Flow of a low concentration polyacrylamide fluid solution in a channel with a flat plate obstruction at the entry

Kabir, M.A.,Khan, M.M.K.,Rasul, M.G. The Korean Society of Rheology 2004 Korea-Australia rheology journal Vol.16 No.2

Flow in a channel with an obstruction at the entry can be reverse, stagnant or forward depending on the position of the obstruction. These flow phenomena have potential applications in the control of energy and various flows in process engineering. Parameters that affect this flow inside and around the test channel are the gap (g) between the obstruction geometry and the test channel, the Reynolds number (Re) and the length (L) of the test channel. The influence of these parameters on the flow behavior was investigated using a flat plate obstruction at the entry of the channel. A low concentration polyacrylamide solution (0.018% by weight) showing a powerlaw fluid behavior was used as the fluid in this investigation. The flow phenomena were investigated by the velocity measurement and the flow visualization and their results were compared with numerical simulation. These results of low concentration polyacrylamide solution are also compared with the results of water published elsewhere (Kabir et al., 2003). The maximum reverse flow inside the test channel observed was 20% - 30% of the outside test channel velocity at a g/w (gap to width) ratio of 1 for Reynolds numbers of 1000 to 3500. The influence of the test channel length (L) and the Reynolds number (Re) on the velocity ratio ($V_i$/$V_o$: inside velocity/outside velocity in the test channel) are also presented and discussed here.

Analysis of spray uniformity and distribution by boom height and operating pressure under test bench and field condition

( Sazzadul Kabir ),( Ashrafuzzamn Gulandaz ),( Nasim Reza ),( Mohammod Ali ),( Shaha Nur Kabir ),( Sun-ok Chung ) 한국농업기계학회 2023 한국농업기계학회 학술발표논문집 Vol.28 No.1

Excessive use of pesticide increase production costs and negatively impact on the environment. Increasing spraying effectiveness is one of the major goals of precision variable rate technologies. The technical performance of the nozzle significantly impacts sprayer performance and quality. Analysis of the effects of operating pressure and boom height on spray dispersal and uniformity was the goal of this research. The test bench consisted of four nozzles (NN D-35) and a single-cylinder motor with a four-stroke capacity of 0.72 kW. This self-propelled sprayer was tasted on the ground with 2 km/h speed. Experiments were conducted both in lab and field condition with conventional spray nozzles and water as the test liquid. Tested liquid outflow pressure ranged from 280 to 520 kPa. Depending on the spraying target surface, 35, 45, and 55 cm of working spray boom height were adjusted. The nozzle spacing was 30 cm and the spray angle of the nozzles was 110o. Resultant sprayer nozzle widths with boom heights of 35, 45, and 55 cm caused overlaps of 22.38%, 23.43%, and 24.15% under the lab condition and 24.11%, 26.32%, and 29.37% under field condition. Under the laboratory condition average droplet density levels of 155.38, 159.20, and 168.31 (spots/cm2) were achieved at boom heights of 35, 45, and 55 cm with a speed of 2 km/h, resulting in the spray coverage levels of 23.21%, 26.38%, and 28.35%, respectively. At boom heights of 35, 45, and 55 cm at a speed of 2 km/h, average droplet densities of 138.62, 151.22, and 171.91 (spots/cm2) were obtained under the field yielding spray coverage levels of 24.11%, 26.38%, and 29.37%, correspondingly. Under the both conditions, the 55 cm boom overlapped less than 30%, and the average droplet density and spray coverage in unit area were better than the other two boom heights. It would also be economical and environmentally friendly to use these spraying tools.

Redescription of Australocirrus shii and First Report of Afrokeronopsis aurea (Ciliophora: Spirotrichea: Sporadotrichida) from South Korea

Kabir, Ahmed Salahuddin,Bharti, Daizy,Shin, Mann Kyoon The Korean Society of Systematic Zoology 2018 Animal Systematics, Evolution and Diversity Vol.34 No.1

