http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
이득과 잡음 지수의 동적 제어가 가능한 광대역 저 잡음 증폭기
오태수(Tae-Soo Oh),김성균(Seong-Kyun Kim),황과지(Guochi Huang),김병성(Byung-Sung Kim) 한국전자파학회 2009 한국전자파학회논문지 Vol.20 No.9
본 논문에서는 전류 블리딩(bleeding)과 입력 인덕티브 직렬-피킹을 이용한 공통 드레인 귀환(Common Drain Feedback: CDFB) CMOS 광대역 저잡음 증폭기(Low Noise Amplifier: LNA)를 설계하였다. 캐스코드 증폭기와 귀환 증폭기를 DC 결합하여 블리딩 전류의 조정을 통해 LNA의 이득과 잡음 지수(Noise Figure: NF)의 동적 제어를 실현하였다. 제작한 LNA는 2.5 ㎓의 대역폭에서, 고이득 영역은 1.7~2.8 ㏈ NF와 17.5 ㏈ 이득, 그리고 27 ㎽의 전력 소비를 보이고, 저 이득 영역은 2.7~4.0 ㏈ NF와 14 ㏈ 이득, 그리고 1.8 ㎽의 전력 소비를 보인다. A common drain feedback CMOS wideband LNA with current bleeding and input inductive series-peaking techniques is presented in this paper. DC coupling is adopted between cascode and feedback amplifiers, so that the gain and NF of the LNA can be dynamically controlled by adjusting the bleeding current. The fabricated LNA shows the bandwidth of 2.5 ㎓. The high gain mode shows 17.5 ㏈ gain with 1.7~2.8 ㏈ NF and consumes 27 ㎽ power and the low gain mode has 14 ㏈ gain with 2.7~4.0 ㏈ NF and dissipates 1.8 ㎽ from 1.8 V supply.
L1/L2 이중-밴드 GPS 수신기용 RF 전단부 설계
김현덕(Hyeon-Deok Kim),오태수(Tae-Soo Oh),전재완(Jae-Wan Jeon),김성균(Seong-Kyun Kim),김병성(Byung-Sung Kim) 한국전자파학회 2010 한국전자파학회논문지 Vol.21 No.10
본 논문에서는 L1/L2 이중-밴드 GPS(Global Positioning System) 수신기용 RF 전단부를 설계하였다. 수신기는 Low IF 구조이며, 인덕터를 사용하지 않는 광대역 저잡음 증폭기(Low Noise Amplifier: LNA)와 이미지 제거를 위하여 다상 여과기(poly-phase filter)를 포함하는 quadrature 하향 변환 주파수 혼합기(quadrature down-conversion mixer) 및 전류 모드 논리(Current Mode Logic: CML) 주파수 분배기로 구성되어 있다. 저잡음 증폭기와 이미지 제거 주파수 혼합기는 높은 이득과 헤드룸 문제를 해결하기 위하여 전류 블리딩 기술을 이용하였으며, 광대역 입력 정합을 구현하기 위하여 공통 드레인 피드백을 이용하였다. 0.18 ㎛ CMOS 공정을 이용해 제작된 RF 전단부는 L1 밴드에서 38 ㏈ 그리고 L2 밴드에서 41 dB의 이득을 보이며, IIP3는 L1 밴드에서 ?29 ㏈m, L2 밴드에서는 ?33 ㏈m이다. 입력 정합은 50 ㎒에서 3 ㎓까지 ?10 ㏈ 이하를 만족하며, 잡음 지수(Noise Figure: NF)는 L1 밴드에서는 3.81㏈, L2 밴드에서는 3.71 ㏈를 보인다. 이미지 주파수 제거율은 36.5 ㏈이다. 설계된 RF 전단부의 칩 사이즈는 1.2×1.35 ㎟이다. The RF front-end for L1/L2 dual-band Global Positioning System(GPS) receiver is presented in this paper. The RF front-end(down-converter) using low IF architecture consists of a wideband low noise amplifier(LNA), a current mode logic(CML) frequency divider and a I/Q down-conversion mixer with a poly-phase filter for image rejection. The current bleeding technique is used in the LNA and mixer to obtain the high gain and solve the head-room problem. The common drain feedback is adopted for low noise amplifier to achieve the wideband input matching without inductors. The fabricated RF front-end using 0.18㎛ CMOS process shows a gain of 38 ㏈ for L1 and 41 ㏈ for L2 band. The measured IIP3 is ?29 ㏈m in L1 band and ?33 ㏈m in L2 band, The input return loss is less than ?10 ㏈ from 50 ㎒ to 3 ㎓. The measured noise figure(NF) is 3.81 ㏈ for L1 band and 3.71 ㏈ for L2 band. The image rejection ratio is 36.5 ㏈. The chip size of RF front end is 1.2×1.35 ㎟.
조남기,오태수,조은일 제주대학교 환경연구소 2000 환경연구논문집 : 제주대 Vol.8 No.-
In order to determine the influence of nitrogen fertilizer on agronomic characters, and forage and quality, Danjimu, Sannariyeolmu and Seouldaehyungmu were cultured on the volcanic ash soil at the Experimental Farm of Cheju University under seven nitrogen rates (0, 50, 100,150, 200, 250, 300 ㎏/㏊) from April 17 to June 20, 1999. Days to flowering was delayed from 47 to 54 days after seeding a s the nitrogen rate increased. Days to flowering of Seouldaehyungmu was very fast(44days) while Danjimu was slow(54days). The plant height increased by increasing of nitrogen rate, the longest was observed at 250 kg/ha treatment (92.7cm) and 300 kg/ha treatment(93cm), but there was no significance. Plant height of Seouldaegyungmu was the tallest(91.5cm) of all, while that of Danjimu was the shortest(79.8cm ). Total fresh yield was very high at 250kg/ha treatment(94.2MT) and at 300kg/ha treatrnent(96.2MT). but there was no significance, on the other hand, was the shortest in the case of non-treatment(46.MT).