http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Deep neural network 기반 오디오 표식을 위한 데이터 증강 방법 연구
김범준,문현기,박성욱,박영철,Kim, Bum-Jun,Moon, Hyeongi,Park, Sung-Wook,Park, Young cheol 한국음향학회 2018 韓國音響學會誌 Vol.37 No.6
본 논문에서는 DNN(Deep Neural Network) 기반 오디오 표식을 위한 데이터 증강 방법을 연구한다. 본 시스템에서는 오디오 신호를 멜-스펙트로그램으로 변환하여 오디오 표식을 위한 심층신경망의 입력으로 사용한다. 적은 수의 훈련 데이터를 사용하는 경우 발생하는 문제를 해결하기 위해, 타임 스트레칭, 피치 변화, 동적 영역 압축, 블록 혼합 등의 방법을 사용하여 훈련 데이터를 증강시켰다. 사용된 데이터 증강 기법의 최적 파라미터와 최적 조합을 오디오 표식 시뮬레이션을 통해 확인하였다. In this paper, we present a study on data augmentation methods for DNN (Deep Neural Network)-based audio tagging. In this system, an audio signal is converted into a mel-spectrogram and used as an input to the DNN for audio tagging. To cope with the problem associated with a small number of training data, we augment the training samples using time stretching, pitch shifting, dynamic range compression, and block mixing. In this paper, we derive optimal parameters and combinations for the augmentation methods through audio tagging simulations.
산화법과 중화법을 이용한 산성광산배수 내 망간 제거 평가
김범준,지원현,고명수,Kim, Bum-Jun,Ji, Won-Hyun,Ko, Myoung-Soo 대한자원환경지질학회 2020 자원환경지질 Vol.53 No.6
Two oxidizing agents (KMnO4, H2O2), and one neutralizing agent (NaOH) were applied to evaluate Mn removal in mine drainage. A Mn2+ solution and artificial mine drainage were prepared to identify the Fe2+ influence on Mn2+ removal. The initial concentrations of Mn2+ and Fe2+ were 0.1 mM and 1.0 mM, respectively. The injection amount of oxidizing and neutralizing agents were set to ratios of 0.1, 0.67, 1.0, and 2.0 with respect to the Mn2+ mole concentration. KMnO4 exhibited a higher removal efficiency of Mn2+ than did H2O2 and NaOH, where approximately 90% of Mn2+ was removed by KMnO4. A black MnO2 was precipitated that indicated the oxidation of Mn2+ to Mn4+ after an oxidizing agent was added. In addition, MnO2 (pyrolusite) is a stable precipitate under pH-Eh conditions in the solution. However, relatively low removal ratios (6%) of Mn2+ were observed in the artificial mine drainage that included 1.0 mM of Fe2+. The rapid oxidation tendency of Fe2+ as compared to that of Mn2+ was determined to be the main reason for the low removal ratios of Mn2+. The oxidation of Fe2+ showed a decrease of Fe concentration in solution after injection of the oxidizing and neutralizing agents. In addition, Mn7+ of KMnO4 was reduced to Mn2+ by Fe2+ oxidation. Thus, the concentrations of Mn increased in artificial mine drainage. These results revealed that the oxidation method is more effective than the neutralization method for Mn removal in solution. It should also be mentioned that to achieve the Mn removal in mine drainage, Fe2+ removal must be conducted prior to Mn2+ oxidation. 이 연구에서는 KMnO4, H2O2, NaOH와 같은 산화제와 중화제를 사용하여 광산배수 내 Mn 제거효율을 확인하고 광산배수에 다량으로 존재하는 Fe2+의 영향을 파악하고자 하였다. 용액 내 Fe2+의 유무에 따라 Mn의 제거여부를 확인하기 위하여 초기농도 0.1 mM의 Mn2+ 용액을 준비하였다. 이때, 광산배수모사 용액의 Fe2+ 농도는 1 mM이 되도록 조성하였다. 산화제와 중화제의 주입량은 용액 내 Mn2+를 기준으로 각각의 몰비가 0.1, 0.67, 1.0, 2.0이 되도록 주입하였으며, Mn2+의 제거효율은 산화제인 KMnO4를 주입한 경우 최대 90%로 가장 높은 결과를 보였다. 산화제 주입 후 검은색의 MnO2 침전물이 형성되어 Mn2+의 산화제거를 확인하였고, 반응용액의 pH-Eh 조건에서 Mn 산화물인 Pyrolusite (MnO2)가 안정함을 확인하였다. 그러나 용액 내 Fe2+가 존재하는 광산배수 모사용액에서는 용액 내 Mn2+의 제거율이 6%로 매우 낮은 결과를 보였다. 이러한 결과는 Mn2+의 산화보다 Fe2+의 산화가 더욱 빠르게 진행되면서 Mn 산화물 형성을 저해하기 때문으로 판단된다. 산화제 및 중화제 주입 후 용액 내 Fe의 농도가 급격히 감소하는 결과는 Fe2+의 산화에 기인한 것으로 판단된다. 또한, Fe2+의 산화 과정에서 KMnO4의 Mn7+가 Mn2+로 환원되어 광산배수 모사 용액의 용존 Mn의 농도가 오히려 증가하는 결과를 보이기도 하였다. 이상의 결과로 보아, 용액에 존재하는 Mn을 제거하기 위해서는 산화법이 중화법보다 더 효과적이며, 광산배수에 존재하는 다량의 Fe2+를 먼저 제거한 후 용존 Mn의 제거를 진행하는 것이 효과적인 것으로 판단된다.
선박용 ESS용 병렬구조 LiB의 Rack간 전류 불평형 저감을 위한 입력 임피던스
김범준(Bum-Jun Kim),송은리(Eun-Lee Song),차현기(Hyun-Ki Cha),한승훈(Seong-Hun Han) 한국조명·전기설비학회 2021 한국조명·전기설비학회 학술대회논문집 Vol.2021 No.11
This paper presents a study on analysis of input impedance in parallel battery racks for improving current imbalance which causes both overload of battery cell and risk of thermal management. In this paper, the impedance analysis was performed considering power line and battery internal impedance variations within the range of the minimized current imbalance between parallel-connected battery racks. The feasibility of this paper was demonstrated by mathematical analysis and simulation results.