The Purpose of this study was to measure and compare the gap distance between implant fixture and implant framework fabricated by three techniques; (1) one-piece casting technique. (2) at the same time soldering technique after casting. (3) at t...
http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
https://www.riss.kr/link?id=A30074795
2003
Korean
510.000
KCI등재
학술저널
127-140(14쪽)
0
상세조회0
다운로드다국어 초록 (Multilingual Abstract)
The Purpose of this study was to measure and compare the gap distance between implant fixture and implant framework fabricated by three techniques; (1) one-piece casting technique. (2) at the same time soldering technique after casting. (3) at t...
The Purpose of this study was to measure and compare the gap distance between implant fixture and implant framework fabricated by three techniques; (1) one-piece casting technique. (2) at the same time soldering technique after casting. (3) at the different time soldering technique after casting.
Four 3i (diameter 4.0 ㎜) implant fixtures were fixed in the stone block. Implant bar framework was completed with type 111 gold alloys after it was waxed up with wax sleeve. Implant bar framework was soldered after it was cut with 0.2 ㎜ gap distance and fixed with pattern resin. Gap distances between each implant fixture and abutment, each gap distances were measured by means of stereomicroscope and micrometer ruler.
The results were as follows :
1. In comparison of gap distance between implant fixture and abutment, one-piece casting technique group was 531 ㎛, soldering at the same time group was 250 ㎛,soldering at the different time group was 46 ㎛. Therefore, marginal adaptation of soldering technique group was higher than one-piece casting technique group. And marginal adaptation of soldering at the different time technique was higher than soldering at the same time technique.
2. In comparison of distance between abutment and abutment, one-piece casting technique group was 44.100 ㎜, soldering at the same time technique was 44.064 ㎜, soldering at the different time was 44.059 ㎜ and there were not significant differences.
목차 (Table of Contents)
키토산을 첨가한 콤포짓트 레진의 기계적 성질과 항균성에 관한 연구
전자빔 진공증착을 이용한 치과용 임플란트재의 표면 전처리법에 따른 HA코팅효과