http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
옥외 청동문화재 보존을 위한 BTA 방청 피막의 특성에 미치는 코팅 조건의 영향
심규태 ( G. T. Shim ),유영란 ( Y. R. Yoo ),권용혁 ( Y. H. Kwon ),김영식 ( Y. S. Kim ) 대한금속·재료학회 2009 대한금속·재료학회지 Vol.47 No.10
Many ancient and historical artifacts were made by copper and its alloys. In the case of outdoor exposure artifacts, the surface could be suffered from corrosion and tarnish by the reaction with its environment. In order to preserve the artifacts, surface treatment would be needed and BTA coating has been usually applied to tin-bronze. This paper dealt with the evaluation of the properties of BTA coated film using a linear polarization method and AC impedance measurement. On the base of corrosion rate and film resistance for the specimen formed by coating process, optimum coating conditions are as follows; 3 cycles brushing or 3 cycles spraying coatings for natural dried process and 1 cycle brushing coating or 5 cycles spraying coating for hot-air dried process.
심규태(Kyu-Tae Shim),김규한(Kyu-Han Kim) 한국해안해양공학회 2020 한국해안해양공학회 논문집 Vol.32 No.6
본 연구에서는 단면2차원수리모형실험을 통하여 파랑과 바람이 공존할 경우 호안주변에서 발생되는 수리현상을 검토하였다. 최근의 호안 보수·보강실례를 토대로 서로 다른 4가지의 대표적 호안형상에 대하여 호안전면에 소파블록을 거치한 조건으로 실험단면을 구성하였고 외력변화에 따른 수면변동, 반사율, 월파 및 파압특성을 검토하였다. 호안의 상치형상은 호안전면에 나타나는 수리특성의 가장 중요한 요소이며 바람이 작용할 경우에는 그 경향이 더욱 뚜렷이 나타나는 것을 확인하였다. 실험결과 직립호안의 경우만 보더라도 3m/s~5m/s의 바람이 발생할 경우 월파량은 약 5%~12% 증가되었으며 파압의 경우 상치 마루부에서 1.5~2.2배까지 증가되는 것을 확인 할 수 있었으며 상치형상이 다른 3가지의 경우에 바람의 작용이 추가될 경우 호안전면의 수리특성은 변화폭이 보다 크게 나타나는 것을 확인할 수 있었다. 따라서 새로운 상치형상의 호안 설계 시에는 이러한 실험결과를 토대로 파랑과 바람 공존장에 대한 보다 상세한 수리특성 검토가 수반되어야 할 것이다. In this study, a two-dimensional hydraulic model test was conducted to examine the hydraulic phenomena that occur around the seawall when wave and wind coexist. Based on recent seawall repair and reinforcement examples, the experimental section was constructed under the condition of installing wave dissipation blocks on the safety surface of four different representative seawalls. Water level fluctuation, reflection, overtopping and wave pressure characteristics according to external force change were reviewed. It was confirmed that the top concrete shape of the seawall is the most important factor of the hydraulic characteristics that appear in front of the seawall, and the tendency is more pronounced when wind acts. Even in the case of vertical type seawall, when wind of 3 m/s~5 m/s occurs, the amount of overtopping increases to about 5%~12%. In the case of wave pressure, it was confirmed from the experimental results that the value increased from about 1.5 to 2.2 times in front of the top of concrete block. In addition, it was confirmed that when the shape of the seawall was different, the range of change in the hydraulic characteristics appeared larger. Therefore, when designing a seawall of a new shape, a more detailed review of the hydraulic characteristics should be accompanied based on these experimental results.
심규태(Kyu-Tae Shim),김규한(Kyu-Han Kim) 한국해안해양공학회 2017 한국해안해양공학회 논문집 Vol.29 No.3
본 연구에서는 침식성 파랑의 내습조건에 대해 인공리프의 길이(Lr), 개구폭(W), 개구부 수의 변화가 인공리프 주변 지형에 미치는 영향을 검토하고자 하였다. 구조물 주변에서의 표사이동 양상은 이동상실험을 통하여 검토하였으며 인공리프의 설치조건과 발생 유속 및 파랑변형, 지형변동과의 관계에 대해 고찰하였다. 실험결과 인공리프의 설치로 인하여 배후 침식량은 감소하였으나 개구부내에서의 세굴은 복수의 개구부를 갖는 구조에 비하여 단일 개구부를 갖는 조건에서 증가되었으며, Lr/W의 변화와 깊은 연관성을 보이는 것으로 확인되었다. The purpose of this study was to investigate the change of length, opening width, and number of openings effecting on topography change around artificial reefs under erosive wave condition. Hydraulic model test was conducted to see sediment transport around the structures and the relation among the installation condition of the artificial reefs, generated velocity, wave deformation, and topographic change was reviewed. Experimental results show that the sediment transport rate was reduced; however, the scour around the structures was increased under the condition of having a single opening compared to the structures having a plurality of openings which shows inversely proportional to the size of Lr/W.