행하여 계측된 동특성을 FE 해석 결과와 비교 평가하여 유용성을 제시한다.
PVA 섬유와 VAE 분말 폴리머를 사용한 시멘트복합체의 압축·휨강도 및 온도변화에 따른 충격파괴거동
허광희,박종건,김충길,이형준,최원석,Heo, Gwang-Hee,Park, Gong-Gun,Kim, Chung-Gil,Lee, Hyung-Joon,Choi, Won-Seok 한국구조물진단유지관리공학회 2019 한국구조물진단유지관리공학회 논문집 Vol.23 No.1
본 연구는 PVA(polyvinyl alcohol) 섬유와 VAE(vinyl acetate ethylene) 분말 폴리머를 사용한 시멘트복합체의 압축 휨강도 와 온도변화에 따른 충격파괴거동을 연구하였다. 충격시험은 $-35^{\circ}C$, $0^{\circ}C$ 및 $35^{\circ}C$의 선정된 온도조건에서 실시하였다. 본 실험에서는 시멘트 복합체와 일반 모르타르에 대한 충격파괴 에너지와 변위, 시간을 얻기 위해 낙하 충격시험기(Ceast 9350)를 사용하여 충격시험을 수행하였다. 강도시험결과, PVA 섬유와 VAE 분말 폴리머의 휨강도는 모두 증가하였다. PVA 섬유보강 시멘트복합체의 경우 재령 28일에서의 압축강도는 약간 감소하였으나, 휨강도는 일반 모르타르 강도보다 24.4% 증가하였다. 낙하 충격시험 결과, PVA 섬유보강 시멘트복합체 시편은 섬유의 가교역할로 인한 균열발생의 억제와 에너지 분산에 의한 미세균열이 발생하였으며, 충격에 의한 배면파괴와 관통에 대하여 억제되었다. 반면 VAE 분말 폴리머 시멘트복합체와 일반 모르타르의 시편은 대부분 큰 균열이나 관통파괴 되었다. 충격하중을 받는 시멘트복합체와 일반 모르타르의 시편은 대부분 국부적인 취성파괴거동을 보이며, PVA 섬유보강에 의한 휨성능 증진으로 인해 충격에 대한 저항성능이 크게 향상되었다. This paper studies impact fracture behavior under temperature variation and compressive flexural strength of cement composites using VAE(vinyl acetate ethylene) powder polymer and PVA(polyvinyl alcohol) fiber. Impact test were conducted in the temperature range selected for the $-35^{\circ}C$, $0^{\circ}C$ and $35^{\circ}C$. In this experimental study, impact test were carried out using a drop impact testing machine (Ceast 9350) to obtain such as displacement, time, and impact fracture energy of normal specimen and and cement composites specimen. As test results, the use of VAE powder polymer and PVA fiber were observed to enhance the flexural strength of mortar. The compressive strength of PVA fibers reinforced cement composites was slightly decreased at 28 days, but the flexural strength was observed to increase 24.4% of normal mortar strength. As a result of the drop impact tests, PVA fiber reinforced cement composites specimens showed microcracks due to energy dispersion and crack prevention with bridge effect of the fibers, and scabbing or perforation by impact was suppressed. On the other hand, the normal mortar and VAE powder polymer cement composites specimens were carried out to the perforation and macro crack. Most of normal mortar and the cement composites subjected to impact load on specimens shows mostly local brittle failure. The impact resistant performance of the specimen with PVA fiber was greatly improved due to the increase of flexure performance.