http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
박기정(Ki-Jung Park),이철희(Cheol-Hee Lee),정동수(Dongsoo Jung) 대한설비공학회 2008 설비공학 논문집 Vol.20 No.9
In this study, performance of R170/R290 mixtures is measured on a heat pump bench tester in an attempt to substitute R22. The bench tester is equipped with a commercial hermetic rotary compressor providing a nominal capacity of 3.5 ㎾. All tests are conducted under the summer cooling and winter heating conditions of 7/45℃ and -7/41 ℃ in the evaporator and condenser respectively. During the tests, the composition of R170 is varied from 0 to 10% with an interval of 2%. Test results show that the coefficient of performance (COP) and capacity of R290 are up to 15.4% higher and 7.5% lower than those of R22 for both conditions respectively. For R170/R290 mixture, the COP decreases and the capacity increases with an increase in the amount of R170. The mixture of 4%R170/96%R290 shows the similar capacity and COP as those of R22. For the mixture, the compressor discharge temperature is 16~30℃ lower than that of R22. There is no problem with mineral oil since the mixture is mainly composed of hydrocarbons. The amount of charge is reduced up to 58% as compared to R22. Overall, R170/R290 mixture is a good long term 'drop-in'. candidate to replace R22 in residential air-conditioners and heat pumps.
평활관과 낮은 핀관에서 R245fa의 풀 비등 열전달계수
박기정(Ki-Jung Park),이요한(Yohan Lee),임병덕(Byeongdeok Lim),정동수(Dongsoo Jung) 대한설비공학회 2011 설비공학 논문집 Vol.23 No.3
In this work, pool boiling heat transfer coefficients(HTCs) of R22, R123, R134a, and R245fa are measured on both horizontal plain and 26 fpi low fin tubes. The pool boiling temperature is maintained at 7℃ and heat flux is varied from 80 ㎾/㎡ to 10 ㎾/㎡ with an interval of 10 ㎾/㎡. Wall temperatures are measured directly by thermocouples inserted through holes of 0.5 ㎜ diameter. Test results show that HTCs of high vapor pressure refrigerants are usually higher than those of low pressure fluids in both plain and low fin tubes. On a plain tube, HTCs of R245fa are 23.3% higher than those of R123 while on a 26 fpi low fin tube, HTCs of R245fa are 46.3% higher than those of R123. The fin effect is more prominent with low vapor pressure refrigerants than with high vapor pressure ones due to a sweeping effect.
대체냉매 R430A를 적용한 정수기 냉동시스템의 성능 평가
박기정(Ki-Jung Park),이요한(Yohan Lee),정동수(Dongsoo Jung),김경기(Kyoung-kee Kim) 대한설비공학회 2009 설비공학 논문집 Vol.21 No.2
In this study, thermodynamic performance of R430A is examined both numerically and experimentally in an effort to replace HFC134a used in the refrigeration system of domestic water purifiers. Even though HFC134a is used predominantly in such a system these days, it needs to be phased out in the near future in Europe and most of the developed countries due to its high global warming potential. To solve this problem, cycle simulation and experimental measurements are carried out with a new refrigerant mixture of 76%H152a/24% H600a using actual domestic water purifiers. This mixture is numbered and listed as H430A by ASHRAE recently. Test results show that the system performance with R430A is greatly influenced by the amount of charge due to the small internal volume of the refrigeration system of the domestic water purifiers. With the optimum amount of charge of 21 to 22 grams, about 50% of HFC134a, the energy consumption of R430A is 13.4% lower than that of HFC 134a. The compressor dome and discharge temperatures and condenser center temperature of R430A are very similar to those of HFC134a at the optimum charge. Overall, R430A, a new long term environmentally safe refrigerant, is a good alternative for HFC134a requiring little change in the refrigeration system of the domestic water purifiers.
