http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
1, 2종 흡수식 히트펌프의 작동 매체에 따른 성능 해석[I]
원승호,이원용,정헌생,Won, S.H.,Lee, W.Y.,Chung, H.S. 대한설비공학회 1989 설비공학 논문집 Vol.1 No.3
Performance analysis of an absorption heat pump system for solar energy recovery has been done by computer simulation to find improved working pairs. Based on the thermodynamic analysis, the coefficient of performance and mass flow ratio have been calculated to compare two aqueous solutions [LiCl-water, $LiCi-CaCl_2-Zn(NO_3)_2$-water] which were developed for cooling by others, with the conventional LiBr-water solution. As a result of this analysis, the performances of the new aqueous solutions were found to be better than that of LiBr-water solution not only in cooling systems, but also in heating and in heat transformer systems. Their theoretical thermodynamic performance data were given here with.
원승호,이영수,Won, S.H.,Lee, Y.S. 대한설비공학회 1991 설비공학 논문집 Vol.3 No.4
Performance analysis of double-effect absorption heat pump system has been done to find improved working pairs (or mixture) by computer simulation. Based on the thermodynamic analysis, the coefficient of performance and mass flow ratio are investigated to compare three aqueous solutions [LiCl-water, LiSCN-LiBr-water, LiCl-$CaCl_2$-$Zn(NO_3)_2$-water] which was developed for only cooling, with conventional LiBr-water solution. It is found that the performances of the new aqueous solutions are better than that of LiBr-water solution not only in cooling systems, but also in heating systems. Theoretical thermodynamic performance data can be used in heat recovery systems by basic design data.
연간 성능을 고려한 가정용 태양열-흡수식 히트펌프의 에너지 절약효과 분석
이재효,이관수,원승호,이명호,Lee, J.H.,Lee, K.S.,Won, S.H.,Lee, M.H. 대한설비공학회 1991 설비공학 논문집 Vol.3 No.4
Studies on the annual performance of three different type of solar-absorption heat pump system (parallel type, series type, and generator type) are carried out by using the computer simulation. These include the calculation of solar energy from the solar collector, and the revision of computer package, developed by Oak Ridge National Laboratory, to predict the annual performance. Finally using weather data and load conditions, the annual performance are obtained. Results show that the annual operating costs of three solar-absorption heat pump systems are almost same values and 44% lower than that of the pure absorption heat pump system. The total annual input energys of solar-absorption heat pump systems are also about 44% lower than that of the pure absorption heat pump. The nominal size of the solar-absorption heat pump systems can be reduced to a value of 55% that of the pure absorption heat pump that would normally be specified under identical conditions.
이원용(W. Y. Lee),원승호(S. H. Won),정헌생(H. S. Chung) 한국태양에너지학회 1990 한국태양에너지학회 논문집 Vol.10 No.3
주어진 열원에서 유기 랭킹 사이클 시스템을 통해 얻을 수 있는 최대 출력 조건에서의 최적 효율을 구하기 위한 이론식을 유도하였으며, 이것이 작동 유체의 열물성치에 의한 엔탈피를 기초로 하여 계산된 열효율과 비교하여 잘 일치되는 것을 확인하였다. 본 연구에서 유도된 결과식에 의해 최대 출력은 열원의 열용량과 초기 온도 그리고 핀치점 온도차만의 함수임을 알 수 있었으며, 이 때의 효율은 열원의 열용량과 관계없이 입열원과 방출열원 초기 온도와 핀치점 온도차의 함수임을 알 수 있었다. 여기서 구한 최대 출력시의 효율식은 실제 랭킨 사이클 시스템의 설계를 위한 최적 설계지표로 사용될 수 있으며 실제 발전소의 성능 예측을 위한 최적 효율로도 사용될 수 있을 것이다. An analytical equation to estimate the Rankine power cycle efficiency at maximum power for the given mass flow rates of heating and cooling fluids is derived. The accuracy of the result is shown by comparing the analytical values with those calculated one using detailed thermodynamic data. The results indicate that the thermal efficiency at maximum power depends primarily on the initial temperatures of the heating and cooling fluids, and it also depends on the pinch-temperature differences between the working fluid and the heating and cooling fluids. The efficiency at maximum power provides a measure of the power available in a practical Rankine heat engine.
Camber Angle이 큰 축류 터어보 기계의 blade주위의 2차원 비점성 유동해석
손병진,맹주성,이관수,원승호,Son B.J.,Maeng J.S.,Lee K.S,Won S.H. 대한설비공학회 1987 설비저널 Vol.16 No.5
The theory of cascade flow analysis for large deflection was suggested lately, but this as-sumed to be incompressible and inviscid, the blades of negligible thickness. In this study, the fluid is assumed to be compressible and inviscide, the blades of given thickness, and using the mean vorticity pannel method the effects of increasing camber angle are analyzed. As the result of this study, it is found that the calculated flow regimes have good agreement with the existing experimented data and other calculation results.