Mechanical behavior and sealing performance of HAR sealing system in roller cone bits

다국어 초록 (Multilingual Abstract)

Two numerical models of HAR ring and O-ring sealing systems for roller cone bits were established in this paper. The stress-strain distribution was analyzed by finite element method. Effects of compression ratio, fluid pressure, ambient temperature and friction coefficient on mechanical behavior and sealing performance were studied. The results show that the HAR ring has better sealing performance than O-ring in the same working condition.
The HAR ring can realize multi-stage sealing to increase the reliability of sealing. The high stress region appears at the sharp corner below the shaft. The sealing performance and the von Mises stress is enhanced with compression ratio and fluid pressure increasing. Under a high working temperature field, the sealing surface of HAR ring fails easily. The contact pressure fluctuation of the sealing surface easily appears by friction coefficient. Sharp-angled regions of the HAR ring near S.S.3, S.S.5 and S.S.6 fail easily.

참고문헌 (Reference)

1 X. He, "Wear mechanism of rock bit bearing and influence of texture on wear under working condition of seal leakage" 40 : 12-16, 2017

2 A. I. Abbas, "Two-temperature generalized thermoelasticity under ramp-type heating by finite element method" 48 (48): 331-339, 2013

3 Z. Liu, "Study on sealing performance of W-shaped seal structure of roller cone bit" 21 : 95-99, 2018

4 L. Wang, "Study on sand drainage and sealing mechanism of spiral combined seal of high speed roller cone bit" Southwest Petroleum University 2017

5 J. L. Yang, "Study on metal seal of bit bearing" Southwest Petroleum University 2017

6 J. Liu, "Study on bearing seal structure of new roller bit" Southwest Petroleum University 2018

7 J. Zhu, "Research of the hydrodynamic sealing mechanism and experiment of variable cross section sealing ring" Northeast Petroleum University 2017

8 B. Li, "Optimization of single metal seal structure of cone bit" 44 (44): 98-102, 2019

9 X. Xiao, "Optimization of bi-metal seal structure of high speed roller bit bearing" 42 (42): 30-33, 2016

10 C. J. Han, "Mechanical properties analysis and structure improvement of tooth and sliding ring combined seals" 43 (43): 86-92, 2018

11 Jie Zhang, "Mechanical behavior and sealing performance of metal sealing system in roller cone bits" 대한기계학회 33 (33): 2855-2862, 2019

12 S. M. Abo-Dahabab, "LS model on thermal shock problem of generalized magneto-thermoelasticity for an infinitely long annular cylinder with variable thermal conductivity" 35 (35): 3759-3768, 2011

13 A. I. Abbas, "LS model on electro–magneto–thermoelastic response of an infinite functionally graded cylinder" 96 : 89-96, 2013

14 J. L. Kelly Jr., "Forecasting the life of rock bit journal bearings" 5 (5): 1990

15 C. J. Han, "Finite element analysis and optimization of rectangle rubber seal" 60 (60): 98-103, 2013

16 Y. Zhou, "Cone bit bearing seal failure analysis based on the finite element analysis" 45 : 292-299, 2014

17 Y. Zhou, "Cone bit bearing seal failure analysis based on the finite element analysis" 45 : 292-299, 2014

18 C. M. Yang, "Ansys analysis of the seal performance of rubber O-sealing ring" 20 (20): 49-52, 2010

19 A. I. Abbas, "A nonlinear generalized thermoelasticity model of temperature-dependent materials using finite element method" 33 (33): 1302-1313, 2012