탄소나노튜브 적용 나노유체의 임계 열유속까지의 비등 열전달계수
박기정(Ki-Jung Park),이요한(Yohan Lee),정동수(Dongsoo Jung),심상은(Sang Eun Shim) 대한기계학회 2011 大韓機械學會論文集B Vol.35 No.7
본 연구에서는 순수 물에 탄소나노튜브를 분산시킨 나노유체를 작동유체로 하여 60℃에서 정사각형 구리평면 히터를 이용하여 핵 비등 열전달계수와 임계 열유속을 측정하였다. 탄소나노튜브의 체적비는 0.0001%, 0.001%, 0.01%까지 변화시켜 실험을 수행하였다. 탄소나노튜브는 고분자 물질을 사용하여 분산시키지 않고 탄소나노튜브에 직접 산화처리를 하여 분산시켰다. 실험 결과 나노유체의 열전달계수는 순수 물과 비교해 모든 체적비에서 증가하였다. 산화 처리를 한 탄소나노튜브는 비등이 일어나는 동안 열 경계층 안에서 열전도도가 큰 탄소나노튜브가 침착되지 않고 열전달 표면에 자주 접촉함으로써 열 경계층을 교란시켜 비등 열전달을 촉진시키는 것으로 사료된다. 임계 열유속은 체적비 0.001%에서 순수 물의 결과에 비해 150%까지 증가하였다. 이는 열전달 표면에서 탄소나노튜브가 매우 얇게 침착되어 생긴 나노 막으로 인해 거대한 기포막의 형성이 억제되고 핵 비등이 높은 열유속에서도 지속되어 임계 열유속이 증가하는 것으로 판단된다. In this study, the nucleate pool boiling heat transfer coefficients (HTCs) and critical heat flux (CHF) for a smooth and square flat heater in a pool of pure water with and without carbon nanotubes (CNTs) dispersed at 60℃ were measured. Tested aqueous nanofluids were prepared using CNTs with volume concentrations of 0.0001%, 0.001%, and 0.01%. The CNTs were dispersed by chemically treating them with an acid in the absence of any polymers. The results showed that the pool boiling HTCs of the nanofluids are higher than those of pure water in the entire nucleate boiling regime. The acid-treated CNTs led to the deposition of a small amount of CNTs on the surface, and the CNTs themselves acted as heat-transfer-enhancing particles, owing to their very high thermal conductivity. There was a significant increase in the CHF? up to 150%?when compared to that of pure water containing CNTs with a volume concentration of 0.001%. This is attributed to the change in surface characteristics due to the deposition of a very thin layer of CNTs on the surface. This layer delays nucleate boiling and causes a reduction in the size of the large vapor canopy around the CHF. This results in a significant increase in the CHF.
박기정(Ki-Jung Park),정동수(Dongsoo Jung) 대한설비공학회 2008 설비공학 논문집 Vol.20 No.9
In this work, pool boiling heat transfer coefficients(HTCs) of 5 refrigerants of differing vapor pressure are measured on horizontal smooth square surface of 9.52 ㎜ length. Tested refrigerants are R123, R152a, R134a, R22, and R32 and HTCs are taken from 10 ㎾/㎡ to critical heat flux of each refrigerant. Wall and fluid temperatures are measured directly by thermocouples located underneath the test surface and by thermocouples in the liquid pool. Test results show that pool boiling HTCs of refrigerants increase as the heat flux and vapor pressure increase. This typical trend is maintained even at high heat fluxes above 200 ㎾/㎡. Zuber's prediction equation for critical heat flux is quite accurate showing a maximum deviation of 21% for all refrigerants tested. For all refrigerant data up to the critical heat flux, Stephan and Abdelsalam's well known correlation underpredicted the data with an average deviation of 21.3% while Cooper's correlation overpredicted the data with an average deviation of 14.2%. On the other hand, Gorenflo's and lung et al's correlation showed only 5.8% and 6.4% deviations respectively in the entire nucleate boiling range.
R1234yf와 R1234yf/R134a의 자동차 에어컨 작동 조건에서의 성능 평가
박기정(Ki-Jung Park),이요한(Yohan Lee),최대성(Daeseong Choe),정동수(Dongsoo Jung) 대한설비공학회 2010 설비공학 논문집 Vol.22 No.12
In this study, performance of R1234yf and R1234yf/R134a mixture is measured on a heat pump bench tester in an attempt to substitute R134a used widely in mobile air conditioners (MACs). The bench tester is equipped with a open type compressor providing a nominal capacity of 3.5 ㎾. All tests are conducted under the summer cooling and winter heating conditions of 7/4 5℃ and -7/41℃ in the evaporator and condenser, respectively. For R1234yf/R134a mixture, measurements are made at 5%, 10%, and 15% of R134a by mass. Test results show that the coefficient of performance (COP) and capacity of R1234yf are up to 2.7% and 4.0% lower than those of R134a, respectively. For R1234yf/R134a mixture, the COP and capacity are up to 3.9% lower and 3.6% higher than those of R134a. For R1234yf and R1234yf/R134a mixture, the compressor discharge temperature is 4.1~6.7℃ lower than that of R134a while the amount of charge is reduced up to 11% as compared to R134a. 90%R1234yf/10%R134a is a better refrigerant than pure R1234yf in that it is less flammable and more compatible with existing R134a system. Based upon the results, it is concluded that R1234yf and R1234yf/R134a mixture are long term environmentally friendly solutions to mobile air-conditioners due to their excellent environmental properties with acceptable performance.