http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
류완호,이원묵,박성하,양천회 한밭대학교 에너지청정기술연구소 2004 에너지청정기술논문집 Vol.4 No.1
국내 석탄화력 발전소에서 폐기되는 석탄회를 이용하여 폐수 중 암모니아성 질소 제거용 흡착제를 제조하고자 NaOH를 반응물로 한 수열합성 반응을 이용, 제올라이트를 합성하였으며 제조된 제올라이트를 실제공정에 활용하기 위하여 흡착실험 및 공정모사를 수행하였다. 또한 흡착제를 구형으로 제조하여 암모니아성 질소의 등온 흡착 공정에 이용하였으며 이 결과 Langmuir, Freundlich 및 Sips 식에 잘 일치함을 알 수 있었다. 고정층에서의 흡착 거동은 축 방향 분산흐름, 입자 내부에서의 표면확산 및 Sips 흡착 등온식을 바탕으로 한 고정층 흡착 모델의 주요 공정 변수에 대한 파과곡선을 잘 모사할 수 있음을 확인할 수 있었다. Zeolite was synthesized from coal fly ash produced by a domestic power plant and applied for the removal of ammonia from waste water. Zeolite was synthezied using a hydrothermal method involving an akaline reaction with NaOH, and adsorption experiments and simulations were performed with the pellectized zeolite. The experimental data obtained from adsorption isotherms were consistent with the Langmuir, Freundlich and Sips equation. Also, most of the correlated results for the fixed bed model based on surface diffusion and Sips adsorption isotherms equation were consistent with the experimental data.
장감용,박성하 한밭대학교 에너지청정기술연구소 2002 에너지청정기술논문집 Vol.2 No.1
최근에는 막분리법은 CO_2 가스의 분리·회수 효율을 증가시키는 방법으로 주목받고 있다. 본 연구에서는 CO_2 분리막에 적용하기 위하여 고온에서도 사용할 수 있는 세라믹막을 개발하였다. 알루미나 세라믹 지지체는 슬립캐스팅법으로 제작되었고, 세라믹 복합졸은 dip coating법으로 세라믹 지지체에 코팅되었다. 세라믹 코팅과 열처리 조건들이 결정되었다. Recently, the membrane method are being focused to increase the effect of the separation and recovery for CO_2 gas. In this stydy, the ceramic membrane was developed to apply the CO_2 separation membrane which could be used in th high temperature. The Al_2O_3-ceramic supports were prepared using the slip coating method. The ceramic composite sol was coated on the ceramic supports by the dip-coating. The conditions for ceramic coating and heat treatment were determined.
MSR 공정에서 CaO를 이용한 CO_(2)의 탄산화·탈 탄산화 반응 특성연구
류완호,이원묵,이철우 한밭대학교 에너지청정기술연구소 2004 에너지청정기술논문집 Vol.4 No.1
MSR(Methane steam reforming)공정 중 발생되는 CO_(2)를 제거하기 위하여 CaCO_(3)에 무기바인더를 이용하여 구형의 CaO 반응물질을 제조하였다. 반응물질의 특성을 알아보기 위하여 반응온도, 농도, 접촉시간 등의 운전조건에 대한 변화와 CO_(2)와의 반응성에 대하여 연속 흐름식 반응장치를 이용하여 실험하였다. 반응물질의 소성온도는 850℃에서 반응성이 가장 좋았지만 탈 탄산화 공정을 고려하여 950℃로 결정하였다. GHSV를 3000hr^(-1)으로 고정시켜 놓고 실험한 결과, 반응기의 온도는 800℃, 유입되는 CO_(2)의 농도는 10%에서 반응성이 가장 좋았다. The adsorbent was prepared to separate CO_(2) gas generated from MSR process. Characteristies of carbonation and decarbonation of the adsorbent have been examine continuous reactor system in respect to temperature, concentrations at contact time. The decarbonation of CO_(2) onto adsorbents slowly occurred in this the temperature range from 850℃ to 950℃. However, the maximum carbonation ability was obtained at GHSV of 3000hr^(-1), temperature 800℃ and CO_(2) concentration of 10%(N_(2) balance).
CMOS 집적회로의 테스팅을 위한 새로운 내장형 전류감지 회로의 설계
곽철호 한밭대학교 에너지청정기술연구소 2004 에너지청정기술논문집 Vol.4 No.1
This paper presents a Built-In Current Sensor that detects defects in CMOS integrated circuits using the current testing technique. This scheme empolys a cross-coupled connected PMOS transistors, it is used as a current comparator. Our proposed scheme has a negligible impact on the performance of the circuit under test (CUT). In addition, in the operation of the normal mode, the Built-In Current Sensor(BICS) doesn't have dissipation of extra power, high speed detection time and it can be applied deep submicron process. The validity and effectiveness are verified through the HSPICE simulation on circuits with defects. The area overhead of a BICS versus the entire chip is about 9.2%. The chip was fabricated with Hynix 0.35㎛ 2-poly 4-metal N-well CMOS technology.