http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
畓裹作栽培에 있어서 麦酒麦品種의 主要形質에 對한 遺伝統計量의 地域間變動
S. G. Kim(金祥坤),B. C. Jeong(丁秉春) 한국육종학회 1983 한국육종학회지 Vol.15 No.2
Heritability of heading date and culm length in malting barley were very high and the local variation was relatively small. Maturing date, spike length and number of spikes per m² were comparatively high in heritability and local variation of heritability was slightly large. Heritability estimation for number of grains and 1,000 grain weight was low due to large local variation. Direct effect of number of spikes per m² and number of grains per spike to yield was high.
김상곤(S.G. Kim),김철완(C.W. Kim),이융교(Y.G. Lee) 한국전산유체공학회 2014 한국전산유체공학회 학술대회논문집 Vol.2014 No.11
Korea Aerospace Research Institute is developing a EAV-2H+. This paper was analysis for EAV-2H+ power-on effect using CFD. EAV-2H+ power-on effect was smaller than EAV-2H power-on effect. Propeller install location, propeller diameter and propeller rotational direction has effect on power-on effect.
CFD를 활용한 항공기 날개의 Diffuser 풍동시험 분석
김상곤(S.G. Kim),김철완(C.W. Kim) 한국전산유체공학회 2013 한국전산유체공학회 학술대회논문집 Vol.2013 No.10
Computational analysis was performed including wind tunnel and wing to correct wind tunnel experiment result. This analysis result was shown that wing lift is increase and wing drag is decreased by wall effect, and then wall effect was appeared partially depending on installation location of wing. lastly, adverse pressure gradient was generated by diffuser and this effect was occurred partial aerodynamic variation by asymmetric deceleration of the flow.
하은경(E. K. Ha),김수태(S. T. Kim),정상원(S. W. Jung),김상곤(S. G. Kim) 한국정밀공학회 2006 한국정밀공학회 학술발표대회 논문집 Vol.2006 No.5월
Hydraulic circuit breaker is the most popular type of electric power circuit breaker because of its superiority of operating performance and capacity. For the improvement of hydraulic circuit breaker"s operating performance , it is very important to analyze its dynamic behavior characteristics. In this study, hydraulic circuit is modeled, analyzed and experimented. As a result, the experimental data agree well with the numerical ones, and the numerical results can be applied to the design and the improvement of hydraulic electric power circuit breaker.
엑시머 레이저를 이용한 산화 바나듐 박막의 상변화 유도에 관한 연구
김상곤,김도훈,이제훈,신동식,문성욱,강호관 한국레이저가공학회 2002 한국레이저가공학회지 Vol.5 No.3
단위 면적당 30W 근처의 값에서 가장 좋은 전기적 특성(상온 저항: 8kΩ, TCR: 2.9%)을 보였으며, 이는 기존의 2.5% 이하 TCR 값과 상온 저항 수십 kΩ 대의 재료에 비해 상당히 향상된 것으로 사료된다. 이런 향상의 원인은 레이저 어닐링 후, V_2O_3, VO_2 등의 혼합상 생성으로 인해 전기적 특성이 높아진 것으로 여겨진다. 표면 관찰 결과, 레이저 어닐링 전의 모습은 스퍼터링으로 인한 박막 증착 때문에 매우 거친 표면이었으나, 어닐링 후에는 보다 부드러운 표면의 모습을 보이고 있다. 이러한 표면의 거칠기 변화는 박막 전체의 저항 측정에 많은 영향을 끼쳤을 것으로 여겨진다. AES 분석 및 XPS 분석을 통하여 깊이에 따른 조성의 변화를 관찰한 결과, 비교적 안정적인 깊이 방향의 상변화를 얻을 수 있었으며, 표면만의 상변화가 아닌 처음에 증착된 박막 전체에 걸쳐 어닐링의 영향이 있었음을 알 수 있었다.