This study is to secure quantitative data of golf driver actions through kinematic and kinetic analysis and examine the efficient forms of each action to achieve successful swing.
This study samples four male pro golfers as excellent group, four univ...
This study is to secure quantitative data of golf driver actions through kinematic and kinetic analysis and examine the efficient forms of each action to achieve successful swing.
This study samples four male pro golfers as excellent group, four university golfers as intermediate group and four general golfers having handicap 92 as non-excellent group.
It analyzes addresses and finishes using six digital camcorders and two surface repulsive motors and calculates necessary variables.
1. Position Factors
1) Club Head
Excellent group showed low top of back swing, but it made distorting posture by enlarging the gap of left and right position(Y axis) and further it had profitable action on increase of angular momentum. Therefore, to make a strong swing, stability of body and lower part of body should be supported.
3) Vertex
First, position changes of left and right direction(Y axis) were greater in excellent group than in non-excellent group and it contributed to secure movement distance and increase momentum.
Second, position changes of up and down direction(Z axis) were very low in the top of back swing and over twice in non-excellent group and it was the cause of unstable posture.
3) Center of Gravity(COG)
Upper part of the body leans forward compared to failure and it resulted in increase of linear speed as well as securing movement distance of club head and further affected the increase of angular momentum.
4) Change of Position of Shoulder Joint
After positioning right shoulder forward compared to left shoulder in addressing back and forth(X), right shoulder moved backward in back swing and it contributed to increase angular momentum and there was also increase of momentum of club head at the end through the increase of torque.
2. Speed Factors
1) Changes of Speed of COG
Center of gravity showed the fast right and left movement speed in down swing which is the former stage of impact and it decreased the speed of COG at the point of time of impact and enlarged the impact by making the speed of club head fast. Therefore, the speed of body was reduced in impact and the speed of upper arm-forearm-hand serially and reduction of speed was achieved in the whole body not to be confined to hand.
2) Changes of Speed of Club Head
Appropriate order of speed reduction in down swing occurred, stopping segmentation was achieved and it resulted in increase of linear speed of club head.
3) Surface Repulsion Factors
First, the motion of pushing left foot strongly toward left in impact was shown in the case of succession compared to that of failure and right foot pushed toward right very strongly. It gave the equal load to both feet and made stable swing motions possible in impact.
Second, in particular, excellent group showed pattern of natural forms of left and right surface repulsion value to address, backswing top and impact in case of success.
Third, the changes of force from back and forth, and left and right showed equal center of gravity on both feet before downswing began, but as downswing began, left foot showed more supports to forward tip and right foot to heel and in impact, left foot gave more gravity to heel and right foot to tip.
3. Angle Factors
1) Rotating angle of shoulder joint
Excellent group and intermediate group showed smaller angular changes in impact than in address. First lower part of body of excellent group keeps closed state compared to address and upper body is impacted on open state due to the increase of rotating force. Second excellent group showed the most effective followthrough in finish motion because about a half of kinetic energy of club head in impact is absorbed into ball and the remaining half is into followthrough and motion to absorb it into body was taken.
2) Angle of Major Joints
Great torque from the body of subject was transferred to upper arm and forearm as downswing began and it caused a strong torque and in impact, excellent group made swing with spread posture of major joints and achieved the most effective swing.
3) Knee Angle
Knee angle of excellent group is bent compared to non-excellent group and non-excellent group made swing motion in extended state of right knee compared to excellent and intermediate groups in back swing.
4) Cocking Angle
Excellent group decreases the inertia efficiency of swing rotation by maintaining cocking angle as it is for a long, enlarges the angular speed of swing and makes speed of club head faster.