Two hypotrich ciliates, Australocirrus shii (Shi et al., 1997) Kumar & Foissner, 2015 and Afrokeronopsis aurea (Foissner & Stoeck, 2008) Foissner et al., 2010 isolated from freshwater habitats in Korea and were studied based on the specimens from live and after protargol impregnation. Australocirrus shii is redescribed based on morphology and 18S rRNA gene sequence, whereas Af. aurea is the first record for Korea. Main morphological features of the Korean population of Au. shii are as following: body size $100-200{\times}40-80{\mu}m$ in vivo; elongate to ellipsoidal or slightly elongate obovate, dorsoventrally flattened; transverse cirri arranged in (3+2) pattern, anterior pretransverse ventral cirrus distantly anterior of the first transverse cirrus; eight or nine dorsal kineties; and three caudal cirri. Main morphological features of the Korean population of Af. aurea are as following: body size $230-375{\times}70-145{\mu}m$ in vivo; shape elongate obovate or ellipsoidal, widest at the mid-body; undulating membranes in Australocirrus pattern with a buccal depression; and three caudal cirri. The Korean population of A. shii is similar in morphology with previous descriptions except for the presence of indentation at the posterior end in the Korean population. The Korean population of A. aurea is slightly shorter than the South African population and has slightly less marginal and mid-ventral cirri. The phylogenetic analysis of present two Korean hypotrichs and relevant species based on 18S rRNA gene sequences generated almost similar tree topologies compared with previous studies.

APPLICATION OF A HYDRAULIC MODEL FOR PREDICTING THE GENERAL SCOUR: A CASE STUDY FOR ELASIN BRIDGE ON THE DHALESWARI RIVER IN BANGLADESH

KABIR M. MAHBOOB-UL,JAHAN SARWAT,NOOR AHMED ABDULLAH 한국수자원학회 2005 한국수자원학회 학술대회 Vol.2005 No.1

Upgrading flexural performance of prefabricated sandwich panels under vertical loading

Kabir, M.Z.,Rezaifar, O.,Rahbar, M.R. Techno-Press 2007 Structural Engineering and Mechanics, An Int'l Jou Vol.26 No.3

3-D wall panels are used in construction of exterior and interior bearing and non-load bearing walls and floors of building of all types of construction. Fast construction, thermal insulation, reduced labor expense and weight saving are the most well pronounced advantage of such precast system. When the structural performance is concerned, the main disadvantage of 3D panel, when used as floor slab, is their brittleness in flexure. The current study focuses on upgrading ductility and load carrying capacity of 3D slabs in two different ways; using additional tension reinforcement, and inserting a longitudinal concentrated beam. The research is carried on both experimentally and numerically. The structural performance in terms of load carrying capacity and flexural ductility are discussed in details. The obtained results could give better understanding and design consideration of such prefabricated system.

D-MoSK Modulation in Molecular Communications

Kabir, Md Humaun,Riazul Islam, S. M.,Kyung Sup Kwak IEEE 2015 IEEE transactions on nanobioscience Vol.14 No.6

<P>Molecular communication in nanonetworks is an emerging communication paradigm that uses molecules as information carriers. In molecule shift keying (MoSK), where different types of molecules are used for encoding, transmitter and receiver complexities increase as the modulation order increases. We propose a modulation technique called depleted MoSK (D-MoSK) in which, molecules are released if the information bit is 1 and no molecule is released for 0. The proposed scheme enjoys reduced number of the types of molecules for encoding. Numerical results show that the achievable rate is considerably higher and symbol error rate (SER) performance is better in the proposed technique.</P>

Dissipation kinetics, pre-harvest residue limits, and hazard quotient assessments of pesticides flubendiamide and fluopicolide in Korean melon (Cucumis melo L. var. makuwa) grown under regulated conditions in plastic greenhouses

Kabir, M. H.,Abd El-Aty, A. M.,Rahman, M. M.,Kim, S. W.,Lee, H. S.,Chung, H. S.,Do, J. A.,Jeong, J. H.,Chang, B. J.,Chang, M. I. Springer Science + Business Media 2017 Environmental science and pollution research inter Vol.24 No.28

