http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
서철식,박재욱,김해준,김동희 한국조명전기설비학회 2003 조명·전기설비학회논문지 Vol.17 No.1
In this paper, prototype of high-power-factor single-stage electronic ballast for fluorescent lamp is designed and implemented. A new low cost single stage high power factor electronic ballast for fluorescent lamps is based on integration of two-boost converter and LC type high frequency resonant inverter. The proposed ballast is combined by simple construction, because full bridge rectifier diode is eliminated and simple control circuit is applied. Boost converter operate in the voltage of positive and negative half cycle respectively at line frequency (60㎐), operation in discontinuous conduction mode performs high power factor. The experimental results show the good performance as PF 0.99, THD 15.4%, and CF 1.65 at output 63.5〔W〕. 본 논문에서는 고역률의 단일전력단을 갖는 형광등용 전자식 안정기를 제안하고 설계ㆍ제작하였다. 저가의 새로운 형태를 갖는 고역률 단일전력단 형광등용 전자식 안정기는 부스터 컨버터와U형 고주파 공진 인버터로 구성되어진다. 그러나, 기존의 안정기와는 달리 제안된 안정기는 브리지 다이오드를 제거하고 간단한 제어회로로 구성함으로 간단한 구조를 갖는다. 부스터 컨버터는 상용전원의 정(+), 부(-)전압에서 각각 동작하고 불연속 모드에서 동작함으로 높은 역률을 얻을 수 있다. 63.5〔W〕의 출력을 갖는 안정기를 제작하여 실험한 결과, PF 0.99, THD 15.4%, CF 1.55의 우수한 결과를 얻을 수 있었다.
서철식,김동희,노채균,남승식,변영복,이봉섭 전력전자학회 1999 전력전자학회 논문지 Vol.4 No.4
본 논문에서는 SEPP-LCC형 부하 공진 고주파 인버터의 한 회로형식을 제안하고, 그 동작원리에 관해서 명확히 하였다. 제안한 인버터는 스위칭 소자 양단에 병렬로 커패시터를 추가함으로써 스위칭 소자의 턴-온과 턴-오프시에 발생하는 스위칭 손실, 노이즈, 스트레스 등을 줄일 수 있다. 범용성 있는 회로해석을 위하여 무차원화 파라미터를 도입하였고, 동작특성 및 평가를 통하여 얻은 특성치를 이용하여 회로를 설계하였다. 또한, 실험을 통하여 이론해석의 정당성을 입증하였다. In this paper, the resonant inverter of SEPP-LCC type is proposed and described the operating principle. As adding t two capacitors in the switching devices in parallel. the proposed inverter can reduce switching losses. noise and voltage s stress at Turn-on and Turn-off. The analysis of the proposed circuit are described by using the normalized parameters. The data of design are got by the characteristic values and an example of the design's method is proposed. In addition. t the justification of theoretical analysis is verified by comparing to the experimental waveforms.
전단일전력단을 갖는 고역율 형광등용 전자식 안정기 구현
서철식(C. S. Seo),박재옥(J. W. Park),김해준(H. J. Kim),노채균(C. G. Ro),김동희(D. H. Kim) 한국조명·전기설비학회 2001 한국조명·전기설비학회 학술대회논문집 Vol.2001 No.-
In this paper, prototype high-power-factor single-stage electronic ballast for fluorescent lamps is designed and implemented. A new low cost single stage high power factor electronic ballast for fluorescent lamps is based on integration of two-boost converter and LC type high frequency resonant converter. A ballast is obtained by simple construction, because full bridge rectifier diode is eliminated and simple control circuit is applied. Using two boost converter operating positive and negative half cycle respectively at line frequency(60Hz), operation in discontinuous conduction mode performs high power factor. The experimental results show the good performance as PF 0.99, A<SUB>THD</SUB> 15.4%, and CF 1.65 at output 63.5W.
