http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
퇴적암 풍화토의 공학적 특성 -대구.경북지역을 중심으로
김영수,이상복,정성관,Kim, Yeong-Su,Lee, Sang-Bok,Jeong, Seong-Gwan 한국지반공학회 1995 지반 : 한국지반공학회지 Vol.11 No.4
대구.경북지역의 대부분은 퇴적암으로 구성되어 있으며, 퇴적암 풍화토중에서 혈암풍화토와 이함풍화토의 공학적 특성에 대하여 연구하였다. 혈암 및 이암풍화토의 공학적 특성을 파악하기 위하여 다짐시 다짐에너지와 합수비 변화가 입도, 수침 및 비수침CBR, 투수 및 파쇄성에 미치는 영향에 대하여 연구하였고 또한,표면적비(Sw'/Sw)와 파쇄지수(IC)사이의 상관성을 검토하였다. 그 결과는 아래와 같다. (1) 최대 건조단위중량은 혈암풍화토가 이암풍화토보다 큰 값을 갖는 반면, 최적함수비는 혈암풍화토가 이암풍화토보다 작은 값을 갖는다. (2) 최소 투수계수는 최적함수비보다 1~2% 습윤측에 나타났으며, 다짐에너지가 증가할수록 투수계수의 변화폭이 작게 나타났다. (3) 표면적 비와 파쇄지수사이에는 직선적인상관성이 있는 것으로 나타났다. IC = 14.2865w'/Sw -8.429(r=0.9937) (4) 각각의 다짐에너지에서 수침CBR값은 최적함수비의 건조측에서 최대가 되었다가 함수비가 증가할수록 감소하는 경향을 보였다. 또한, 최적함수비를 기준으로 하여 건조측에서는 다짐에너지가 커질수록 비수침 및 수침CBR값이 크게 나타나는 반면, 습윤측에서는 그와 반대의 현상이 나타났다. Much of Taegu and Kyungpook areas are composed of sedimentary rocks. This paper is concerned with the engineering characteristi os of weathered shale soils and mudstone soils. In this study, the engineering characteristics of weathered shale soils and mudstone soils are investigated by performing tests such as compaction, gradation, CBR permeability and crushability according to compaction energy and water content. The experiments were carried out to obtain the relationships of the ratio of surface area(Sw'/Sw) and the indez of crushing(IC) The results are found as follows : (1) Weathered shale soils are larger than weathered mudstone soils in maximun dry den sixty, but weathered shale soils are smaller than weathered mudstone soils in OMC. (2) Minimum permeability is found in OMC's 1~2% wet side, and the more compaction energy is high, the more the change's range of permeability becomes narrow. (3) There is linear correlation between the ratio of surface area and the indez of crushing. IC : 14.286sw'/Sw -8.429(r=0.9937) (4) Soaked CBR value becomes maximum in OMC's dry side, and it decreases as the water content increases. Whereas the more compaction energy is high the more unsoaked and soaked CBR values are high in OMC's dry side, unsoaked and soaked CBR values are opposed to that in OMC's wet side.
김영수,서인석,백영식,Kim, Yeong-Su,Seo, In-Seok,Baek, Yeong-Sik 한국지반공학회 1993 지반 : 한국지반공학회지 Vol.9 No.2
This paper presents the two and three -dimensional stability analysis of nonhom- ogeneous, c-o soil slopes. Potential failure surface is assumed as a logspiral curve refracted in boundaries of layers. In 3-D analysis, rotational soil mass is assumed with a cylindroid central part terminated with plane ends. Seismic force is considered by sesmic intensity. The program developed in this study is compared with the program PCSTABLS. The ratio of three-dimensional minimum factor of safety to two-dimensional case is examined and factor of safety changes are showed for the ratio of cylindroid length to slope height and numbers of slice. On such bases the following conclusions may by made : (1) The program developed in this program is less conservative than the program PCSTABLS. (2) The value of F2 of this study shows the larger differences than that of PCSTABLS with increasing friction angle (3) Factors of safety computed for 3-D geometry differ considerablely from ordinary 2-D factors of safety. Since Fb/F2 exceeds unity, three -dimensional effects tend to increase the factor of safety. (4) As the ratio of three - dimensional failure width of slope height, b/H increase, the value of Fb/Ff decreases and approaches 1.0 when bye is 14. (5) In calculating the factor of safety using the developed program the number of slices is suitable with the ranges of 30-40 본 연구는 이질토층의 c-o흙사면에 대한 2차원 및 3차원 안정해석을 제시한다. 가능파괴면은 층의 경계에서 파괴면이 내부마찰각에 따라 굴절되는 대수나선곡선을 사용하였다. 3 차원 해석에서는 회전활동토괴는, 중앙부는 Cylindroid이고 양쪽 끝단은 평면으로 사용하였 다. 지진력은 수평 및 수직진도를 고려하였다. 개발한 프로그램을 PCSTABLS와 비교하였고, 2차원 최소안전율에 대한 3차원의 최소안전율의 비를 조사하였고, 사면높이에 대한 Cylindroid길이의 비에 따른 안전율의 변화를 검토하였다. 그리고 절편의 수에 따른 안전율의 변 화도 조사하였다. 이러한 것을 기초로 다음의 결과가 얻어졌다 : (1)본 연구에서 개발된 프로그램의 2차원 안전율이 PCSTABLS보다는 더 크게 나타났다. (2)본 연구의 2차원 안전율은 흙의 내부 마 찰각이 증가함에 따라 PCSTABLS보다 더 큰차이를 나타냈다. (3) 3차원 안전율은 2차원 안전율보다 더 크게 나타났다. 따라서 3차원효과는 안전율을 증가시키는 경향이 있다. (4) 사면의 높이에 대한 3차원 파괴토괴의 폭의 비, bye가 증가함에 따라 2차원 안전율에 대한 폭, b를 가진 3차원 안전율의 비, Fb/F거 값은 감소하였고, bye가 약 14이상이면 1.0에 근접 했다. (4) 2차원 안전율에 대한 폭, b를 가진 3차원 안전율의 비, Fb/F거 값은 전단강도정수, 지하수위 그리고 수평진도의 값에 매우 민감한 것으로 나타났다. (5) 본 연구에서 개발된 프로그램을 사용하여 안전율을 계산할때,절편의 수는 30~40개 정도면 적당하였다.