http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
카자흐스탄 구리제련소 슬래그 내 구리회수를 위한 선별 특성
박제현,최의규,최홍일,신승한,Park, Jayhyun,Choi, Uikyu,Choe, Hongil,Shin, Shunghan 한국자원리싸이클링학회 2015 資源 리싸이클링 Vol.24 No.4
일반적으로 구리제련 슬래그내 구리함량은 0.5-3.7% 혹은 그 이상의 높은 비율로 포함되어 있며, 슬래그내 구리회수에 대한 대표적인 방법으로는 부유선별, 침출 그리고 배소가 있다. 본 연구에서는 부유선별법에 의한 구리 회수방법을 검토하였으며, 잔세이트포수제를 이용한 황화부선을 수행하였다. 산성과 알칼리 조건에서 부유선별 특성을 관찰하였으며, pH 4 에서 구리회수율 50%, pH 11 에서 구리회수율 67%로 나타났으며, 특히 pH 11에서는 $100{\mu}m$ 이상의 입자가 정광으로 부유되어 회수율이 상대적으로 높게 나타나는 경향을 보였다. 슬래그 입도를 200 mesh 이하로 분쇄하여 단체분리도를 향상시켜 pH조건별 부유선별 실험을 수행한 결과, 회수율이 78 - 83%까지 향상되는 것을 확인할 수 있었다. Almost all copper slags contain a considerable amount of Cu (0.5 - 3.7%) close to or even higher than copper ores. A number of methods for metal recovery from copper slag were reported These methods can be classified into three categories, flotation, leaching and roasting. Sulfide flotation method for the recovery of copper from Kazahstan copper furnace slag is discussed in this investigation. 50% of copper from the slag was recovered by sulfide flotation at pH 4. meanwhile 67% of copper from the slag was recovered at pH 11. Higher copper recovery result at pH 11 rather than that at pH 4 was caused by the fact that copper sulfides were floated in particle size fraction over $100{\mu}m$ in concentrates at pH 11. When the slag were ground below $74{\mu}m$by ball milling, the recovery of copper by floation in slag improved to 78 - 83% because of copper liberation effect.
김종걸,유경근,최홍일,최의규,박제현,Kim, Jonggeol,Yoo, Kyoungkeun,Choe, Hongil,Choi, Uikyu,Park, Jayhyun,Alorro, Richard Diaz 한국자원리싸이클링학회 2015 資源 리싸이클링 Vol.24 No.4
광물찌꺼기의 효율적인 활용을 위하여 부유선별공정에서 배출되어 1차 분급된 시료를 대상으로 정밀분급을 실시하였다. 0.1 MPa - 0.3 MPa의 주입압력(공급유량)과 5% - 15%의 광액농도 조건에서 2인치 습식사이클론을 이용하여 분급시험을 진행한 결과, 주입압력 (공급유량)이 감소할수록 광액농도가 증가할수록 분리입도는 증가하였다. 광액농도 5%와 주입압력 0.3 MPa의 조건에서 overflow와 underflow의 평균입도는 각각 $6.56{\mu}m$와 $55.45{\mu}m$를 나타내었다. 분급효율은 광액농도를 증가시키거나 주입압력을 감소시킬수록 이상적인 분급효과에 근접하였다. 광액농도가 증가할수록 탈수효과는 증가하며, 주입압력에 따른 변화는 크지 않았다. 광액농도 15 %와 주입압력 0.3 MPa의 조건에서 underflow의 함수율은 27.9%로 나타났다. Fine particle classification was performed using products obtained from primary classification process after flotation for efficient application of tailing. The cut size increased with decreasing input pressure from 0.1 MPa to 0.3 MPa and increasing pulp density from 5% to 15% using 2-inch hydrocyclone. The median sizes of overflow and underflow were $6.56{\mu}m$ and $55.45{\mu}m$, respectively at 0.3 MPa with 5% pulp density. The imperfection became closed to ideal separation with increasing the pulp density and decreasing the input pressure. The water content decreased with increasing the pulp density, but the effect of input pressure could be ignored. The water content of underflow was 27.9% at 0.3 MPa with 15% pulp density.
오삼주 ( Sam-ju Oh ),김기준 ( Ki-joon Kim ),송재용 ( Jea-yong Song ),최의규 ( Uikyu Choi ) 대한지질공학회 2016 지질공학 Vol.26 No.4
본 연구는 환경유해시설인 광물찌꺼기 적치장의 효과적 유지관리를 위한 모니터링 방안을 수립하기 위해 수행하였다. 광물찌꺼기 적치장 유지관리를 위한 모니터링은 세분된 점검항목 및 평가항목의 선정을 통해 상세한 조사가 필요하며, 조사결과를 효과적으로 활용하기 위하여 불량정도 및 그 진행성 여부에 대한 평가가 필요하다. 따라서 모니터링 항목을 옹벽구조물(콘크리트옹벽, 석축, 돌망태) 및 일반시설물(차수층, 복토층, 사면, 광물찌꺼기, 우수배제시설, 침출수, 식생)로 점검항목을 세분하고, 각 항목별 모니터링 결과에 대한 상태평가를 수행하여 등급 및 점수화를 통해 체계적인 유지관리가 될 수 있도록 모니터링 개선안을 제안하였다. 개선안에 따른 현장 적용성 평가 결과, 기존 모니터링에 비해 최대 16건(우수배제시설)의 하자 발생 건수가 추가로 확인되는 등 기존 모니터링에 비해 세부적인 평가가 가능한 것으로 확인되었으며, 등급에 따른 광물찌꺼기 적치장별 종합점수는 금장광산이 89.3점으로 가장 양호하고 거풍광산이 22.2점, 화천광산이 27.8점으로 가장 불량한 것으로 확인되었다. 이와 같이 개선안을 적용할 경우, 보다 상세한 모니터링을 수행할 수 있고 각각의 항목에 대한 정량적인 평가가 가능하다. 이러한 정량적 평가는 향후 광물찌꺼기 적치장의 보수 우선순위를 결정하고 중점관리항목 선정, 유지보수 계획수립에 활용될 수 있을 것으로 판단된다. This study aims to establish a monitoring method for managing the effective maintenance of tailings dams. The monitoring of a tailings dump area involves several parameters and their investigation through a selection of evaluation items. The extents of defects and progressive failures also need to be effectively estimated. Therefore, the monitoring items can be subdivided into categories relating to the retaining wall structure (concrete wall, reinforcing stone wall, mesh gabions) and general facilities (liner, covering soil, slope, tailings, rain protection facility, leachate, planting), and quantitative evaluations can then be conducted for each condition. In doing so, we developed a systematic monitoring method that assesses the dam maintenance condition with grades and scores. The field application of the monitoring method results showed it to provide a more detailed evaluation than existing monitoring methods: the method detected an additional 16 defects missed by conventional methods. The evaluation gave scores of 89.3, 22.2, and 27.8 to the Geumjang mine tailings dam, the Gupoong mine tailings dam, and the Hwachun mine tailings dam, respectively. The advanced method can provide quantitative evaluation and perform detailed monitoring of the dams. This quantitative evaluation can be used to decide on maintenance priorities, select the main management items, and establish schedules of maintenance.