단일 전력단을 갖는 고역률 형광등용 전자식 안정기에 대한 특성해석
서철식(Cheoi-sik Seo),박재욱(Jae-Wook Park),김동희(Dong-Hee Kim),노채균(Chae-Gyun Ro),변영복(Young-Bok Byun),서진우(Jin-Woo Seo) 전력전자학회 2000 전력전자학술대회 논문집 Vol.2000 No.11
A Novel high-power-factor electronic ballast for fluorescent lamps is presented in this paper. The proposed topology is based on integrahon of two-boost converter and a half-bridge parallel resonant converter.<br/> A ballast is obtained by simple construction, because full-bridge rectifier diode is eliminated and self oscillating technique is used to resonant converter. Using two-boost converter operating positive and negative half cycle respectively at line frequency (60Hz), operating in discontinuous conduction mode performs high power factor. The simulated and experimental results for 32W fluorescent lamps 110V utility line have been obtained, which verify the theoretical analysis
서철식(Cheol-Sik Seo),문종현(Jong-Hyun Moon),박재욱(Jae-Wook Park),김금수(Geum-Soo Kim),김동희(Dong-Hee Kim) 한국조명·전기설비학회 2008 조명·전기설비학회논문지 Vol.22 No.6
본 논문에서는 무정전 전원시스템(UPS : Uninterruptible Power Supply)의 에너지 저장용으로 사용되는 납축전지를 최적의 상태로 유지, 관리하는 배터리관리시스템을 설계, 제작하고, 잔존용량을 추정하는 알고리즘을 제안한다. 제안된 배터리관리시스템은 배터리의 충ㆍ방전 전류를 제어하여 과방전 및 과충전으로부터 배터리를 보호하며, 충ㆍ방전 시 배터리 잔존용량(SOC)을 예측하여 배터리를 최적 상태로 유지하도록 하는 알고리즘이 적용된다. 또한 충ㆍ방전 시험기를 이용한 실험과 UPS에 장착한 후 성능 실험을 통해, 제작된 시스템의 성능 및 제안된 배터리 잔존용량 추정 알고리즘의 타당성을 입증한다. This paper presents the battery management system(BMS) for the optimum conditions of the lead-Acid battery in UPS. The proposed system control the currents and voltages of battery for optimum conditions to estimate the State Of Charge(SOC) in charge or discharge mode. It proved the performance and the algorithm for the estimation of SOC, through the experiments which using the charge and discharge tester and the field tests.
배터리관리시스템(BMS)을 이용한 배터리 잔존수명(SOH) 추정 알고리즘에 관한 연구
서철식(Cheol-Sik Seo),문종현(Jong-Hyun Moon),박재욱(Jae-Wook Park),김금수(Geum-Soo Kim),김동희(Dong-Hee Kim) 한국조명·전기설비학회 2008 한국조명·전기설비학회 학술대회논문집 Vol.2008 No.5월
This paper presents the battery management system(BMS) for the optimum conditions of the lead-Acid battery in UPS. The proposed system controls the over and under currents of battery for protecting and it was applied algorithm for optimum conditions to estimate the State Of Charge(SOC) and State Of Health(SOH) in charge or discharge mode. It approved the performance and the algorithm for the estimation of SOH, through the experiments which using the charge and discharge tester and the field tests.
ZVS를 이용한 SEPP-LCC형 고주파 공진인버터의 특성해석에 관한 연구
서철식(Cheol-Sik Seo),김종해(Jong-Hae Kim),김동희(Dong-Hee Kim),노채균(Chae-Kyun Noh),이달해(Dal-Hae Lee) 전력전자학회 1998 전력전자학술대회 논문집 Vol.- No.-
This paper has described about principle and form of proposed circuit made use of soft switching technology ZVS(Zero-Voltage-Switching) to reduce turn on and off loss at switching. also, the analysis of the proposed circuit has described by using normalized parameter and operating characteristics have been evaluated as to switching frequency and parameters. In addition, this paper proves the propriety of theoretical analysis in terms of the experiments. <br/>
복공진 인버터를 적용한 고역률 메탈핼라이드 램프용 전자식 안정기에 관한 연구
박재욱,서철식,남승식,김해준,원재선,김동희 전력전자학회 2005 전력전자학회 논문지 Vol.10 No.4
In this paper, High power factor electronic ballast using a double resonant inverter for 250[W] MHD lamp is designed and implemented. Proposed electronic ballast is composed of configuration that is cascaded boost active PFC circuit as power factor corrector and half-bridge double resonant inverter into two stage approach.Theoretical analysis of circuit and characteristics estimation is generally illustrated by using normalized parameter. To remove the phenomenon of acoustic resonance in the lamp, Simple frequency controller composed timer IC and driving IC is designed and employed on the ballast. The experimental results show that an high power factor electronic ballast using a double resonant inverter is operated stably. 본 논문은 복공진 인버터를 적용한 250[W] 메탈핼라이드램프를 구동하기 위한 고역률 전자식 안정기를 설계하고 구현하였다. 제안된 전자식 안정기는 역률 개선 회로기능을 갖는 부스트 능동 PFC 회로와 하프 브리지 복공진형 인버터로 구분된 2개의 전력처리단으로 구성되어 있다. 회로 기본동작원리 및 회로 해석은 무차원화 파라미터를 도입하여 범용성을 부여하여 도식적으로 나타내었다. 음향공명을 제거하기 위해 타이머 IC와 구동 IC로 구성된 간단한 주파수 제어기를 구현하였다, 실험을 통해 복공진 인버터를 적용한 고역률 메탈핼라이드램프용 전자식 안정기가 안정적으로 동작함을 확인하였다.