Design and Performance Study of Fabry-perot Filter based on DBR for a Non-dispersive Infrared Carbon Dioxide Sensor

다국어 초록 (Multilingual Abstract)

A highly sensitive and selective non-dispersive infrared (NDIR) CO₂ gas sensor requires achieving high transmittance and narrow full width at half maximum (FWHM), which depends on the interface of the optical filter for precise measurement of CO₂ concentration. This paper presents the design, simulation, and fabrication of a Fabry-perot filter based on a distributed Bragg reflector (DBR) for a low-cost NDIR CO₂ sensor. The Fabry-perot filter consists of upper and lower DBR pairs, which comprise multilayered stacks of alternating high- and low-index thin films, and a cavity layer for the resonance of incident light. As the number of DBR pairs inside the reflector increases, the FWHM of the transmitted light becomes narrower, but the transmittance of light decreases substantially. Therefore, it is essential to analyze the relationship between the FWHM and transmittance according to the number of DBR pairs. The DBR is made of silicon and silicon dioxide by RF magnetron sputtering on a glass wafer. After the optimal conditions based on simulation results were realized, the DBR exhibited a light transmittance of 38.5% at 4.26 μm and an FWHM of 158 nm. The improved results substantiate the advantages of the low-cost and minimized process compared to expensive commercial filter.