http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
김준호,Kim, Jun-Ho 한국종축개량협회 2006 種畜改良 Vol.11 No.4
본 글은 Veeppro dairy management 11월호의 내용을 발췌하여 정리한 내용입니다.
고로슬래그 미분말과 알칼리 자극재로서 순환골재를 사용하는 콘크리트의 강도발현 특성
김준호,한민철,한천구,Kim, Jun-Ho,Han, Min-Cheol,Han, Cheon-Goo 한국건설순환자원학회 2014 한국건설순환자원학회 논문집 Vol.2 No.2
본 연구에서는 자원순환형으로 재활용되는 순환골재(RA)를 고로슬래그 미분말(BS) 콘크크리트에 치환하여 강도발현특성을 확인하므로 RA의 실용화에 기여하고자하는 연구이다. 즉, BS치환 콘크리트에 RA를 순환잔골재(RFA) 순환굵은골재(RCA)로 나누어 천연잔골재(NFA) 천연굵은골재(NCA)에 치환율을 실험변수로 하여 실시하였다. 실험결과 RFA RCA의 치환율이 증가함에 따라 강도가 증가하는 것을 확인하였는데, 이는 RA의 미수화 시멘트에 의한 알칼리자극재(Alkali Activation) 역할을 하여 BS의 불투수성 피막을 파괴하여 잠재수경성 반응을 촉진시킨 것으로 판단된다. 그러나, 재령 365일에서는 RA의 알칼리가 거의 소비되어 효과를 발휘하지 못하고, 또한 RA의 낮은 품질특성에 기인하여 강도가 다소 저하하나, 천연골재(NA)만을 사용한 시험체에 비해 약 90 % 전후의 강도를 나타내어 다소 양호한 값이며, BS의 치환할 경우 오히려 NA 시험체보다 높은 강도를 나타내어 우려할 사항은 아닌 것으로 분석되었다. The objective of this study is to evaluate the strength development of blast furnace slag concrete in response to the use of recycled aggregate as alkali activator. The influence of the amount of recycled aggregate was evaluated depending on different ratios of replacement for each RFA and RCA to NFA and NCA, respectively. The results indicated that as replacement of RFA and RCA increased, their strength exhibited to be increased. This was due to the fact that the latent hydraulic properties of blast furnace slag was activated by the alkali in recycled aggregates. However, in case of 365-days, it showed lower compressive strength than using NA(natural aggregates) which could be explained as the exhaustively use of alkali containing in RA. The specimens using RA showed about 90% of compressive strength comparing with specimens using NA.
단상 스위치드 릴럭턴스 모터에 설치된 영구자석 기동장치의 디텐트 토크
김준호,이승민,Kim, Jun-Ho,Lee, Seung-Min 한국전기전자재료학회 2010 전기전자재료학회논문지 Vol.23 No.5
The single-phase switched reluctance motor(SRM) generates the positive torque in the restricted section. So, it can not started by itself and the torque ripple is heavier than poly-phase. For self-starting and fixing rotating direction, the rotor should be placed at the rising inductance slope when stationary. The parking permanent magnet locates the rotor in the fixed position, which can be started by it-self. It is very simple and cost effective but has some drawbacks. It affects the rotor during the operation, so the characteristics of motor, such as a torque, speed, and ripple are changed to go bad. This paper presents the detent torque of parking magnet starting device through the finite element analysis and experiments. The finite element analysis is performed at incremental rotor positions over one detent torque cycle for any one pole. The prototype, fabricated in the previous research, is used for the experiments. The inductance, instant torque, and detent torque are calculated using the terminal voltage and phase current. Finally, the finite element analysis result and the experiment result are compared for analysis and validity.