<P>The dissipation kinetics, pre-harvest residue limits, and hazard quotient (HQ) assessments of the pesticides flubendiamide and fluopicolide were conducted for Korean melon (Cucumis melo L. var. makuwa) cultivated at two different sites. A single extraction and cleanup procedure was carried out using acetone (partitioned with dichloromethane) and amino solid-phase extraction cartridges, respectively. Residue analysis was performed by HPLC with ultraviolet detection. Both pesticides showed excellent linearity with correlation coefficients of 0.9999 and 0.9996 for flubendiamide and fluopicolide, respectively. The accuracy (expressed as recovery %) at three spiking levels was 92.0-103.6 and 82.8-105.3%, and the precision (expressed as relative standard deviation) was 1.7-3.4 and 2.7-5.3% for flubendiamide and fluopicolide, respectively. The initial residues of flubendiamide/fluopicolide were 0.326/0.376 and 0.206/0.298 mg/kg at sites 1 and 2, respectively. These amounts were substantially lower than the maximum residue limits (MRLs=1 and 0.5 mg/kg for flubendiamide and fluopicolide, respectively) established by the Korean Ministry of Food and Drug Safety. The half-lives of flubendiamide were 5.8 and 6.5 days, and those of fluopicolide were 6.7 and 9.1 days at sites 1 and 2, respectively. The shorter half-lives were attributed to seasonal variations (higher temperatures) and enzymatic and metabolic profiling. The risk assessment HQs of flubendiamide were 0.217/0.249 on day 0, which decreased to 0.102/0.168 on day 5, and to 0.065/0.88 on day 10; the HQ values for fluopicolide were 0.029/0.042, 0.022/0.025, and 0.010/0.019 on day 0, day 5, and day 10, for sites 1/2, respectively. From this data, we concluded that the fruits could be consumed safely.</P>

Polyphenolic Contents and Antioxidant Activities of Underutilized Grape (Vitis vinifera L.) Pomace Extracts

Kabir, Faisal,Sultana, Mosammad Shahin,Kurnianta, Heri The Korean Society of Food Science and Nutrition 2015 Preventive Nutrition and Food Science Vol.20 No.3

Grape pomace is an abundant source of underutilized winery by-products. Polyphenols were extracted from grape pomace using cellulase and gluco-amylase enzymes. 2,2-diphenyl-1-picrylhydrazyl (DPPH) and Folin-Ciocalteu's assays were used to measure antioxidant activity and total polyphenolic contents. Both cellulase, and gluco-amylase digested grape pomace showed efficient radical scavenging activity. In addition, the total polyphenolic contents of cellulase digested grape pomace showed lower concentrations were effective compared to higher concentrations, whereas glucoamylase enzyme did not show remarkable variations. The DPPH radical scavenging activity and total polyphenolic contents were significantly higher in the cellulase digested grape pomace compared to the gluco-amylase digested and the not digested grape pomace. It is notable that enzymatic digestions were efficient for extracting polyphenols from grape pomace. The underutilized grape pomace polyphenols can be further used for food safety as a natural antioxidant.

Dissipation pattern and risk quotients assessment of amisulbrom in Korean melon cultivated in plastic house conditions

Kabir, Md. Humayun,Abd El-Aty, A. M.,Rahman, Md. Musfiqur,Chung, Hyung Suk,Lee, Han Sol,Park, Sun-Hyang,Hacımü,ftü,oğ,lu, Fazil,Chang, Byung-Joon,Shin, Ho-Chul,Shim, Jae-Han Springer-Verlag 2017 Environmental monitoring and assessment Vol.189 No.6

Reader level filtering for efficient query processing in RFID middleware

Kabir, Muhammad Ashad,Han, Jun,Hong, Bonghee Elsevier 2015 JOURNAL OF NETWORK AND COMPUTER APPLICATIONS - Vol.48 No.-

<P><B>Abstract</B></P> <P>In RFID systems, middleware is used to filter a large amount of streaming data gathered continuously from readers to process application requests. The high volume of data makes the middleware often in a highly overloaded situation. The reader filtering capability can be used to reduce data volume and middleware work-load. However, if the middleware dispatches query conditions to readers without any adjustment, it may generate a huge amount of duplicate data and imposes considerable load on the middleware. As such, an appropriate schema for data volume reduction is required. In this paper, we propose a query decomposition technique to divide queries into sub-queries for middleware and reader level execution. This new approach of query execution resolves the problem of duplicate data generation. Our experiments show that the proposed approach considerably improves the performance of middleware by reducing query processing time and network traffic between reader and middleware.</P> <P><B>Highlights</B></P> <P> <UL> <LI> We exploit RFID readers' filtering capability for processing query efficiently. </LI> <LI> We present query models for RFID middleware and reader. </LI> <LI> We present algorithms to decompose query to process by middleware and reader. </LI> <LI> Our approach resolves the problem of duplicate data generation and improves the performance of middleware. </LI> </UL> </P>